
E-Mail: info@kern-sohn.com
Phone: +49-[0]7433- 9933-0
Fax: +49-[0]7433-9933-149
Internet: www.kern-sohn.com
Assembly instructions Tripod
KERN EOB-A01-A01N
Version 1.0
EOB-A01
EOB-A01N
EOB-A01-A01N-IA-e-1310

Assembly instructions Tripod
Contents
1 Technical data ......................................................................................................... 2
2 Scope of delivery .................................................................................................... 3
3 Assembly EOB-A01 ................................................................................................. 3
3.1 Assemble the tripod to the balance ................................................................................. 3
3.2 Assemble the display unit to the tripod ........................................................................... 4
4 Assembly EOB-A01N .............................................................................................. 4
4.1 Assemble the tripod to the balance ................................................................................. 4
4.2 Assemble the display unit to the tripod ........................................................................... 5
EOB-A01 EOB-A01N
Suitable only for medical balances
with platform size up to 310 x 300
mm.
Only suitable for non–medical
balances with platform size up to
310 x 300 mm.
1 Technical data
KERN EOB-A01 EOB-A01N
Net weight 1150 g 1645 g
Tripod height 450 mm 450 mm

EOB-A01-A01N-IA-e-1310 3
2 Scope of delivery
EOB-A01 EOB-A01N
1. Tripod
2. Fastening screws
3. Turning knobs for assembly display unit
4. Support screw
1. Tripod
2. Fastening screws
3. Turning knobs for assembly display unit
4. Support screw (already assembled)
5. Rubber cover
3 Assembly EOB-A01
3.1 Assemble the tripod to the balance
Example:
(Figure approximately)
Fasten the tripod acc. to illustration with
the 4 screws on the lower side of the
platform.
Observe that during screwing
down not too much pressure is performed
on the weighing pan.

4 EOB-A01-A01N-IA-e-1310
(Figure approximately)
Turn-in support screws for stabilisation at
the lower side of the tripod.
3.2 Assemble the display unit to the tripod
Secure the display unit with the two
black rotary knobs to the tripod
according to illustration.
Position display unit with the rotary
knobs.
4 Assembly EOB-A01N
4.1 Assemble the tripod to the balance
Fasten the tripod acc. to illustration with
the 4 screws on the lower side of the
platform.
Observe that during screwing
down not too much pressure is performed
on the weighing pan.

Adapt the rubber cover in the provided
opening at the lower side of the tripod.
Unscrew the support screw until the
balance is in a stable and horizontal
position.
4.2 Assemble the display unit to the tripod
Secure the display unit with the two
black rotary knobs to the tripod
according to illustration.
Position display unit with the rotary
knobs.