Kenmore 758.154120 Owner's Manual

READ AND SAVE THESE INSTRUCTIONS
Operator's Manual
®
WHOLE HOUSE
12 Gallon Output with Digital Readout
Model 758.154120
HUMIDIFIER
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
www.sears.com
Part No. SP6592 Printed in Canada
Safety
Assembly
Operation
Maintenance
Parts
Espa_ol, p. 17
P_ONE YEAR FULL WARRANTY ON KENMORE HUMIDIFIER _
If any part of this humidifier fails due to a defect in material or workmanship within one year from the date of purchase, or it the humidifier motor fails due
to a defect in material or workmanship during the second year from the date of purchase, RETURN THE HUMIDIFIER TO THE NEAREST SEARS PARTS &
REPAIR CENTER, and it will be repaired free of charge. This warranty does not include humidifier filters, which are expendable parts that can wear out
from normal use in less than one year. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
Sears, Roebuck and Co., Dept. 817WA, Hoffman Estates, IL 60179
GENERAL SAFETY INSTRUCTIONS
Safety Signal Words
DANGER: means if the safety
information is not followed someone will be seriously injured or killed.
WARNING: means if the safety information is not followed someone
could be seriously injured or killed. CAUTION: means if the safety
information is not followed someone may be injured.
1. To reduce the risk of fire or shock hazard, plug humidifier directly into a
120V, A.C. electrical outlet. Do not use
extension cords.
2. Keep the electric cord out of traffic areas. To reduce the risk of fire
hazard, never put the electric cord under rugs, near heat registers,
radiators, stoves or heaters.
3. Always unplug the humidifier before moving it, before cleaning, or
whenever the humidifier is not in service.
4. Keep the humidifier clean.
5. Do not put foreign objects inside the humidifier.
6. Do not allow to be used as a toy. Close attention is necessary when used by or near children.
7. Never use your humidifier while any part is missing or damaged in any
manner.
8. To reduce the risk of electrical hazard or damage to humidifier, do not tilt, jolt or tip humidifier while unit
is running.
9. To reduce the risk of damage to humidifier, unplug when not in use.
10. To reduce the risk of accidental electrical shock, do not touch the
cord or controls with wet hands.
11. Note the warning label shown below.
WARNING: To reduce risk of fire,
electric shock, or injury always unplug before servicing or cleaning.
Table of Contents
Warranty Information ............................... 2
General Safety Instructions .................... 2
To Save A Service Call ........................... 3
Know Your Humidifier ............................. 3
How Your Humidifier Works .................... 4
Step 1. Getting Your Humidifier
Up and Running ................................. 4
Step 2. Location Instructions ................. 5
Electrical Hook-Up .................................. 5
Step 3. Water Fill .................................... 6
Step 4. Operating the Controls ........... 7-8
Using Your Humidifier ........................ 9-10
Replacement and Care of Filters .......... 11
Cleaning and Maintenance ................... 12
Troubleshooting ................................... 13
Repair Parts ..................................... 14-15
To Save A Service Call --
Check the following if your humidifier is not operating.
1. Is power cord attached to outlet?
2. Is there electrical power to outlet?
Know Your Humidifier --
3. Is fan control on?
4. Is humidity control set high enough?
5. Is the cabinet sitting on a level surface?
Fan Assembly _
. Bottle Handle
.........Speed
Control
Housing J Assembly
Humidistat Base (On Power
Cord)
_" Filter:
Description Gallon Output/24 hrs.
Capacity of Bottle Capacity of Base
Sq. Ft. Coverage Fan Speeds
Auto Fan Speed Replacement Filter
Power Light Fill Light
Auto Humidistat Auto Shut Off
Controls Casters
CUL Listed Volts
Hertz Amps (High Speed)
Watts (High Speed)
758.154120 12
1.9 Gallons
2.0 Gallons
2500
4
Yes
32-14906
Yes Yes
Yes Yes
Electronic (Push Button)
Yes (4)
Yes
120 A.C.
60
0.80 8O
....... Bottle
jJ
Replacement No.
32-14906
Based on an area with average insulation and an 8 foot ceiling height
How Your Humidifier Works --
Your new Kenmore humidifier is designed to satisfy home humidity requirements through the principle of evaporation of
water in the air. Once the filter becomes saturated, air is drawn in, passes through Dry air
the filter and moisture is absorbed into enters the air. All evaporation occurs in the the
humidifier so any residue remains in the louvers filter. This natural process of evaporation in the
virtually eliminates white dust. housing
CAUTION: To reduce the risk of injury, fire or damage to humidifier,
use only cleaners specifically recommended for humidifiers. Never
use flammable, combustible or poisonous materials to clean your
humidifier. To reduce the risk of scalds and damage to humidifier, never put hot water in humidifier.
Humidified air is then released throuc
through
Step 1. Getting Your Humidifier Up and Running --
Assembly Remove casters, water bottle, housing
assembly, and filter from the box and reverse the base. Press casters into the
bottom of the base manually. Do not use tools. Set the base upright.
Replace the filter, housing assembly and bottle (See "Replacement and Care of Filters", page 11 for reference).
Step 2.
WARNING: For your own safety, do not use humidifier if any parts are damaged or missing.
Selecting A Location Place humidifier on a flat level surface,
take extra care in leveling when placing the unit on carpet. Position the humidifier where the most humidity is needed or
where the most air will be circulated throughout the house such as near a
cold air return.
Moist air (humidity) produced will disperse into the whole house, but the
area closest to the unit will have the highest humidity. If the unit is positioned
close to a window, condensation may form on the window pane. If this occurs the unit should be repositioned in another
location.
NOTE: Due to release of cool, moist air from humidifier, it is best to direct air away from thermostat and hot air registers and to position humidifier next
to an inside wall. Unit should not be placed where cold air from outside walls
or warm air from a hot air register blows directly on it.
Location and Electrical Hook-Up
Positioning The Unit The humidifier should be positioned with
the back (cord exit side) and left side, at least 2 inches away from the wall. Air needs to enter through all of the louvers in the housing assembly in order for the humidifier to operate at peak efficiency.
I At least 2 inches
from wall
NOTE: Be sure humidistat, which is located on power cord, is free from
obstruction and away from any hot air source.
Electrical Hook-Up
Locate nearest 120V A.C. wall socket in the location desired, preferably on inside
wall. With the humidifier in the desired location, route the electrical cord safely
so no one will trip or upset the humidifier. Plug in the electrical cord.
WARNING: To reduce the risk of fire or shock hazard, humidifier should
be plugged into a 120VA.C. outlet. Do not use extension cords.
To reduce the risk of electrical shock, this humidifier has a polarized plug (one
blade is wider than the other). This plug will fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet, reverse plug. If it still does not fit, contact
a qualified electrician to install the proper outlet. Do not change the plug in any way.
Loading...
+ 11 hidden pages