Kenwood CAW1301-05 User Manual

KIT ASSEMBLY INSTRUCTIONS

Double DIN & Double ISO Mount Applications

1) Remove the Shaded tab from the bottom of each left and right
mounting bracket (see Fig. B below).

2) Cut and remove center rib from main bracket for double DIN and double
ISO applications

3) Attach the left and right side brackets to the main bracket,

4) Attach climate controls to the top of the kit using factory screws.

5) Fnr rtniihip DIN radio applications ONLY cut and remove center rib from

and file edges smooth.

6) Follow steps 5-7 from single ISO instructions on page 2.

7) Attach a rear support bracket to the rear oi the radio components and adjust

as needed to allow rear support bracket to rest in the sub-dash.

NOTE: ISO kim ring ^ ^ mysl be used in ploc& of ofreF'markel radioes Irtm rtngs. For ISO mounf oppli<otions,

mounl ahef-markei mdio components to side brackets using screws provided with radio when possible or

2-DIN CAW-1301-05

1198-2003 LEXUS GS 300
1198-2003 LEXUS GS 400

RADIO MOUNTING KIT

INSTALLATION INSTRUCTIONS

PASH DISASSEMBLY INSTRUCTIONS

1) Carefully unsnap and pull forward the vent/clock assembly from above
the factory radio.

2) Unplug the wire harnesses from the rear of the vent/clock assembly and
remove assembly.

3) Remove the (2) 10mm bolts securing the upper radio/climate control
brackets to the sub-dash.

4) Carefully remove the ashtray assembly from below the climate controls.

5) Remove the (2) 10mm bolts securing the lower radio/climate control
brackets to the sub-dash.

6) Carefully pull radio/climate control assembly forward, disconnect all wire
harnesses and antenna lead wire from radio and climate controls and
remove entire assembly.

7) Remove the factory climate control unit from fhe factory brackets.

KIT ASSEMBLY INSTRUCTIONS

Single DIN Mount Applications

1) Attach the left and right side brackets to the main bracket.

2) Insert pocket into lower section of ttie main bracket.

3) Attach left and right side brackets to the rear of the pocke* using
screws supplied.

4) Insert DIN sleeve from your new radio into the upper section of fhe
installation kit.

5) Depress the tabs from inside the sleeves opening upward, outward, and
downward to secure sleeve to the installation kit.

6) Install radio into sleeve and lock into place.

7) Attach a rear support bracket to the rear of the new radio and adjust as
necessary to attach to the rear support stud located on the back of the
pocket using the small phillips screw supplied with kit.

KIT ASSEMBLY INSTRUCTIONS

Single ISO Mount Applications

1) Attach the left and right side brackets to the main bracket.

2) Insert pocket into lower section of the main bracket.

3) Attach left and right side brackets to the rear of the pocket using
screws supplied.

4) Attach climate controls to the top of the kit using factory screws.

5) Attach (1) ISO Spacer to the inside of upper section on both Left & Right mounting
brackets as shown in Fig. A.

6) Insert ISO mountable radio between ISO mount brackets and loosely
attach to sides of radio using screws provided with radio when possible or
hardware included with kit.

7) Slide radio components forward or backward for desired look and tighten screws.

8) Attach a rear support bracket to the rear of fhe new radio and adjust as
necessary to attach to fhe rear support stud located on the back of the
pocket using the small phillips screw supplied with kit.