Kenwood Nexedge NX-230EX, Nexedge NX-330EX Instruction Manual

NX-230EX/ NX-330EX

VHF DIGITAL TRANSCEIVER/ UHF DIGITAL TRANSCEIVER

INSTRUCTION MANUAL

ÉMETTEUR-RÉCEPTEUR NUMÉRIQUE VHF/ ÉMETTEUR-RÉCEPTEUR NUMÉRIQUE UHF

MODE D’EMPLOI

TRANSCEPTOR DIGITAL VHF/ TRANSCEPTOR DIGITAL UHF

MANUAL DE INSTRUCCIONES

RICETRASMETTITORE DIGITALE VHF/ RICETRASMETTITORE DIGITALE UHF

MANUALE DI ISTRUZIONI

VHF DIGITAL FUNKGERÄT/ UHF DIGITAL FUNKGERÄT

BEDIENUNGSANLEITUNG

VHF DIGITALE ZENDONTVANGER/ UHF DIGITALE ZENDONTVANGER

GEBRUIKSAANWIJZING

VHF SAYISAL EL TELSİZİ/ UHF SAYISAL EL TELSİZİ

KULLANIM KILAVUZU

ΨΗΦΙΑΚΟΣ ΠΟΜΠΟΔΕΚΤΗΣ VHF/ ΨΗΦΙΑΚΟΣ ΠΟΜΠΟΔΕΚΤΗΣ UHF

ΟΔΗΓΙΕΣ ΧΡΗΣΗΣ

© B62-2449-00 (E)
09 08 07 06 05 04 03 02 01 00

VHF DIGITAL TRANSCEIVER/
UHF DIGITAL TRANSCEIVER

NX-230EX/ NX-330EX

INSTRUCTION MANUAL

NOTIFICATION

This equipment complies with the essential
requirements of Directive 1999/5/EC.
The use of the warning symbol
equipment is subject to restrictions of use in certain
countries.
This equipment requires a licence and is intended for
use in the countries as below.

AT BE DK FI FR DE GR IS IE

IT LI LU NL NO PT ES SE CH
GB CY CZ EE HU LV LT MT PL
SK SI BG RO HR

means the

ISO3166

ENGLISH

THANK YOU

We are grateful you have chosen KENWOOD for your land
mobile radio applications.

NOTICES TO THE USER

Government law prohibits the operation of unlicensed radio

◆

transmitters within the territories under government control.

Illegal operation is punishable by fi ne and/or imprisonment.

◆

Refer service to qualifi ed technicians only.

◆

Safety:

◆

It is important that the operator is aware of, and understands,
hazards common to the operation of any transceiver.

◆

For use in explosive atmospheres, read additional document
“SAFETY MANUAL FOR HAZARDOUS LOCATIONS” (B62­2450-XX).

Information on Disposal of Old Electrical and Electronic Equipment and Batteries
(applicable for countries that have adopted separate waste collection systems)

Products and batteries with the symbol (crossed-out wheeled bin) cannot

be disposed as household waste.
Old electrical and electronic equipment and batteries should be recycled
at a facility capable of handling these items and their waste byproducts.
Contact your local authority for details in locating a recycle facility nearest
to you.
Proper recycling and waste disposal will help conserve resources whilst
preventing detrimental effects on our health and the environment.

Notice: The sign "Pb" below the symbol for batteries indicates that this

battery contains lead.

i

PRECAUTIONS

• Do not charge the transceiver and battery pack when they are wet.

• Ensure that there are no metallic items located between the
transceiver and the battery pack.

• Use only KENWOOD specifi ed explosion-protected options for the
NX-230EX and NX-330EX transceivers.

• If the die-cast chassis or other transceiver part is damaged, do not
touch the damaged parts.

• Do not place the microphone cable around your neck while near
machinery that may catch the cable.

• Do not place the transceiver on unstable surfaces.

• Ensure that the end of the antenna does not touch your eyes.

• When the transceiver is used for transmission for many hours, the
radiator and chassis will become hot. Do not touch these locations
when replacing the battery pack.

• Do not immerse the transceiver in water.

• Always switch the transceiver power off before installing optional
accessories.

• The charger is the device that disconnects the unit from the AC
mains line. The AC plug should be readily accessible.

ii

Turn the transceiver power off in the following locations:

• Near blasting sites.

• In aircrafts. (Any use of the transceiver must follow the instructions
and regulations provided by the airline crew.)

• Where restrictions or warnings are posted regarding the use of
radio devices, including but not limited to medical facilities.

• Near persons using pacemakers.

• Do not disassemble or modify the transceiver for any reason.

• Do not place the transceiver on or near airbag equipment while the
vehicle is running. When the airbag infl ates, the transceiver may be
ejected and strike the driver or passengers.

• Do not transmit while touching the antenna terminal or if any
metallic parts are exposed from the antenna covering. Transmitting
at such a time may result in a high-frequency burn.

• If an abnormal odor or smoke is detected coming from the
transceiver, switch the transceiver power off immediately, remove
the battery pack from the transceiver, and contact your KENWOOD
dealer.

• Use of the transceiver while you are driving may be against traffi c
laws. Please check and observe the vehicle regulations in your
area.

• Do not expose the transceiver to extremely hot or cold conditions.

• Do not carry the battery pack with metal objects, as they may short
the battery terminals.

• Danger of explosion if the battery is incorrectly replaced; replace
only with the same type.

iii

Information concerning the battery pack:

The battery pack includes fl ammable objects such as organic
solvent. Mishandling may cause the battery to rupture producing
fl ames or extreme heat, deteriorate, or cause other forms of
damage to the battery. Please observe the following prohibitive
matters.

• Do not disassemble or reconstruct battery!

The battery pack has a safety function and protection circuit to

avoid danger. If they suff er serious damage, the battery may
generate heat or smoke, rupture, or burst into fl ame.

• Do not short-circuit the battery!

Do not join the + and – terminals using any form of metal (such

as a paper clip or wire). Do not carry or store the battery pack in
containers holding metal objects (such as wires, chain-necklace or
hairpins). If the battery pack is short-circuited, excessive current will
fl ow and the battery may generate heat or smoke, rupture, or burst
into fl ame. It will also cause metal objects to heat up.

• Do not incinerate or apply heat to the battery!

If the insulator is melted, the gas release vent or safety function is

damaged, or the electrolyte is ignited, the battery may generate
heat or smoke, rupture, or burst into fl ame.

• Do not leave the battery near fi re, stoves, or other heat

generators (areas reaching over 80°C)!

If the polymer separator is melted due to high temperature, an

internal short-circuit may occur in the individual cells and the battery
may generate heat or smoke, rupture, or burst into fl ame.

• Avoid immersing the battery in water or getting it wet by

other means!

If the battery becomes wet, wipe it off with a dry towel before use. If

the battery’s protection circuit is damaged, the battery may charge
at extreme current (or voltage) and an abnormal chemical reaction
may occur. The battery may generate heat or smoke, rupture, or
burst into fl ame.

iv

• Do not charge the battery near fi re or under direct sunlight!

If the battery’s protection circuit is damaged, the battery may charge

at extreme current (or voltage) and an abnormal chemical reaction
may occur. The battery may generate heat or smoke, rupture, or
burst into fl ame.

• Use only the specifi ed charger and observe charging

requirements!

If the battery is charged in unspecifi ed conditions (under high

temperature over the regulated value, excessive high voltage or
current over regulated value, or with a remodeled charger), it may
overcharge or an abnormal chemical reaction may occur. The
battery may generate heat or smoke, rupture, or burst into fl ame.

• Do not pierce the battery with any object, strike it with an

instrument, or step on it!

This may break or deform the battery, causing a short-circuit. The

battery may generate heat or smoke, rupture, or burst into fl ame.

• Do not jar or throw the battery!

An impact may cause the battery to leak, generate heat or smoke,

rupture, and/or burst into fl ame. If the battery’s protection circuit
is damaged, the battery may charge at an abnormal current (or
voltage), and an abnormal chemical reaction may occur. The
battery may generate heat or smoke, rupture, or burst into fl ame.

• Do not use the battery pack if it is damaged in any way!

The battery may generate heat or smoke, rupture, or burst into

fl ame.

• Do not solder directly onto the battery!

If the insulator is melted or the gas release vent or safety function

is damaged, the battery may generate heat or smoke, rupture, or
burst into fl ame.

• Do not reverse the battery polarity (and terminals)!

When charging a reversed battery, an abnormal chemical reaction

may occur. In some cases, an unexpected large amount of current
may fl ow upon discharging. The battery may generate heat or
smoke, rupture, or burst into fl ame.

v

• Do not reverse-charge or reverse-connect the battery!

The battery pack has positive and negative poles. If the battery

pack does not smoothly connect with a charger or operating
equipment, do not force it; check the polarity of the battery. If the
battery pack is reverse-connected to the charger, it will be reverse­charged and an abnormal chemical reaction may occur. The
battery may generate heat or smoke, rupture, or burst into fl ame.

• Do not touch a ruptured and leaking battery!

If the electrolyte liquid from the battery gets into your eyes, wash

your eyes with fresh water as soon as possible, without rubbing
your eyes. Go to the hospital immediately. If left untreated, it may
cause eye-problems.

• Do not charge the battery for longer than the specifi ed time!

If the battery pack has not fi nished charging even after the

regulated time has passed, stop it. The battery may generate heat
or smoke, rupture, or burst into fl ame.

• Do not place the battery pack into a microwave or high

pressure container!

The battery may generate heat or smoke, rupture, or burst into

fl ame.

• Keep ruptured and leaking battery packs away from fi re!

If the battery pack is leaking (or the battery emits a bad odor),

immediately remove it from fl ammable areas. Electrolyte leaking
from battery can easily catch on fi re and may cause the battery to
generate smoke or burst into fl ame.

• Do not use an abnormal battery!

If the battery pack emits a bad odor, appears to have diff erent

coloring, is deformed, or seems abnormal for any other reason,
remove it from the charger or operating equipment and do not use
it. The battery may generate heat or smoke, rupture, or burst into
fl ame.

vi

CONTENTS

UNPACKING AND CHECKING EQUIPMENT ............................. 1

PREPARATION .............................................................. 2

GETTING ACQUAINTED .................................................... 4

PROGRAMMABLE FUNCTIONS ........................................... 7

BASIC OPERATIONS ....................................................... 9

MENU MODE ............................................................... 12

SCAN ........................................................................ 15

FleetSync: ALPHANUMERIC 2-WAY PAGING FUNCTION ............ 17

5-TONE SIGNALING ....................................................... 20

ADVANCED OPERATIONS ................................................22

UNPACKING AND CHECKING EQUIPMENT

Carefully unpack the transceiver. If any items are missing or
damaged, fi le a claim with the carrier immediately.

Note: These unpacking instructions are for use by your KENWOOD
dealer, an authorized KENWOOD service facility, or the factory.

SUPPLIED ACCESSORIES

Belt clip (KBH-16EX) ................................................................... 1

• Screws for belt clip (M3 x 10 mm) ...........................................2

Universal connector cap .............................................................. 1

• Dressing screw (preassembled) .............................................1

• Packing (preassembled) .........................................................1

Instruction manual .......................................................................1

1

PREPARATION

INSTALLING/ REMOVING THE (OPTIONAL) BATTERY PACK

1 Match the guides of the

battery pack with the grooves
on the upper rear of the
transceiver, then fi rmly press
the battery pack in place.

2 Lock the safety catch to

prevent accidentally releasing
the battery pack.

3 To remove the battery pack,

lift the safety catch, press the
release latch, then pull the
battery pack away from the
transceiver.

Note:

◆ For battery pack charging procedures and usage, refer to the
battery charger Instruction Manual.

◆ Before charging a battery pack that is attached to the
transceiver, ensure that the safety catch is fi rmly closed.

◆ While operating the transceiver using a Li-ion battery pack in
areas with an ambient temperature of –10°C/ +14°F and lower,
operating time may be shortened.

INSTALLING THE (OPTIONAL) ANTENNA

Screw the antenna into the
connector on the top of the
transceiver by holding the antenna
at its base and turning
it clockwise until secure.

Antenna

2