Kenwood KDC-X397, KDC-MP255U, KDC-MP155U, KDC-355U, KDC-155U, KMR-355U User Manual
KDC-X397
KDC-MP255U
KDC-355U
KDC-255U
KDC-MP155U
KMR-355U
KDC-155U
CD-RECEIVER
INSTRUCTION MANUAL
AMPLI-TUNER LECTEUR DE CD
MODE D’EMPLOI
REPRODUCTOR DE DISCOS COMPACTOS RECEPTOR DE FM/AM
MANUAL DE INSTRUCCIONES
Take the time to read through this instruction manual.
Familiarity with installation and operation procedures will help you obtain the best performance from your new CD-receiver.
For your records
Record the serial number, found on the back of the unit, in the spaces designated on the warranty card, and in the space provided below. Refer to the model and serial
numbers whenever you call upon your Kenwood dealer for information or service on the product.
Model KDC-X397/ KDC-355U/ KDC-255U/ KDC-155U/ KDC-MP255U/ KDC-MP155U/ KMR-355U Serial number
US Residents Only
Register Online
Register your Kenwood product at www.Kenwoodusa.com
Do not operate any function that takes your attention away from safe driving.
Caution
Volume setting:
• Adjust the volume so that you can hear sounds outside the car to prevent accident.
• Lower the volume before playing digital sources to avoid damaging the speakers by the sudden increase of the
output level.
General:
• Avoid using the USB device or iPod/iPhone if it might hinder driving safety.
• Make sure all important data has been backed up. We shall bear no responsibility for any loss of recorded data.
• Never put or leave any metallic objects (such as coins or metal tools) inside the unit, to prevent a short circuit.
•
If a disc error occurs due to condensation on the laser lens, eject the disc and wait for the moisture to evaporate.
Remote control (RC-406):
• Do not leave the remote control in hot places such as on the dashboard.
• The Lithium battery is in danger of explosion if replaced incorrectly. Replace it only with the same or equivalent
type.
• The battery pack or batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
• Keep battery out of reach of children and in original package until ready to use. Dispose of used batteries
promptly. If swallowed, contact a physician immediately.
CALIFORNIA, USA ONLY
This perchlorate WARNING applies only to the product sold or distributed in California USA “Perchlorate
Material–special handling may apply, See www.dtsc.ca.gov/hazardouswaste/perchlorate.”
Maintenance
Cleaning the unit: Wipe off dirt on the faceplate with a dry silicon or soft cloth.
How to read this manual
• Operations explained mainly using buttons
on the faceplate.
[XX]
indicates the selected items.
•
(« XX)
•
2
indicates references are available on
the stated page number.
Cleaning the connector: Detach the faceplate and clean the connector with a
cotton swab gently, being careful not to damage the connector.
Handling discs:
• Do not touch the recording surface of the disc.
• Do not stick tape etc. on the disc, or use a disc with tape stuck on it.
• Do not use any accessories for the disc.
• Clean from the center of the disc and move outward.
• Clean the disc with a dry silicon or soft cloth. Do not use any solvents.
• When removing discs from this unit, pull them out horizontally.
• Remove burrs from the center hole and disc edge before inserting a disc.
Connector (on the reverse
side of the faceplate)
BASICS
Faceplate
KDC-X397
Display window
Attach
Remote control (RC-406)
(not supplied for
KMR-355U
Remote sensor (Do not expose
Volume knob
to bright sunlight.)
(turn/press)Loading slot
Detach
* Not used.
How to reset
Detach
button
KDC-X397KDC-255UKDC-355U
KDC-155U KMR-355U
KDC-MP255U
Your preset adjustments
KDC-MP155U
will also be erased.
ToDo this (on the faceplate)Do this (on the remote control)
How to replace the battery
)
Pull out the
insulation sheet
when using for
the first time.
Turn on the powerPress LSRC.
• Press and hold to turn off the power.*
1
Adjust the volumeTurn the volume knob.Press VOL
Press and hold SRC to turn off the power.
( Pressing SRC does not turn on the power. )
or VOL.
Press ATT during playback to attenuate the sound.
• Press again to cancel.
Select a sourcePress LSRC repeatedly.Press SRC repeatedly.
Change the display
information*
1
*
KMR-355U
For
2
*
For
KDC-MP255U
2
: The power will automatically turn off after 20 minutes when in standby mode (Auto Power Off).
/
KDC-MP155U
Press SCRL DISP repeatedly.
• Press and hold to scroll the current display information.
( not available )
: You can also select to turn off the display information by pressing SCRL DISP repeatedly.
ENGLISH |
3
GETTING STARTED
3
Set the initial settings
1
Cancel the demonstration
When you turn on the power (or after you reset the unit), the display
shows: “CANCEL DEMO” \ “PRESS” \ “VOLUME KNOB”
1 Press the volume knob.
[YES]
is selected for the initial setup.
2 Press the volume knob again.“DEMO OFF” appears.
For
KMR-355U
2
Set the clock
1 Press the volume knob to enter
2 Turn the volume knob to select
3 Turn the volume knob to select
4 Press the volume knob to select
,
[DEMO OFF]
is selected initially.
[FUNCTION]
[SETTINGS]
[CLOCK]
[CLOCK ADJUST]/ [CLOCK ADJ]
.
, then press the knob.
, then press the knob.
.
5 Turn the volume knob to adjust the hour, then press the knob.
6 Turn the volume knob to adjust the minute, then press the knob.Press 4
/
¢ to move between the hour and minute adjustment.
7 Press and hold to exit.
(or)
Press and hold SCRL DISP to enter clock adjustment mode
directly while in clock display screen.
Then, perform steps 5 and 6 above to set the clock.
1 Press SRC to enter
2 Press the volume knob to enter
3 Turn the volume knob to select
[STANDBY]
.
[FUNCTION]
[INITIAL SET]
.
, then press the knob.
4 Turn the volume knob to make a selection (see the table below), then press
the knob.
5 Press and hold to exit.
• To return to the previous hierarchy, press
PRESET TYPENORMAL/ NORM: Memorizes one station for each preset button in each band (FM1/
FM2/ FM3/ AM). ; MIX: Memorizes one station or SiriusXM channel for each preset
button regardless of the selected band or SiriusXM channel.
KEY BEEP
PANDORA SRC
BUILT-IN AUX/
BUILTIN AUX
CD READ
SWITCH PRE
SP SELECT
F/W UPDATE
F/W UP xx.xx
ON: Activates the keypress tone. ; OFF: Deactivates.
(Except for
ON: Enables PANDORA in source selection. ; OFF: Disables. (
ON: Enables AUX in source selection. ; OFF: Disables. (« 7)
1: Automatically distinguishes between audio file disc and music CD. ; 2: Forces to play
as a music CD. No sound can be heard if an audio file disc is played.
(Except for
REAR/ SUB-W: Selects whether rear speakers or a subwoofer are connected to the
line out terminals on the rear (through an external amplifier).
OFF/ 5/4/ 6 × 9/6/ OEM: Selects according to the speaker size (5 inches or
4 inches, 6×9 inches or 6 inches) or OEM speakers for optimum performance.
YES: Starts upgrading the firmware. ; NO: Cancels (upgrading is not activated).
For details on how to update the firmware, see: www.kenwood.com/cs/ce/
• To store a station: Press and hold one of the number buttons (1 to 6).
• To select a stored station: Press one of the number buttons (1 to 6)
Direct Access Tuning (using RC-406) (except for
1 Press
AM– / #FM+ to select a band.
*
KMR-355U
)
2 Press DIRECT to enter Direct Access Tuning.
“– – – • –” (for FM) or “– – – –” (for AM) appears on the display.
3 Press the number buttons to enter a frequency.
4 Press 4 / ¢ (+) to search for a frequency.
• To cancel, press
• If no operation is done for 10 seconds after step 3, Direct Access Tuning is
automatically canceled.
Other settings
1 Press the volume knob to enter
2 Turn the volume knob to select
.
[FUNCTION]
[SETTINGS]
.
, then press the knob.
3 Turn the volume knob to make a selection (see the table on the right),
then press the knob.
4 Press and hold to exit.
SEEK MODESelects the tuning method for the
AUTO1: Automatically searches for a station. ; AUTO2: Searches for a preset station. ;
MANUAL: Manually search for a station.
AUTO
MEMORY
MONO SET
KDC-MP255U
For
PTY SEARCHSelects the available Program Type (see below), then, press
TI
CLOCK
TIME SYNC
TUNER SET: Selectable only when the source is not TUNER.
TI
•
[MONO SET]/ [PTY SEARCH]/ [TI]
• Available Program Type:
SPEECH: NEWS, INFORM
MUSIC
The unit will search for the Program Type categorized under
• For
:
selected.
KDC-MP255U
information or alarm, the adjusted volume is memorized automatically. It will be
applied the next time traffic information or alarm function is turned on.
YES: Automatically starts memorizing 6 stations with good reception. ; NO: Cancels.
(Selectable only if [NORMAL] / [NORM] is selected for [PRESETTYPE].) (
ON: Improves the FM reception, but the stereo effect may be lost. ; OFF: Cancels.
/
KDC-MP155U
ON: Allows the unit to temporarily switch to Traffic Information. ; OFF: Cancels.
ON: Synchronizes the unit’s time to the Radio Broadcast Data System station time. ;
OFF: Cancels.
ON: Allows the unit to temporarily switch to Traffic Information. ; OFF: Cancels.
(information),
PERSNLTY
(spanish music),
ROCK, CLS ROCK
COUNTRY
(rhythm and blues),
music)
(personality),
(classic rock),
,
OLDIES, SOFT, NOSTALGA
KDC-MP155U
/
:
is selectable only when the source is FM.
PUBLIC, COLLEGE, HABL ESP
HIP HOP, WEATHER
SOFT R&B
: If the volume is adjusted during reception of traffic
4
/ ¢ buttons.
4 / ¢
SPORTS, TALK, LANGUAGE, REL TALK
(spanish talk),
ADLT HIT
(soft rhythm and blues),
(adult hits),
(nostalgia),
SOFT RCK
JAZZ, CLASSICL
REL MUSC
[SPEECH]
(softrock),
(classical),
to start.
(religious talk),
MUSC ESP
(religious
or
[MUSIC]
Default:
«
4)
TOP 40,
R & B
if
XX
ENGLISH |
5
CD / USB / iPod
Start playback
CD
Label side
0
: Eject disc
KDC-MP155U
: Applicable
— : Not applicable
ToDo thisCDUSB iPod
The source changes to CD and playback
starts.
USB
USB input terminal
CA-U1EX (max.: 500 mA)
(optional accessory)
The source changes to USB and playback
starts.
iPod/iPhone (except for
KDC-MP155U
)
USB input terminal
KCA-iP102 (optional accessory)
The source changes to iPod and playback
starts.
Press and hold iPod to select the control
mode while in iPod source.
1
MODE ON:
MODE OFF:
1
You can still control play/pause, file
*
From the iPod
From the unit.
*
.
selection, fast-forward or reverse files
from the unit.