Kenwood 106VR, 105VR User Manual

Specifications and Main Features

The minimum RMS power output at STEREO operation is rated at 110 watts per channel with a total harmonic distortion of no more than 0.8 percent at FTC. This is for both channels driven from 40 Hz to 20,000 Hz.
The power output for SURROUND operation is as follows.
The minimum RMS power for Front for 8 ohms at 1 kHz is 110 watts with a maximum of 0.8 % distortion
The minimum rms for a Center at 8 ohms setting at 1 kHz is 110 watts with 0.8 percent distortion
The minimum rms for Surround two speakers at 110 watts driven at 1 kHz for 8 ohm load with maximum of 0.8 percent total distortion.
The THD at 1kHz rated at 55 W and 8 ohm load is 0.3 percent.
The signal to noise ratio as defined by IHF'66 is as below:
PHONO MM mode has a rated noise of 75db.
LINE CD has a rating of 93db.
The input impedance and sensitivity are as follows:
PHONO (MM): 3.0 mV / 47 kΩ
CD: 220 mV / 47 kΩ
The Tone controls for this device has the following:
The BASS has an output rating of 8.IH305db.
The Middle lever has a rating of 8 dB at 900 Hz.
The THRESHOLD at 10 000Hz is 8dB.
N.B. Circuit : 5dB at 80Hz.
Impedance value / output level: Sub woofer pre-out: 2.0 V / 600Ω.
Video input section: VIDEO connector level input output (Composite): 1 Vp-p / 75 Ohm.
Incorporation of an FM Tuner:
Band tuning frequency coverage: 87.5 MHz ~ 108 MHz.
Able usable sensitivity: 1.3 uV (Tailored Termination 75 Ohm) / 13.2 dB (Rate deviation of 75kHz, SINAD of 30dB).
50 dB quieting sensitivity: STEREO: 31.6 µV (Termination 75 Ohm)/ 41.2dB.
AM Tuner section:
Frequency range of the tunning: 530kHz - 1700kHz.
Consumption of power wattage: 250.
Measurements in the dimension: W: 440 mm (17-5/16”), H: 127 mm (5”), D: 389 mm (15-5/16”).
Weight in its net: 9 kg 19.9 lb.
Regions falling below zero (0) degrees Celsius are believed to hinder the provision of complete services.

Frequently Asked Questions

Q: What is the power output of the KENWOOD 106VR/105VR?

A: For STEREO operation 110watts minimum RMS per channel at 8 ohm is rated. Also, the unit is 110watts per channel in SURROUND operation at 8 ohm.

Q: May I hook this up with a subwoofer?

A: Yes. The unit has a Sub woofer pre-out terminal for connection of powered subwoofers.

Q: Can you explain the frequency response of the FM tuner?

A: The FM tuner for this device offers tuning frequency that ranges between 87.5MHz to 108MHz.

Q: What are the audio inputs of this device?

A: The device accepts multiple audio inputs which comprise PHONO, MM, and CD.

Q: Is there a way I can adjust the tone on this unit? Why?

A: This particular device has a built-in tone control facility that can adjust BASS, MIDDLE, and TREBLE up to +8 dB from their respective frequencies.

Q: What is the total harmonic distortion at rated power?

A: The total harmonic distortion was found to be up to 0.3 % at frequency 1 kHz with 55 W supply at 8 ohms.

User Manual

+ 22 hidden pages