The marking of products using lasers
(For countries other than U.S.A. and U.S.-Military)
Inside this laser product, a laser diode classified as Class 2 laser radiation is contained as alerted by the internal caution label shown above. Do
not stare into beam or view directly with optical instruments.
Location: DVD laser pick-up unit cover inside this product
CAUTION
VISIBLE AND INVISIBLE LASER RADIATION
WHEN OPEN. DO NOT STARE INTO THE BEAM OR
VIEW DIRECTLY WITH OPTICAL INSTRUMENTS.
DO NOT PRESS ON THIS SURFACE
The marking this product has been classified as Class 1. It
means that there is no danger of hazardous radiation outside
the product.
Location: Back panel
CLASS 1
LASER PRODUCT
Operation to reset
The microprocessor may fall into malfunction (impossibility to operate erroneous display, etc.) when the power cord is unplugged while
power is ON or due to an external factor.
In this case, switch off the power, wait for several seconds, and then
switch the power on again.
Return to the factory defaults by resetting the microprocessor is
done as shown as follows.
Press the MENU key on the remote to enter SETUP MENU.
Select the PREFERENCE, then press the ENTER key.
Select DEFAULTS, press the Cursoe right ( ) key to select
RESET.
Press the numeric keys as shown below.
Press , , , , then press the ENTER key.
When resetting is done according to this method, all settings,
including the settings for password and parental level, will be
reset to the factory defaults.
Manufactured under license from Dolby Laboratories. "Dolby"
and the double-D symbol are trademarks of Dolby Laboratories.
"DTS" and "DTS Digital Out" are trademarks
of Digital Theater Systems, Inc.
Before transporting or moving this unit, carry out the following operations.
1. Set the POWER ON/OFF switch to the ON without loading a disc.
2. Wait a few seconds and verify that the display shown appears.
3. Set the POWER ON/OFF switch to OFF.
Caution on condensation
Condensation (of dew) may occur inside the unit when
there is a great difference in temperature between this unit
and the outside. This unit may not function properly if condensation occurs. In this case, leave the unit for a few
hours and restart the operation after the condensation has
dried up.
Be specially cautious against condensation in the following circumstances:
When this unit is carried from one place to another across
a large difference in temperature, when the humidity in the
room where this unit is installed increases, etc.
Note related to transportation and movement
Please confirm that the following accessories are present.
Batteries(R6/AA) ...(2)
Audio video cord (Red, White, Yellow) ...(1)
(E30-2990-08)
Remote control unit ...(1)
(A70-1532-08) : E, X, Y
(A70-1592-08) : M
Coaxial cable ...(1)
(E30-7235-08)