KEPCO RTW-300L User Manual

INSTRUCTION MANUAL

KEPCO

An ISO 9001 Company.

KIT

DIN RTW-300L

DIN-RAIL MOUNTING KIT

FOR SERIES RTW 300W

DESCRIPTION. Kepco Kit, Model DIN RTW-300L contains

a preassembled mounting plate and associated hardware
used to install RTW 300 Watt Series power supplies with
factory-installed cover (-KC models) on a DIN rail. The “L”
suffix is for mounting along the long dimension (length) as
shown in Figure 1. Outline dimensions are shown in Figure

4.

INSTALLATION.

1. INSTALLING KIT. Attach the preassembled mounting

plate to the power supply using the hardware supplied (see
Figure 3).

2. INSTALLING POWER SUPPLY ON DIN RAIL. To mount the power supply on the rail insert one end of both clips
under one edge of the rail, then snap the other end of the clips into place (see Figure 2A).

FIGURE 1. L SUFFIX ORIENTATION

NOTE: For applications where the installed power supply may be subject to unusual levels of shock or vibration, or

where the power supply is oriented such that it may slide down the rail due to gravity, the use of two DIN rail
end stops (Kepco P/N 108-0367) is recommended. After installing the power supply on the rail, the end stops
are installed by clearing the DIN rail of other components and sliding the end stops over the rail. When the end
stops are secure against the power supply, tighten the two integral screws of each end stop.

3. WIRE POWER SUPPLY. Refer to RTW 300W manual.

REMOVING POWER SUPPLY FROM DIN RAIL. While grasping the power supply with one hand, use a screwdriver to

ap ply lever age towards the left a s s h o w n i n F i g u r e 3 B t o d i s e n g ag e b oth clips f r o m t h e r a i l .

A - INSTALLATION

B - REMOVAL

FIGURE 2. INSTALLATION AND REMOVAL OF POWER SUPPLY FROM DIN RAIL

KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL [phone] " FAX [phone]

©2006, KEPCO, INC 1
Data subject to change without notice 228-1585

http://www.kepcopower.com " email: [e-mail]

FIGURE 3. INSTALLATION OF KIT ON RTW 300W POWER SUPPLY

FIGURE 4. RTW 300W POWER SUPPLY WITH KIT INSTALLED, OUTLINE DIMENSIONS

KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL [phone] " FAX [phone]

http://www.kepcopower.com " email: [e-mail]

2 228-1585 061206