Kenmore 66513842K600, 66513843K600, 66513844K600, 66513849K600 Installation Guide

EZ iNSTALLTips

See Installationinstructionsformoredetailed information.

Tip Over Hazard

Do not use dishwasher until completely installed. Do not push down on open door.

Doing so can result in serious injury or cuts.

Before you begin your dishwasher installation:

Turn off the water and electricity.

o Remove old dishwasher,

You may need to purchase the following:

%" NPT compression or flared 90 ° elbow

Plumber tape 2 appropriate wire connectors

Tip the dishwasher and lay it on its back.

Use the packaging material

underneath to protect the floor.

Connect the drain hose extension.

Use the green clamp provided to connect the supplied drain hose.

Connect the hot water inlet hose.

Apply plumber tape to only the %" Connect the threaded compression

NPT threaded end of the 90° elbow or flared 90° elbow end to the fitting, hose. Then connect this end into the

water inlet valve. Leave elbow facing the rear of the dishwasher.

Stand dishwasher up.

Pull all the tubing, hoses and wires Slide dishwasher into position.

through their cabinet openings. Make final connections for drain,

water and electricity as needed.

If there is a disposal, remove the Connect the dishwasher to the

disposal plug. drain using the silver clamp

provided.

Level dishwasher and secure.

Use a level and check across the

bottom edge of the closed dishwasher door and along the front of door from top to bottom.

Raise or lower front legs as needed.

Check the dishwasher fit with the cabinet opening.

Remove supplied parts and

literature from inside the dishwasher.

Remove 2 access panels. Fit the dishwasher into the cabinet.

Remove old drain hose and check routing for new drain hose. Route

water and electric supplies.

Electrical Shock Hazard

Electrically ground dishwasher,

Connect ground wire to green ground connector in terminal box. Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or

electrical shock.

Connect to electric power.

Open the door and place a towel over the lower dish rack to prevent any dropped screws from falling into the pump.

Secure the dishwasher to countertop with screws provided.

Check for leaks.

Turn on water and check for leaks at fitting. Reinstall the 2 access panels on the lower front of the dishwasher.

Turn electricity on. Run a cycle to check for leaks at both the hot

water and drain connections.

Remove terminal cover.

Adjust the back wheels as

necessary.

Adjust the front legs as necessary.

Connect the wires using appropriate wire connectors to secure.

Replace the terminal cover after electricity is connected.

TM SM

When water and drain connections are working, cancel cycle.