Kenmore 79075728991, 79075728992, 79075728993, 79075727992, 79075727993 Installation Guide

For Models with 4 Standard Sealed Top Burners

INSTALLATION AND SERVICE MUST BE PERFORMED BY

A QUALIFIED INSTALLER.

IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.

READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

THIS CONVERSION KIT MUST BE INSTALLED BY A QUALIFIED SERVICE TECHNICIAN

IN ACCORDANCE WITH THE MANUFACTURER'S INSTRUCTIONS AND ALLAPPLICABLE CODES AND
REQUIREMENTS OFTHE AUTHORITY HAVING JURISDICTION. FAILURE TO FOLLOW INSTRUCTIONS
MAY RESULT IN FIRE, EXPLOSION OR PRODUCTION OF CARBON MONOXIDE CAUSING PROPERTY
DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. THE QUALIFIED SERVICE AGENCY IS RESPONSIBLE

FOR TH E PROPER INSTALLATION OF THIS KIT. THE INSTALLATION IS NOT PROPER AND COMPLETE
UNTIL THE OPERATION OF THE CONVERTED APPLIANCE IS CHECKED AS SPECIFIED IN THE

MANUFACTURER'S INSTRUCTIONS SUPPLIED WITH THE KIT.

BEFORE PROCEEDING WITH THE CONVERSION, SHUT OFF THE GAS SUPPLY BEFORE

DISCONNECTING ELECTRICAL POWER TO THE RANGE. BE SURE BOTH POWER SUPPLIES ARE OFF
BEFORE INSTALLING THE CONVERSION KIT. FAILURE TO DO SO COULD CAUSE SERIOUS BODILY
INJURY.

This kit contains the following:

Quantity Description Part Number

Top Burner Orifice Marked 0.89 mm (7,500 BTU*)
*For operation at elevations above 2000 ft., appliancerating shall be

reducedat the rate of 4 percent for each 1000 ft. above sea level.
1
4

4
4

Tools Required:

#1 Phillips Head Screwdriver (small) _--:=_

5/8" Open End Wrench

1/8" Wide Flat Blade Screwdriver

7mm Nutdriver _ _]

Installation Instructions

Restrictor-Burner

Screw-Restrictor

Choke-Burner: Small (7,500 BTU) Top Burners

7qo.-r.qTizTq l/,; 'Flo.?'...<'7,z,/qq/;

7clo.7572- _ lj "7_o.T57Z_-_q /

790.7,._77-.1qq)_; 79o. 7573-3.9q2-.,"

9o. 7xTz,Tq 2-;

7go. 75"72_'_'q2.

316010802

316105828
316011600
316064200

316056700

Espahol- P_ginas 7-12

PIN 316105828 (0001)

How to Convert the Range for use

with LP/Propane Gas

1. Convert the Pressure Regulator

To access the regulator,remove the kick panel, storage

drawer or warmer drawer. If equipped with a broiler
drawer, open drawer completely. For models equipped

with warmer drawer, follow the instructions below to
remove warmer drawer,

a. _|Nkvivl_.l_t_ll_[C'tlElectrical Shock Hazard can occur and

result in serious injury or death. Disconnect electrical
power to the range before removing the warmer

drawer for servicing.

b. Open the drawer to the fully opened position.
c. Locate glide lever on each side of drawer, pull up on the

left glide lever and push down on the right glide lever
(see figure 1).

d. Pull the drawer away from the range.

Pullup with finger

[]

Left Glide

@@ @ @@

II II

Front Access

to Regulator:

Remove Kick Panel,

StorageDrawer, or

Warmer Drawer,

(See Owner's Guide

for Instructions).
If Equipped with

Broiler Drawer.

Open Broiler Drawer.

FIGURE 2

Pressure

Regulator

location at

rear of

range

...._er

p__ L[]

FIGURE 1

e. Do not remove the Pressure Regulator or allow it to

rotate or turn. Remove the dust protector from the

cap, Using a 5/8" wrench, unscrew the cap from the
pressure regulator. Do not remove the spring from

the regulator. Do not pull on spring.

f. Turn the cap over so the hollow end faces outward.

Place the solid end of the cap into the loop end of the
dust protector as shown in illustration below.

g. Replace the cap on the regulator. The letters LP should

be visible on the exposed end of the cap. Snap the dust
protector over the regulator cap.

RightGlide

Dust

Protector

Spring i_

Hollow End Solid End

Towards Towards

Regulator Regulator

for Natural Gas for LP/Propane Gas

FIGURE 3