MODEL NO.
625.343800
625.343820
{DELUXE)
Caution:
Read and Follow
All Safety Rules,
Installation and
Operating
Instructions
Before First Use
of This Product.
WaterWorks
If you have questions
when installing and us-
ing your water filter,
housing call this toll-
free number...
1 -800 -426 -9345
SAVE THIS MANUAL
Sears, Roebuck and Co., Hoffman Estates, IL 60179 USA
Safety Guides
Installation
Operation
Cartridge Replacement
Repair Parts
SAFETY GUIDES / SPECIFICATIONS
"_ Please read this entire manual before
installing and using your undersink water
f'dter housing. Be sure to follow all guides and
rules carefully. Failure to follow them could
cause personal injury or property damage.
Check with your local public works
department for plumbing codes. You must
follow their guides as you install the water
Ftlter housLtig.
Use the f'dter on a potable, safe-to-drink,
home COLD water supply only. The filter
Maximum Supply Water Pressure
Min_- Max. Supply Water Temperature
Inlet - Outlet Thread Size
cartridge will not purify water, or make it safe
to drink. DO NOT use on HOT water (IO0°F,
max.), n_dcrobioiogically unsafe water, or on
water of unknown quality.
Protect the water filter housing and piping
from freezing. Water freezing in the housing
will break it.
Your undersink water filter housing will
withstand up to 125 psi water pressure. If
your house water supply pressure is higher
than 100 psi, install a pressure reducing valve
before the water filter.
125 psi
40 - I00 °F
318"NPT
WARRANTY
FULL ONE YEAR WARRANTY ON UNDERSINK WATER FILTER HOUSING
( disposable filter cartridge not included)
For' one year from the date of purcllase, Sears will replace this Undersink Water Filter Housing, (except filter
cartridge, which is purchased separately), free of charge, ifdefective in materiai or workmanship.
WARRANTY IS AVAILABLE BY SIMPLY RETURNING THE WATER FILTER HOUSING TO THE NEAREST
SEARS STORE THROUGHOUT THE UNITED STATES°
This warranty gives you specific legal rights, and you may have other rights which vary from state to state.
Sears, Roebuck and Co., DEPT, 817 WA, Hoffman Estates, IL 60179
2
TABLE OF CONTENTS
Water Treatment Filter Cartridges .................................... 3
Planning Installation / Typical Installation Drawings / Tools and
Materials Needed ................................................... 4 - 5
Water' Filter' Housing Installation ..................................... 5 - 7
Using Compression Fittings ........................................ 5 - 6
Using Soldered Copper ....................................... 6
Using Threaded Fittings ...................................... 7
Installing Filter' Cartridge ....................................... 7
Filter Cartridge I.ife / Replacement ................................... 8
Repair Parts .......................................................... 9
WATER TREATMENT FILTER CARTRIDGES
Filter cartridges are available (not included with water
filter housing) flora Sears to remove (1) sediments, (2)
tastes and odors, (3) tastes, odors and chemical con-
taminants, and ('4) tastes, odors and lead.
Following is a list of filter cartridges available at the
time of dais printing. Shop your local Sears store for
the current selection
(1) Sediment Filter Cartridge, Sears Stock No.
42-34360 (25 micron), or Stock No. 42-34362 (5
micron): Sediment cartridges remove sand, silt, clay,
dirt, and other sediments from water The 25 micron
cartridge filters larger sediments from water', and a!-
lows higher flows at less pressure drop, The 5 micron
cartridge filters finer' sediments from water,
Taste and Odor Cartt-idges: Many bad tastes and/or
odors are removed from water' by an activated carbon
cartridge. It is most often useci to remove chlorine taste
and smell, usually to a single faucet such as die kitchen
cold
Note: Small amounts of hydrogen sulfide (noticeable
as "rotten egg" odor) may be reduced by taste and
odor filters for a short time, quicldy exhausting flae car-
bon media. Consult your Sears store for proper contin-
uous treatment,
Sears has several taste and odor' filter cartridges avail-
able. These are:
(2) Sears Stock No. 42-34370: for' 95% chlorine
reduction,
and Sears Stock No. 42-34372: for' 99% chlorine
reduction
(3) Sears Stock No. 42-34375: for 99% chlorine
reduction, plus chemical contaminants
(4) Sears Stock No. 42-34377: for 99% chlorine
reduction, plus 95% lead reduction
Locate the water filter' housing on the cold water sup-
ply pipe, under the kitchen and/or bathroom sink, to
filter' the cold drinking water: Refer to the following
drawing
FILTERING WATER TO ONE FAUCET
r'l _ n kitchen sink
I I
HOT g
COLD
HOUSING
PLANNING YOUR INSTALLATION
When planning your installation, use the drawings be-
low and on page 5 to guide you, There are many van-
_k Installation Kit, Sears Stock No. 42-34386 - Includes
318" fittings and tubing
ables to consider' as you plan, Some of these are:
t,," The water filter' housing inlet and outlet internal
threads are 318" NP'E
existing plumbing type (copper; threaded, etc.) and
Installation Kit, Sears Stock No. 42-34387 - Includes
3f8" fittings and tubing, water' supply saddle valve,
and a separate faucet for filtered water'.
nominal size (114", 318" etc.)
tools you have, and your plumbing skills
t.," cost of materials needed
t.* space available fbr installing the filter' housing
Sears has optiona! kits available to make installing the
water' filter housing easier' (see below and page 5)
These are:
-k Mounting Bracket, Seat's Stock No, 42-34388 - (in-
cluded with deluxe model)
Make a simple sketch of your' proposed installation,
and a list of plumbing materials you will need Obtain
evep/d_ing you need before starting the installation.
Be sure you have the tools required.
TYPICAL UNDERSINK INSTALLATIONS / TOOLS AND MATERIALS NEEDED
INSTALLATION ON COPPER PLUMBING USING COMPRESSION FITTINGS
f
\ SINK / compression / --
elbow / "_
! _ Mounting Bracket -includes screws
Sears Stock No.,42-_34388
I
/
HOT / apply several
shutoff valve / wraps of
filter cartridge, you
mustturnoffthewa-
Note: Tochange the / Teflontiape
ter. A nearby shutoff t
valve is convienenL /
Most sinks already/
have shutoff valves/
on the supply pipe& 1
INLET
3/8" NPT
Note: Be sure to allow a minimum
space of 1-1t2" under the filter for
removing the sump, to change the
cartridge.
j (included with Deluxer_odel)
/
nut
brass
ferrule
compression
adaptor (use elbow
or straight fitting)
- MATERIALS AND TOOLS NEEDED -
2 compression adaptors (either straight fit-
tings as shown, or'elbows), 3/8" NPT x comp..
ii_ 2 compression elbows, 3/8" NPT x comp.
(compression end to fit existing pipe)
Note: Sears has an installation kit available
that fits 3/8" O.D. pipe size, Stock No.
42-34386.
Teflon tape
tubing cutter
_- sandpaper or emery-cloth
_9wrenches, either nn_n_t_._.,end n,_.._=,4ju_t=bI,=_..
jaw, size to fit compression adaptors
4