KEPCO ERX-240L User Manual

INSTRUCTION MANUAL

KEPCO

An ISO 9001 Company.

DIN-RAIL MOUNTING KIT

FOR SERIES ERX 240W

.

DESCRIPTION. Kepco KIT, Model DIN ERX­240L contains a cover, cable kit, left and right
mounting clips, and associated hardware (see
Table 1) used to install ERX Series 240W power
supplies on a DIN rail. The “L” suffix is for
mounting along the long dimension (length) as
shown in Figure 1. Outline dimensions are
shown in Figure 4.

TABLE 1. COMPONENTS SUPPLIED

KIT

MODEL NO.

COVER

PART NO.

CABLE KIT

PART NO.

CLIP

(QTY 2)

PART NO.

BRACKET

(QTY 2)

PART NO.

KIT

DIN ERX

-240L

FIGURE 1. L SUFFIX ORIENTATION

SCREW (QTY 4)

PAR T N O .

WASHER (QTY4)

PART NO.

DIN ERX-240L CA 18 219-0169 108-0362 128-1941

NOTE: Clip and Bracket are supplied preassembled into left and right mounting clip assemblies. To replace a mounting clip assembly,
order both the clip and bracket and assemble per Figure 2 detail.

INSTALLATION

1. INSTALL COVER. Attach the cover to the power supply per Instruction Manual supplied with the cover.

2. INSTALL CLIPS. Attach left and right clips to power supply using hardware supplied (see Figure 2).

101-0383

(8-32 X 0.187 PHPH)

103-0032

(NO. 8, SPLIT, LOCK)

FIGURE 2. INSTALLING CLIPS ON POWER SUPPLY

KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL [phone] "

©1998, KEPCO, INC
Data subject to change without notice 228-1325

http://www.kepcopower.com " email: [e-mail]

FAX [phone]

1

3. INSTALL CABLE KIT. Attach wires to the power supply per Instruction Sheet supplied with cable kit.

4. INSTALL POWER SUPPLY ON DIN RAIL. To mount the power supply on the rail insert one end of both
clips under one edge of the rail, then snap the other end of the two clips into place (see Figure 3A).

REMOVING POWER SUPPLY FROM DIN RAIL. With power off, disconnect wires from power supply. While
grasping the power supply with one hand, insert a screwdriver in the area shown in Figure 3B and apply leverage
towards the left as shown in Figure 3B to disengage each clip from the rail. Where mounting clips are close
together, it may be necessary to apply leverage with two screwdrivers simultaneously.

INSTALLATION

A

FIGURE 3. INSTALLATION AND REMOVAL OF POWER SUPPLY FROM DIN RAIL

B

REMOVAL

FIGURE 4. POWER SUPPLY WITH KIT INSTALLED, OUTLINE DIMENSIONS

KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL [phone] "

2

http://www.kepcopower.com " email: [e-mail]

228-1325 061801

FAX [phone]