Kenmore 56494449400, 56494446400 Owner’s Manual

Compact Refrigerator

Models: 94449194446

4.4 cu. ft. Capacity

Read This Manuall

It will tell you how to operate and care for your refrigerator.
It also offers tips on how to get the best and lowest cost

performance.

If you prefer installing your own parts, use the parts list to

find the part number. Do not use the illustration number.

In the space below record the model and serial number of

your refrigerator. Each is printed on the model number

plate located in the upper comer of the refrigerator back.
Use these numbers when calling for service.

Model No. Serial No.

Kenmore Appliance Warranty

One Year Limited Warranty
When installed, operated and maintained accordingto all
instructionssuppliedwiththe product, ifthisappliance fails

due to a defect in material or workmanship withinone year

from the date of purchase,call 1-800-.4-MY-HOME® to

arrange for free repair.

Disclaimer of implied warranties;
limitation of remedies

Customer's sole and exclusive remedy under this limited

warranty shall be product repair as provided herein. Implied
warranties, including warranties of merchantability orfitness
for a particular purpose, are limited to one year or the
shortest period allowed by law. Sears shall not be liable for

incidental or consequential damages, or limitation on the
duration of implied warranties of merchantability orfitness,
so these exclusions or limitations may not apply to you.

This warranty applies only while this appliance is used in the
United States and Canada.

This warranty gives you specific legal rights, and you may
also have other rights which vary from state to state.

Sears, Roebuck and Co., Dept. 814WA, Hoffman
Estates, IL 60179

Sears Canada Inc. Toronto, Ontario, Canada MSB 2B8

Installation

Remove all packing material and tape from the unit. Inspect
the unit thoroughly, notify Sears immediately if the unit has

any damaged or missing parts.
Install the unit on a strong level floor or counter. Avoid any
direct sunlight, heat source or moisture.

Let air circulate freely around the refrigerator. Keep the back

of the unit at least A inches away from the wall. Provide at
least 1 inch of space between the top of the unit and any

surface above it.

at least three minutes before restartingtoavoid

CAUTION: If you turn offthe coldcontrol,allow

blowingfuses or trippingyourcircuitbreaker.

If this applianceis used forother than private family
purposes,this warranty appliesfor only 90 days from the

Electrical Requirements

120 Volts, 60 Hz (60 cycles AC), 15 amps.

date ofpurchase.

"This warranty covers only defects in material and

workmanship, Sears will NOT pay for:

1, Expandibleitems that can wear out from normal use,

includingbutnot limitedtofilters, belts,light bulbs,and
bags.

2. Aservice technician to instructthe user in correct

productinstallation,operationof maintenance.

3. Aservice technician to clean or maintain this product.

4. Damage toor failure ofthis product if itis not installed,
operatedor maintained according to all instructions

suppliedwith the product.

Eiectricai Gr0u_nding

Your refrigerator comes with a three-prong plug and must be
inserted into a three-prong, grounded wall outlet. Do not use
an extension cord.

WARNING: Unless the above grounding

methods are followed, you are notprotected
against severe or lethal shockin the event ofa
short circuitin refrigeratorwiring orelectrical

components.

5. Damage to or failure of this productresultingfrom
accident,abuse, misuse, or use for other thanits

intendedpurpose.

6. Damage to 0r failure of thisproductcaused by the use
ofdetergents, cleaners, chemical or utensils other than

those recommended inall instructionssuppliedwiththe
product.

7. Damage to or failure of partsorsystem resultingfrom
unauthorizedmodificationsmade to this product.

Things to Remember

1. When resetting your refrigerator to a new temperature,

allow 24 hours for it to reach the new setting.

2. The motor will start and stop often. It must do so in order

to maintain the temperature you select.

3. Keep your refrigerator level.

4. Unplug the refrigerator before doing a_ything with the

electrical system.

Sears, Roebuck and Co., Hoffman Estates, IL 60179

Part No. 302978
(SR4432SBtSMD) Sears, Roebuck and Co., U.S,A.

HOW TO TRANSFER THE DOOR HINGE LOCATION OF

A REVERSIBLE DOOR

For your convenience, this door can be reversed by changing the position of the door hinge assembly.

1. Gently lay de refrigerator on its back.

2, Unscrew the leg at opening side and set aside. *There may be a screw next to the leg; if so unscrew it.

Otherwise unable to attach the hinge.

3. Unscrew two screws (some models have 3 screws) at the bottom hinge, remove the leg, a hinge and a
shaft.

4. Unscrew two screws at the bottom of the door and remove the door stopper, then transfer them to the other
side.

5. Pull the door toward you, and set it at the side. (We recommended putting the door on a blanket to avoid

scratches.)

6. Remove the shaft carefully from the top table as using the screwdriver and relocate itto the other side.

7. Remove the hinge collar cap from the door cap, and then relocate it to the other side.

8. Reattach the door to the refrigerator cabinet toward the shaft at the top table and the bottom of the door hole

has to meet with the shaft at the bottom hinge.

9. Reattach the hinge with two screws (some models have 3screws), the leg and also the shaft with the hinge.

10. Now your door has been reversed. The following points should be checked.

A. Make sure the door is onstraight.
B. Make sure that there is no space between the door gasket and the refrigerator unit itself when the door is

closed.

C. Make sure that the gasket on the hinge side is not caught between the door and the unit when the door is

opened or closed. (If the door is forced closed when the gasket is caught, the gasket may be damaged.)

When checking the above points, ifit is discovered that the door is not installed properly (this is apt to happen

at the first try), loosen the screws holding the lower hinge, straighten the door and tighten the screws slowly
with the socket wrench. After making sure that the door is installed correctly, tighten all the screws holding
the hinge. If they are not tightened, the door may slip put of position or there may be an opening between the

door and the unit.

11. Stand the unit back in the upright position.
Wait 3 hours before plug in the power cord.

S H_je CollarCap