Key 13104R, 13104 User Manual

WIRELESS OPTICAL LIQUID MOUSE WITH PAD

FEATURES

◆ 2.4GHz wireless optical liquid mouse, Nano receiver, and USB rechargeable cable

◆ Material: ABS+acrylic

◆ Resolution: 1000 DPI

◆ Operation distance: 8-10 metres

◆ Reduces tangled cords.

◆ Provides pinpoint precision on most surfaces, except glass.

◆ Key life: over 5000,000 times.

◆ Convenient direct to battery charge.

◆ Operation temperature: 14°F – 140°F

◆ Size: 10.3 x 6 x 3.5 CM

◆ Voltage: 3V

◆ Working current: 10mA

POWER FEATURES

• Built-in rechargeable battery.

• When the bottom red LED display is very low, or no power completely, recharge the battery for the mouse.

• Charge the mouse before linking to the computer. Connect the USB cable provided to the mouse and to the computer
USB port. Charging the mouse for the first time will take 5-7 hours. It will take only 3-4 hours thereafter. A fully
charged mouse will last up to two weeks. (PICTURE A)

INSTRUCTIONS

1. Turn on computer. Disconnect the existing mouse.

2. Insert the Nano USB receiver in the USB port of computer, or laptop.

3. Insure that the mouse has power. (PICTURE B)

4. For optimal operation, keep the mouse within 3 feet (approximately 1 meter) of the nano USB receiver.

5. Place the mouse near USB receive to ensure there is a good connection. (PICTURE C)

6. The first connection will take 3-8 seconds. It will only take 1-3 seconds thereafter.

7. If the mouse does not work, link mouse again. Re-check power and connection.

Note:

• Optical mouse does not work well on glass or highly reflective surfaces. If the mouse does not work properly, try
using it on a different surface such as a mouse pad or a plain white piece of paper.

• Turn off the mouse when charging.

• If the mouse doesn’t work, make sure the receiver is securely connected to the computer, and make sure fresh
batteries have been installed correctly.

• Don’t use this mouse in dangerous places, such as a gas station or a plane.

• This product contains small parts, not suitable for children under 3 years.

PICTURE A PICTURE B PICTURE C

FCC Certification Requirements
Caution: Any changes or modifications in construction of this device which are not
expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user’s
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.

-- Consult the dealer or an experienced radio/TV technician for help.