KEPCO FAW-150S User Manual

INSTRUCTION MANUAL

KEPCO

An ISO 9001 Company.

DIN-RAIL MOUNTING KIT

FOR SERIES FAW 100W, 150W

DESCRIPTION. Kepco KITs, Models DIN FAW-100S

and -150S, each contain two preassembled mounting
clips and associated hardware used to install FAW 100
and 150 Watt Series power supplies on a DIN rail. The

-100 suffix is for the 100 Watt Series, and -150 for the
150 Watt Series. The “S” suffix is for mounting along the
short dimension (width) as shown in Figure 1. Outline
dimensions are shown in Figure 4

TABLE 1. COMPONENTS SUPPLIED

KIT

MODEL NO.

DIN FAW-100S CA 27 128-1980 108-0362

COVER

PAR T N O .

MOUNTING PLATE

PART NO.

CLIP (QTY 2)

PART NO.

KIT

DIN FAW

-100S, 150S

FIGURE 1. S SUFFIX ORIENTATION

SCREW (QTY 4)

PAR T N O .

101-0092

(4-40 X 0.312 BHPH)

WASHER (QTY 4)

PART NO.

103-0014

(NO. 4, INT. TOOTH)

DIN FAW-150S CA 28 128-1980 108-0362

INSTALL COVER. Attach the cover to the power supply per instruction manual supplied with the cover.

INSTALLING KIT. Attach the preassembled mounting clips to the power supply using the hardware supplied (see Fig-

ure 3). The clips may be mounted with the release lever on either side to facilitate removal.

INSTALLING POWER SUPPLY ON DIN RAIL. To mount the power supply on the rail insert one end of both clamps
under one edge of the rail, then snap the other end of the two clips into place (see Figure 2A).

REMOVING POWER SUPPLY FROM DIN RAIL. While grasping the power supply with one hand, use a screwdriver to
apply leverage towards the left as shown in Figure 2B to disengage each clip from the rail. Where mounting clips are
close together, it may be necessary to apply leverage with two screwdrivers simultaneously.

A —

INSTALLATION

B —

REMOVAL

101-0092

(4-40 X 0.312 BHPH)

103-0014

(NO. 4, INT. TOOTH)

FIGURE 2. INSTALLATION AND REMOVAL OF POWER SUPPLY FROM DIN RAIL

KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL [phone] "

©1998, KEPCO, INC
Data subject to change without notice 228-1342

http://www.kepcopower.com " email: [e-mail]

FAX [phone]

1

FIGURE 3. INSTALLATION OF KIT ON FAW POWER SUPPLY

FIGURE 4. FAW 100W, 150W POWER SUPPLY WITH KIT INSTALLED, OUTLINE DIMENSIONS

KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL [phone] "

2

http://www.kepcopower.com " email: [e-mail]

228-1342 061901

FAX [phone]