Kenmore FP730 Installation Manual
FP730 series
mul
t
i
p
r
o
m
u
l
t
i
p
r
o
m
u
l
t
i
p
r
o
efore using your Kenwood appliance
b
●
Read these instructions carefully and retain for future reference.
●
Remove all packaging and any labels.
safety
●
he blades and discs are very sharp, handle
T
ith care. Always hold the knife blade
w
by the finger grip at the top, away
rom the cutting edge, both when
f
andling and cleaning.
h
●
Do not lift or carry the processor by the handle - or the handle
ay break resulting in injury.
m
●
lways remove the knife blade before pouring contents from the
A
bowl.
●
eep hands and utensils out of the processor bowl and liquidiser
K
ug whilst connected to the power supply.
j
●
Switch off and unplug:
●●
before fitting or removing parts
●●
after use
●●
before cleaning
●
Never use your fingers to push food down the feed tube. Always
use the pusher/s supplied.
●
Before removing the lid from the bowl or liquidiser/mill from the
power unit:-
●●
switch off;
●●
wait until the attachment/blades have completely stopped;
●●
be careful not to unscrew the liquidiser jug or mill from the
blade unit.
●
Liquids should be allowed to cool to room temperature before
blending.
●
Do not use the lid to operate the processor, always use the on/off
speed control.
●
This machine will be damaged and may cause injury
if the interlock mechanism is subjected to excessive
force.
●
Never use an unauthorised attachment.
●
Never leave the machine on unattended.
●
Never use a damaged machine. Get it checked or repaired: see
‘service and customer care’.
●
Never let the power unit, cord or plug get wet.
●
Don’t let excess cord hang over the edge of a table or worktop
or touch hot surfaces.
●
Do not exceed the maximum capacities stated in the
recommended speed chart.
●
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety.
●
Children should be supervised to ensure that they do not play
with the appliance.
●
Only use the appliance for its intended domestic use. Kenwood
will not accept any liability if the appliance is subject to improper
use, or failure to comply with these instructions.
●
Misuse of your processor/liquidiser can result in injury.
Refer to the relevant section under “using the attachments” for
additional safety warnings for each individual attachment.
before plugging in
●
Make sure your electricity supply is the same as the one shown
on the underside of your machine.
mportant – UK only
I
●
he wires in the cord are coloured as follows:
T
Blue = Neutral,
Brown = Live.
●
he appliance must be protected by a 13A approved (BS1362)
T
fuse.
ote:
N
●
For non-rewireable plugs the fuse cover MUST be refitted when
replacing the fuse. If the fuse cover is lost then the plug must not
e used until a replacement can be obtained. The correct fuse
b
cover is identified by colour and a replacement may be obtained
from your Kenwood Authorised Repairer (see Service).
●
f a non-rewireable plug is cut off it must be DESTROYED
I
IMMEDIATELY. An electric shock hazard may arise if an
unwanted non-rewireable pug is inadvertently inserted into a 13A
ocket outlet.
s
●
This appliance conforms to EC directive 2004/108/EC on
Electromagnetic Compatibility and EC regulation no. 1935/2004
of 27/10/2004 on materials intended for contact with food.
before using for the first time
1 Remove all packaging including the plastic blade covers from the
knife blade. Take care the blades are very sharp. These
covers should be discarded as they are to protect the blade
during manufacture and transit only.
2 Wash the parts see ‘cleaning’
3 Push excess cord into the back of the machine.
key
processor
power unit
detachable drive shaft
bowl
lid
feed tube
pushers
safety interlocks
cord storage
speed control
liquidiser
filler cap
lid
jug
sealing ring
blade unit
2
additional attachments
Not all of the attachments listed below may be included with
our food processor. Attachments are dependent upon the
y
model variant.
knife blade
dough tool
twin beater geared metal whisk
maxi-blend canopy
thick slicing/coarse shredding disc
thin slicing/fine shredding disc
ine (Julienne style) chipper disc
f
geared citrus press (if supplied)
mill
mini processor bowl (if supplied)
centrifugal juicer (if supplied)
choosing a speed for all functions
Tool/Attachment Function Speed Maximum Capacities
Knife Blade One Stage Cake Mix 1 – 8 1.5Kg/3lb 5oz Total Wt
Knife Blade with maxi-blend canopy Soups – start at a low speed and move up to 8 1 – 8 1.5 litres/2pts 12fl. oz
Whisk Egg Whites 8 6 Egg Whites
Dough tool Yeasted mixes 8 500g/1lb 2oz
Discs – slicing/shredding/chipping Firm food items such as carrots, hard cheese. 5 – 8
Citrus Press Citrus fruits 1
Mini Bowl & knife All processing 8 200g/8oz
Liquidiser All processing 8 1.5 litres/2pts 12fl.oz
Mill All processing 8
Centrifugal juicer Fruit & Vegetables 8 450g/1lb
Pastry - rubbing fat into flour 5 – 8 340g/12oz Flour Wt
Adding water to combine pastry ingredients 1 – 5
Chopping/pureeing/pates 8 600g/1lb 6oz Meat
Egg & sugar for fatless sponges 8
Cream 5 – 8 500 mls
Softer items such as cucumbers, tomatoes 1 – 5
3
Loading...