Kenmore KM400 Installation Manual
important - UK only
attachment outlets
the mixer
safety
Switch off and unplug before fitting or removing tools/attachments, after
use and before cleaning.
This machine is not intended for use by young children or infirm persons
without supervision.
Keep your fingers away from moving parts and fitted attachments.
Never leave the machine on unattended.
Never use a damaged machine. Get it checked or repaired: see
‘service’, page
6.
Never use an unauthorised attachment or more than one attachment
at once.
Never exceed the maximum capacities on page
2.
Don’t let children play with this machine.
When using an attachment, read the safety instructions that come with it.
Only use this machine for domestic food preparation.
before plugging in
Make sure your electricity supply is the same as the one shown on
the underside of your machine.
The wires in the cord are coloured as follows:
Blue = Neutral, Brown = Live.
This machine complies with European Economic Community Directive
89/336/EEC.
before using for the first time
Remove all packaging.
Wash the parts: see ‘care and cleaning’, page
6
.
know your Kenwood kitchen machine
high-speed outlet
citrus juicer outlet
slow-speed outlet
tool socket
mixer head
outlet catch
bowl
head-lift lever
on/off and speed switch
power unit
K-beater
whisk
dough hook
spatula
know your Kenwood kitchen machine
KENWOOD CHEF KM300, 400, 410 / MAJOR KM600, 800, 810
●
●
●
●
●
●
●
●
●
●
●
●
●
1
2
1
K-beater
whisk
dough hook
to insert a tool
to remove a tool
hints
important
shortcrust pastry
stiff yeast dough
soft yeast dough
fruit cake mix
egg whites
K-beater
whisk
dough hook
the mixer
●
●
●
1
2
3
4
5
●
6
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
2
the mixing tools and some of their uses
For making cakes, biscuits, pastry, icing, fillings, éclairs and mashed
potato.
For eggs, cream, batters, fatless sponges, meringues, cheesecakes,
mousses, soufflés.
Don’t use the whisk for heavy mixtures (eg creaming
fat and sugar) - you could damage it.
For yeast mixtures.
to use your mixer
Turn the head-lift lever anti-clockwise and raise the mixer head till it
locks.
Turn till it stops
then push.
Fit the bowl onto the base - press down and turn clockwise
Turn the head-lift lever anti-clockwise and lower the mixer head till it locks.
Select a speed, then switch on by turning the speed switch.
Switch to pulse for short bursts.
Unscrew.
Switch off and scrape the bowl with the spatula frequently.
Eggs at room temperature are best for whisking.
Before whisking egg whites, make sure there’s no grease or egg yolk
on the whisk or bowl.
Use cold ingredients for pastry unless your recipe says otherwise.
points for bread making
Never exceed the maximum capacities below - you’ll overload the
machine.
If you hear the machine labouring, switch off, remove half the dough
and do each half separately.
The ingredients mix best if you put the liquid in first.
maximum capacities
KM300, 400, 410 models KM600, 800, 810 models
Flour weight: 680g - 1lb 8oz Flour weight: 910g - 2lb
Flour weight:
1.36kg - 3lb Flour weight: 1.5kg - 3lb 5oz
Total weight:
2.18kg - 4lb 13oz Total weight: 2.4kg - 5lb 5oz
Flour weight:
1.3kg - 2lb 14oz Flour weight: 2.6kg - 5lb 12oz
Total weight:
2.5
kg - 5lb 8oz Total weight: 5kg - 11lb
Total weight:
2.72kg - 6lb Total weight: 4.55kg - 10lb
12 16
speeds
creaming fat and sugar start on min, gradually increasing to ‘max’.
beating eggs into creamed mixtures 4
- ‘max’.
folding in flour, fruit etc Min - 1.
all in one cakes start on min speed, gradually increase to max.
rubbing fat into flour min - 2.
Gradually increase to ‘max’.
Start on ‘min’, gradually increasing to
1.
for
cleaning see page 6
P
KENWOOD CHEF KM300, 400, 410 / MAJOR KM600, 800, 810
troubleshooting
solution
●
●
1
2
3
4
5
6
1
2
3
4
5
●
●
6
problem
The whisk or K-beater knocks against the bottom of the bowl or isn’t
reaching the ingredients in the bottom of the bowl.
Adjust the height. Here’s how:
Unplug.
Raise the mixer head and insert the whisk or beater.
Hold it, then loosen the nut
Lower the mixer head.
Adjust the height by turning the shaft. Ideally the whisk/K-beater should
be
almost touching the bottom of the bowl
Raise the head, hold the whisk/K-beater and tighten the nut.
to fit and use your round/D-shaped
splashguard (if supplied)
Raise the mixer head until it locks.
Fit the bowl onto the base.
Push the splashguard on until fully located
. The hinged section
should be positioned as shown round
and D-shaped
Insert required tool.
Lower the mixer head ensuring the splashguard follows the shape of
the bowl.
During mixing, ingredients can be added directly to the bowl via the
hinged section of the splashguard.
You do not need to remove the splashguard to change tools.
Remove the splashguard by raising the mixer head and sliding it down.
3
KENWOOD CHEF KM300, 400, 410 / MAJOR KM600, 800, 810
Loading...