Kenmore 79070270405, 79070270406, 79060012602 Installation Guide

INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALiFiED INSTALLER.

IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.

READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

If the information in this manual is not followed

exactly, a fire or explosion may result causing property
damage, personal injury or death.

FOR YOUR SAFETY:

-- Do not store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.

-- WHAT TO DO IF YOU SMELL GAS:

• Do not try to light any appliance.

• Do not touch any electrical switch; do not use any phone
in your building.

• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.

• If you cannot reach your gas supplier, call the fire
department.

-- Installation and service must be performed by a qualified
installer, service agency or the gas supplier.

RANGE
DIMENSIONS _--- 29 7/8" ---_

OVERALL !_/8"

Minimum to ] :_U" 30"

Wall on Either Minimum

Side of Range |

Above 36" 2"

Height.

U

46-3/4"

Maximum

T

36_+1/8"

Refer to your serial plate for

applicable agency certification

e ALL RANGES

CAN TiP

• INJURYTO PERSONS

COULD RESULT

• iNSTALL ANTI=TIP

DEVICE PACKED WiTH
RANGE

• SEE iNSTALLATiON
iNSTRUCTiONS

Note: For appliances installed in the
State of Massachusetts see page 2.

FRONT SIDE

VIEW VIEW

Cabinets on Maximum Depth

_. Minimum to 1÷13"-_1

Either Side for Cabinets

,_ of Range. Above Range Top. _1

_25"_

445/8" _

Door Open -_\\

2 7 "

\ ,,t/i_? .....

Clearances and Dimensions

1. Location--Check location where the range will be
installed. Check for proper electrical and gas supply,

and the stability of the floor.

2. Dimensions that are shown must be used. Given
dimensions provide minimum clearance. Contact

surface must be solid and level.

p/n 316469100 (0608) EN/SP

iii i

i i _ iii

_ 30"

Important Notes to the Installer

1. Read all instructions contained in these installation
instructions before installing range.

2. Remove all packing material from the oven compartments
before connecting the gas and electrical supply to the
range.

3. Observe all governing codes and ordinances.

4. Be sure to leave these instructions with the consumer.

Important Note to the Consumer: Keep these instructions
with your Use & Care Guide for future reference.

1

0" Clearance Below Cooking Top and at Rear of Range.

iMPORTANT SAFETY
iNSTRUCTiONS

installation of this range must conform with local codes or, in
the absence oflocal codes, with the National Fuel Gas Code

ANSI Z223.1--1atest edition when installed in the United
States. When installed in Canada, installation must conform

with CAN/CGA-B149.1 and CAN/CGA-B149.2.
This range has been design certified by CSA international. As

with any appliance using gas and generating heat, there are
certain safety precautions you should follow. You will find them
in the Owner's Guide_,read it carefully.

• Be sure your range is installed and grounded properly
by a qualified installer or service technician.

• This range must be electrically grounded in
accordance with local codes or, in their absence,

with the National Electrical Code ANSI/NFPA No .70--
latest edition when installed in the United States.

When installed inCanada, this range must be electrically
grounded in accordance with CSA Standard C22.1,
Canadian Electrical Code, Part 1. (Read the Grounding
instructions on pages 5 and 6).

• The installationof appliances designed for manufactured
(mobile) home installationmust conform with Manufactured
Home Construction and Safety Standard, title 24CFR,
part 3280 [Formerlythe Federal Standard for Mobile Home
Construction and Safety, title 24, HUD (part 280)] orwhen
such standard is not applicable, the Standard for
Manufactured Home Installation 1982 (Manufcatu redHome
Sites, Communities and Set-ups), ANSi Z225.1/NFPA
501A--latest edition, or with local codes when installedin
the United States. When installed inCanada, installation

must conform with CAN/CSA-Z240 MH.

• Before installing the range in an area covered with
linoleum or any other synthetic floor covering, make
sure the floor covering can withstand heat at least
90°F above room temperature without shrinking,
warping or discoloring. Do not install the range over
carpeting unless you place an insulating pad or sheet of
1/4-inch thick plywood between the range and carpeting.
Make sure the wall coverings around the range can
withstand the heat generated by the range.

Do not obstruct the flow of combustion air at the oven
vent nor around the base or beneath the lower front

panel of the range. Avoid touching the vent openings or
nearby surfaces as they may become hot while the oven
is in operation. This range requires fresh air for proper

burnercombustion.

Stepping, leaning or sitting on the doors or

drawers of this range can result in serious injuries and
can also cause damage to the range.

Never leave children alone or unattended

in the area where an appliance is in use. As children grow,
teach them the proper, safe use ofall appliances. Never leave
the oven door open when the range is unattended.

• Do not store items of interest to children in the
cabinets above the range. Children could be seriously

burned climbing on the range to reach items.

• To eliminate the need to reach over the surface
burners, cabinet storage space above the burners

should be avoided.

• Adjust surface burner flame size so it does not
extend beyond the edge of the cooking utensil.

Excessive flame is hazardous.

• Do not use the oven as astorage space. This creates
a potentially hazardous situation.

• Never use your range for warming or heating the
room. Prolonged use of the range without adequate
ventilation can be dangerous.

• Do not store or use gasoline or other flammable
vapors and liquids near this or any other appliance.
Explosions or fires could result.

• Reset all controls to the "off" position after using a
programmable timing operation.

= Air curtain or other overhead range hoods, which

operate by blowing a downward air flow on to a
range, shall not be used in conjunction with gas
ranges other than when the hood and range have
been designed, tested and listed by an
independent test laboratory for use in combination

with each other.

Before Proceeding"

Your range has been preset at the factory for use with Natural
Gas. This appliance may beconverted for LP/Propane Gas by
installing the supplied LP Kit located on the backside of the
appliance.

Special instructions for appliances installed in the State of
Massachusetts: This appliance can only be installed in the
State of Massachusetts by a Massachusetts licensed
plumber or gas fitter. When using a flexible gas connector, it
must not exceed 3 feet (36 inches) in length. A "T" handle

type manual gas valve must be installed in the gas supply

line to this appliance.

DO NOT MAKE ANY ATTEMPT TO

OPERATE THE ELECTRIC IGNITION OVEN DURING AN

ELECTRICAL POWER FAILURE. RESET ALL OVEN
CONTROLS TO "OFF" IN THE EVENT OF A POWER
FAILURE.

The electric ignitor will automatically re-ignite the oven
burner when power resumes iftheoven thermostat control

was left in the "ON" position.
When an electrical power failure occurs during use, the

surface burners will continue to operate.
During a power outage, the surface burners can be lit with

a match. Hold a lighted match to the burner, then slowly turn
the knob to the LITE position. Use extreme caution when
lighting burners this way.