Kenwood 325HD75X User Manual

CH580 series
English
efore using your Kenwood
b appliance
ead these instructions carefully and
R
etain for future reference.
Remove all packaging and any labels including the plastic blade covers from the knife blade. Take care
the blades are very sharp.
These covers should be discarded as they are to protect the blade during manufacture and transit only.
safety
The blades are very sharp, handle with care. Always hold by the
finger grip at the top, away from the cutting edge, both when handling and cleaning.
Switch off and unplug:
before fitting or removing parts
after use
before cleaning.
Always wait for the blades to completely stop before removing the power unit from the bowl.
Always remove the knife blade(s) before emptying or pouring contents from the bowl.
Never use a damaged appliance. Get it checked or repaired: see ‘service and customer care’.
Never let the power unit, cord or plug get wet.
Don’t let excess cord hang over the edge of a table or worktop or touch hot surfaces.
Never leave the appliance on unattended.
Misuse of your food chopper can result in injury.
Never use an unauthorised attachment.
his appliance is not intended for
T use by persons (including children)
ith reduced physical, sensory or
w
ental capabilities, or lack of
m experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions.
before plugging in
Make sure your electricity supply is the same as the one shown on the underside of the appliance.
Important - UK only
The wires in the cord are coloured as follows: Blue = Neutral Brown = Live.
The appliance must be protected by a 3A approved (BS1362) fuse.
Note:
For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse. If the fuse cover is lost then the plug must not be used until a replacement can be obtained. The correct fuse cover is identified by colour and a replacement may be obtained from your Kenwood Authorised Repairer (see Service).
If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY. An electric shock hazard may arise if an unwanted non-rewireable plug is inadvertently inserted into a 13A socket outlet.
2
Loading...
+ 5 hidden pages