Kenwood Major KMP05 PRO series User Manual
m
i
n
1
2
3
4
5
6
P
Major KMP05 PRO series
Congratulations on buying a Kenwood. With such a wide range of
attachments available, it’s more than just a mixer. It’s a state-of-the-art
kitchen machine. We hope you’ll enjoy it.
R
obust. Reliable. Versatile. Kenwood.
before using your Kenwood appliance
●
Read these instructions carefully and retain for future reference.
●
Remove all packaging and any labels.
safety
●
Switch off and unplug before fitting or removing tools/attachments, after
use and before cleaning.
●
Keep your fingers away from moving parts and fitted attachments.
●
N
ever leave the machine on unattended.
●
Never use a damaged machine. Get it checked or repaired: see
‘service’, page 10.
●
Never let the cord hang down where a child could grab it.
●
N
ever let the power unit, cord or plug get wet.
●
N
ever use an unauthorised attachment or more than one attachment
at once.
●
Never exceed the maximum capacities on page 6.
●
When using an attachment, read the safety instructions that come with it.
●
Take care when lifting this appliance as it is heavy. Ensure the head is
locked and that the bowl, tools, outlet covers and cord are secure before
lifting.
●
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
●
Children should be supervised to ensure that they do not play with the
appliance.
●
Only use the appliance for its intended domestic use. Kenwood will not
accept any liability if the appliance is subject to improper use, or failure to
comply with these instructions.
before plugging in
important - UK only
●
Make sure your electricity supply is the same as the one shown on the
underside of your machine.
●
The wires in the cord are coloured as follows:
Green and Yellow = Earth, Blue = Neutral, Brown = Live.
●
The appliance must be protected by a 13A approved (BS1362) fuse.
●
WARNING: THIS APPLIANCE MUST BE EARTHED.
Note:
●
For non-rewireable plugs the fuse cover MUST be refitted when replacing
the fuse. If the fuse cover is lost then the plug must not be used until a
replacement can be obtained. The correct fuse cover is identified by
colour and a replacement may be obtained from your Kenwood
Authorised Repairer (see Service).
●
If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY.
An electric shock hazard may arise if an unwanted non-rewireable plug is
inadvertently inserted into a 13A socket outlet.
●
This appliance conforms to EC directive 2004/108/EC on Electromagnetic
Compatibility and EC regulation no. 1935/2004 of 27/10/2004 on
materials intended for contact with food.
before using for the first time
1 Wash the parts: see ‘care and cleaning’, page 10.
2 Push excess cord into the cord stowage compartment at the back of the
machine.
know your Kenwood kitchen machine
3
EEnngglliisshh
know your Kenwood kitchen machine
attachment outlets high-speed outlet
m
edium speed outlet
slow-speed outlet
tool socket
the mixer mixer head
outlet catch
f
inger guard with feed chute
bowl
bowl seating pad
head-lift lever
r
ed power off button
g
reen power on button
speed switch
power unit
feed chute extension
K
-beater
flexible beater
flexible wiper
whisk
dough hook
spatula
spanner
control panel
power on indicator light
timer display
timer decrease button
timer increase button
fold button
start/stop button
min
sec
4
m
i
n
1
2
3
4
5
6
P
5
the mixer
the mixing tools and some of their uses
K-beater●For making cakes, biscuits, pastry, icing, fillings, éclairs and mashed
potato.
f
lexible beater
●
I
deal for scraping mixes from the sides and base of the bowl during mixing.
w
hisk
●
F
or eggs, cream, batters, fatless sponges, meringues, cheesecakes,
mousses, soufflés. Don’t use the whisk for heavy mixtures (eg creaming
fat and sugar) - you could damage it.
dough hook
●
For yeast mixtures.
to use your mixer
1 Turn the head-lift lever clockwise and raise the mixer head till it locks.
to insert a tool 2 Place the tool in the socket, locating the shaft pin in the groove and then
turn to lock into position .
3 F
it the bowl onto the base - press down and turn clockwise
4 To lower the mixer head, raise it slightly, then turn the head lift lever clockwise.
Lower into the locked position.
to remove a tool
●
Turn and remove.
5 C
onnect the mixer to the power supply and press the green power on
b
utton. The display will show 88:88 and then clear leaving the power on
indicator illuminated .
6 Turn the speed switch to the desired setting and then press the start/stop
button to start the mixer. The timer will count up in 1 second intervals.
The speed can be changed at any time whilst the mixer is operating.
7 Stop the mixer by pressing the start/stop button . The operating time will
be displayed and if the machine is re started the timer will continue counting
providing no longer than 3 minutes has elapsed. If the mixer is not used
within this time the display will re set to 00:00.
8 Press the red power off button to switch off the power supply, then unplug
the mixer.
Note: If the red power off button is pressed at any time, then all power to the
mixer is lost including the timer settings selected. To restore power press the
green power on button and re-set the timer if required.
Important - If at any time, the mixer head is raised during an operation,
the mixer will automatically stop and it will not re start when the mixer head is
lowered. It will only restart when the head is lowered and the start/stop
button is pressed.
pulse position
To select pulse turn the speed switch anti clockwise to the position. The
mixer will run at maximum speed for as long as the switch is held in this
position. When the switch is released it will return to the ‘min’ position and
the mixer will stop.
Note: If the mixer is running in the timer mode the pulse function will not
operate.
fold button
Press and release the fold button and the mixer will automatically
operate on minimum speed for 2-3 seconds. The button can be held
down for a longer operation or pressed repeatedly as needed to combine
ingredients.
Note: If the mixer is running in the timer mode the fold function will not
operate.
speed switch
K-beater
●
creaming fat and sugar start on min, gradually increasing to max.
●
beating eggs into creamed mixtures 4 - max.
●
folding in flour, fruit etc min - 1
●
all in one cakes start on min speed, gradually increase to max.
●
rubbing fat into flour min - 2.
flexible beater
●
scraping mixes from the side of the bowl start on min, gradually
increasing to 3.
whisk
●
Gradually increase to max.
dough hook
●
Start on min, gradually increasing to 1.
P
m
i
n
1
2
3
4
P
m
i
n
1
2
3
4
P
m
i
n
1
2
3
4
P
Loading...