KEPCO ERX-60P User Manual

INSTRUCTION MANUAL

KEPCO

An ISO 9001 Company.

DIN-RAIL MOUNTING KIT

FOR SERIES ERX 60W

DESCRIPTION. Kepco KIT, Model DIN ERX-60P

contains a cover, cable kit, left and right mounting
clips, and associated hardware (see Table 1) used
to install ERX Series 60W power supplies on a DIN
rail. The “P” suffix is for mounting the power supply
perpendicular to the DIN rail as shown in Figure 1.
Outline Dimensions are shown in Figure 5.

TABLE 1. COMPONENTS SUPPLIED

SCREW
(QTY 6)

(Power Supply

To Mounting

Bracket)

PART NO.

KIT

MODEL NO.

COVER

PART

NO.

CABLE

KIT

MOUNTING

BRACKET

PART NO.

WASHER

(QTY 6)

(Power Supply

To Mounting

Bracket)

PART NO.

KIT

DIN ERX

-60P

FIGURE 1. P SUFFIX ORIENTATION

SCREW

CLIP

(QTY 2)

PART

NO.

CLIP

PLATE

(QTY 2)

PART NO.

Thread-form

(QTY 4)

(Clip To

Mounting

Bracket)

PART NO.

WASHER

(QTY 4)

(Clip To

Mounting

Bracket)

PART NO.

DIN ERX-60P CA 16 219-0145 128-2055

101-0383

(8-32 X 3/16

PHPH)

103-0017

(NO. 8, INT.

TOOTH)

108-0362 128-1938

101-0443

(4-40 X 1/4

ST. TR.)

103-0014

(NO. 4, INT.

TOOTH)

INSTALLATION

1. INSTALL COVER. Attach the cover to the
power supply per instruction manual supplied
with the cover.

2. INSTALL MOUNTING BRACKET. Attach the
mounting bracket to the power supply using
the hardware supplied (see Figure 2).

3. INSTALL CLIPS. Attach preassembled
mounting clips into the mounting bracket
holes using hardware supplied (see Figure 3)

FIGURE 2. INSTALLING MOUNTING BRACKET ON POWER SUPPLY

4. INSTALL CABLE KIT. Attach wires to the
power supply per Instruction Sheet supplied with cable kit.

5. INSTALL POWER SUPPLY ON DIN RAIL. To mount the power supply on the rail insert one end of both mounting
clips under one edge of the rail, then snap the other end of the two clips into place (see Figure 4A)

REMOVING POWER SUPPLY FROM DIN RAIL. While grasping the power supply with one hand, Insert a screwdriver
into the access holes provided and apply leverage towards the left as shown in Figure 4B to disengage each clip from
the rail. Where mounting clips are close together, it may be necessary to apply leverage with two screwdrivers simulta­neously.

KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL [phone] "

©2001, KEPCO, INC
Data subject to change without notice 228-1419

http://www.kepcopower.com " email: [e-mail]

FAX [phone]

1