Kenwood TKR-851E3 User Manual

TKR-751/ TKR-851

VHF FM REPEATER/ UHF FM REPEATER

INSTRUCTION MANUAL

RELAIS FM VHF/ RELAIS FM UHF

MODE D’EMPLOI

REPETIDOR VHF FM/ REPETIDOR UHF FM

MANUAL DE INSTRUCCIONES

RIPETITORE FM VHF/ RIPETITORE FM UHF

MANUAL DI ISTRUZIONI

VHF-FM-REPEATER/ UHF-FM-REPEATER

BEDIENUNGSANLEITUNG

VHF FM REPEATER/ UHF FM REPEATER

GEBRUIKSAANWIJZING

TKR-751/ TKR-851 INSTRUCTION MANUAL

VHF FM REPEATER/ UHF FM REPEATER

THANK YOU!

We are grateful you purchased this KENWOOD repeater. We believe this easy-to-program repeater will be highly effective in your communications system, and will keep personnel operating at peak efficiency.

KENWOOD incorporates the latest in advanced technology into all of our products. As a result, we feel strongly that you will be pleased with the quality and features of this product.

FEATURES

• Easily program channel data using the KPG-91D software on a PC.

• Recall 1 of 16 preset channels using either a PF key or the external control line.

•Write the firmware to the Flash memory through an external source.

• Program QT/DQT signalling on each channel to simultaneously decode up to 16 different QT tones/DQT codes.

• Operate the repeater with the air remote control function.

• Use the interface port with external equipment, such as a repeater controller.

• Multi-mode capable:

Wide5k: 25 kHz/ Wide4k: 20 kHz/ Narrow: 12.5 kHz

• Adjust the following functions using a PC:

• 5-Tone deviation

• Battery operating tone deviation

• Battery warning tone deviation

• Courtesy tone deviation

• CW ID deviation

• DTMF deviation

• DQT balance

• DQT deviation

• Maximum deviation

• QT deviation

• Repeat gain

• RF output power

• RF power down detect

• RX audio signal output (RA)

• RX detector signal output (RD)

• RX frequency

• Squelch

•Test tone deviation

• TX audio signal input (TA)

• TX frequency

• TX signalling deviation (TD)

UNPACKING AND CHECKING EQUIPMENT

Note: The following unpacking information is for use by your KENWOOD dealer, an authorized KENWOOD service center, or the factory.

Carefully unpack the repeater. We recommend that you identify the items listed in the following table before discarding the packing material. If any items are missing or have been damaged during shipment, file a claim with the carrier immediately.

metI rebmuNtraP ytitnauQ

erutxiferawdraHXX-2048-12J1

ssalgtnorFXX-5362-01B1

retliFXX-9521-11B1

noihsuCXX-1081-31G4

noihsuCXX-2081-31G4

tooFXX-5740-20J2

tooFXX-2940-20J2

temmorGXX-2030-95J2

eldnaHXX-8140-10K1

swercSXX-6003-53N5

swercSXX-6004-03N2

drocCDXX-7243-03E1

elbacrotcennoCXX-8223-13E1

esuFXX-2301-60F1

launamnoitcurtsnIXX-4771-26B1

INSTALLATION

To install the handles onto the front panel of the repeater, align the handles with the holes on the front panel, then secure the handles using the supplied screws.

Please consult your dealer for installing the repeater and antenna.

MICROPHONE

Connect an optional KMC-30, KMC-27A, KMC-27B, or KMC-9C KENWOOD microphone to the MIC jack on the front panel.

PRECAUTIONS

• Do not expose the unit to rain or moisture; to prevent fire or electric shock.

• Do not open the unit under any circumstances; to avoid risk of electric shock.

• Do not expose the unit to long periods of direct sunlight, nor place it close to heating appliances.

• Do not place the unit in excessively dusty and/or humid areas, nor on unstable surfaces.

• If you detect an abnormal odor or smoke coming from the unit, disconnect the power from the unit immediately. Contact your KENWOOD service center or dealer.

+ 2 hidden pages