KEPCO ERX-120S User Manual

INSTRUCTION MANUAL

KEPCO

An ISO 9001 Company.

DIN-RAIL MOUNTING KIT

FOR SERIES ERX 120W

.

DESCRIPTION. Kepco KIT, Model DIN ERX­120S contains a cover, cable kit, left and right
mounting clips, and associated hardware (see
Table 1) used to install ERX Series 120W power
supplies on a DIN rail. The “S” suffix is for
mounting along the short dimension (lwidth) as
shown in Figure 1. Outline dimensions are
shown in Figure 4.

TABLE 1. COMPONENTS SUPPLIED

KIT

MODEL NO.

COVER

PART NO.

CABLE KIT

PART NO.

CLIP

(QTY 2)

PART NO.

DIN ERX

-120S

FIGURE 1. S SUFFIX ORIENTATION

BRACKET

(QTY 2)

PART NO.

SCREW
(QTY 4)

PART NO.

WASHER

(QTY4)

PART NO.

KIT

DIN ERX-120S CA 17 219-0146 108-0362 128-1965

NOTE: Clip and Bracket are supplied preassembled into left and right mounting clip assemblies. To replace a mounting
clip assembly, order both the clip and bracket and assemble per Figure 3 detail.

101-0383

(8-32 X 0.187

PHPH)

103-0032

(NO. 8, SPLIT,

LOCK)

INSTALLATION

1. INSTALL COVER. Attach the cover to the power supply per Instruction Manual supplied with the cover.

2. INSTALL CLIPS. Attach left and right clips to power supply using hardware supplied (see Figure 3).

3. INSTALL CABLE KIT. Attach wires to the power supply per Instruction Sheet supplied with cable kit.

INSTALLATION

A

B

REMOVAL

FIGURE 2. INSTALLATION AND REMOVAL OF POWER SUPPLY FROM DIN RAIL

KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL [phone] "

©1998, KEPCO, INC
Data subject to change without notice 228-1324

http://www.kepcopower.com " email: [e-mail]

FAX [phone]

1

4. INSTALL POWER SUPPLY ON DIN RAIL. To mount the power supply on the rail insert one end of both
clips under one edge of the rail, then snap the other end of the two clips into place (see Figure 2A).

REMOVING POWER SUPPLY FROM DIN RAIL. With power off, disconnect wires from power supply. While
grasping the power supply with one hand, insert a screwdriver in the area shown in Figure 2B and apply leverage
towards the left as shown in Figure 2B to disengage each clip from the rail. Where mounting clips are close
together, it may be necessary to apply leverage with two screwdrivers simultaneously.

FIGURE 3. INSTALLING CLIPS ON POWER SUPPLY

FIGURE 4. POWER SUPPLY WITH KIT INSTALLED, OUTLINE DIMENSIONS

KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL [phone] "

2

http://www.kepcopower.com " email: [e-mail]

228-1324 061801

FAX [phone]