Kenwood CAW2190-16 User Manual

8. Remove the two Torx screws, located over the switch panel.

Remove the switch panel.

9. Remove the two Torx

screws, located over the OEM head unit.

Installation Manual Double DIN Kit

Standard: CAW 2190-16 Rubber-Touch: CAW 2190-16-RT

• Mercedes C-Class (W203) 2004

Compatible with these Kenwood double DIN devices

Kenwood Navigation

10. Remove OEM head unit.

11. Place the facia plate and ﬁx it with the 4 original screws.

Push the metal frame into the

facia plate.

Connect all required circuit points

and push the double DIN head unit until it snaps in.

Place the trim frame.

Reinstall everything in reverse

order to ﬁnish installation.

Double DIN Set contents

• (1) Metal Frame

• (2) Installation Kit

• (3) Facia Plate

• (4) Trim Frame

1. Mercedes C-Class with

OEM head unit.

2. Remove panel by lifting it up. Remove ash tray.

3. Remove the two Torx (TX20) screws underneath the air condition control unit.

5. Unclip the air vent unit carefully on both sides with a screw driver.

6. Pull up the air vent and remove the 2 screws (left and right) which become visible.

7. Pull down the air vent and unclip the whole unit at both sides care fully with a screw driver.

Remove the air vent unit.

4. Pull out the air condition control unit. Remove the

two Torx (TX20) screws under the OEM-Radio.

All installation work must be performed by a qualiﬁed professional installer only. The manufacturer / dealer is not liable for any kind of incidential or indirect damages.

Mount the metal brackets with the double DIN head unit

The position of the copper coloured holder can be adjusted to your needs for perfect ﬁt. (see sample)