Key Atkey.hello User Manual

1

AuthenTrend ATKey.Hello (Hello Dongle), touch base Fingerprint USB dongle

(WBF driver WHQL certified, ready on Windows Update)

If you are a new user (go to next section if you ever installed previous ATKey.Hello driver)

 Insert ATKey.Hello dongle to available USB port

o Please be noted, ATKey.Hello only supports Windows 10 32/64-bits OS

 If your OS is Windows 10 RedStone version (upgrade after 2016.08) and connect to internet, when you insert your

dongle, it will install driver from Windows update automatically.

 Then jump to Start your Fingerprint on Windows Hello.

2

 If your OS is NOT upgrade to Windows 10 RedStone version, you can still can find driver from Windows update by

“Search automatically for updated driver software”:

 Manually Driver installation (if it’s necessary)

o Download driver files from: http://authentrend.com/download/ATKey.Hello_WBFDriver3.5.2.2.zip

o Download the driver and unzip it
o Driver is INF base (not installation), please “install driver” from “device manager” “Biometric devices” to

browser your driver folder to install

o From device manager, find “Biometric devices” => “Egis EH570 sensor” with “!” mark

Egis EH570 fingerprint sensor

3

o Click the device, from pop up dialog, click “Update Driver” or “install driver”

o Install driver by browsing the target folder

4

o Browse INF folder as below:

 If you are x64 system

 Win10Release sub-folder

 INF is inside this sub-folder

But since we insert “Scheduler” in by registry keys, please “reboot” system to make those “run once”

effective!

5

Start your Fingerprint to Windows Hello:

1) Start from “Settings” => “Accounts”

2) “Sign-in Options”, Fingerprint “Setup”

6

3) Need PIN code first; if you did not setup PIN code yet, Windows Hello will guide you to setup it

4) Enroll and Register your fingerprint

7

* please pay attention to “LED” of ATKey.Hello dongle

 Flashing Blue: touch your fingerprint
 Green: enroll fingerprint success / fingerprint matching
 Red: enroll fingerprint fail / wrong fingerprint

 Blue: dongle is ready

5) It needs around 10 ~ 12 enrollments, following or dongle LED or the GUI instructions (touch, lift) to enroll.

Tip: try to enroll (touch) your finger by different area, not always touch by same finger area.

6) All Set. We will recommend you to register at least 2 fingers for the account, and you also can register

different finger for different account

LED

When the LED is flashing blue, that means Windows requests you fingerprint verification, so just touch your
registered finger to login; at the touch, if LED shows Green, it matched; if LED shows Red, that means

fingerprint not matching, so please try again or touch by right finger.

8

If you already installed previous version drivers

a. Uninstall driver first

b. Upgrade by INF (following Windows Hello Validation requirement)

9

 download the driver ZIP and unzip it to the specific folder
 Browse to the folder

 If you are x64 system

 Win10Release sub-folder

 INF is inside this sub-folder

c. But since we insert “Scheduler” in by registry keys, please “reboot” system to make those “run once”

effective!