Kenmore 56494443500 Owner’s Manual

303035

installation

®

Remove all packing material and tape from the unit. Inspect
the unit thoroughly. Notify Sears immediately if the unit has

any damaged or missing parts.

Compact Refrigerator

Model 94443

4.4 cu0 ft. Capacity

Read This Manual!

It will tell you how to operate and care for your refrigerator.
It also offers tips on how to get the best and lowest cost

performance.

If you prefer installing your own parts, use the attached
parts list to find the correct part number. Do not use the

illustration number. In the space provided below record the
model and serial number of your refrigerator. This can be

found on the rear of the refrigerator printed or the model

number plate.
This information will be required when call ng for parts or

servtce.

Model No. Seria No.

Full One Year Warranty on Refrigerator

For one year from the date of purchase, when this refrig-

erator is operated and maintained in accordance with the
provided owner's manual, Sears will repair it, free of

charge, if found defective in material or workmanship.

Full Five Year Warranty on

Sealed Refrigeration System

For five years from the date of purchase, when this refrig-
erator _s operated and maintained in accordance with the
provided owner's manua, Sears will repair the sealed

system (consisting of refrigerant, connecting tubing and
compressor motor), free of charge, if found defective in

material or workmanship.

The above warranty coverage applies only to a refrigerator
which is used for food storage and private household

purposes.
Warranty service is available by contacting the nearest

Sears Service Center throughout the United States.
This warranty applies only while this product is operated in

the United States. This warranty gwes you specific rights
and you may also have other rights which vary from state to
state.

SEARS, ROEBUCK AND CO.,
D/817WA, HOFFMAN ESTATES IL 60179

Install the unit on a strong level, floor or counter. Avoid any
direct sunlight, heat source or moisture.

Let air circulate freely around the refrigerator. Keep the back

of the unit at least 4 inches away from the wall Provide at
least 1 inch of space between the top of the unit and any

surface above it.

CAUTION: If you turn off the cold control, allow
at least three minutes before restarting to avoid

blowing fuses or tripping your circuit breaker.

Electrical

120 Volts, 60 Hz (60 cycles AC), 15 amps.

Electrical Grounding

Your refrigerator comes with a three-prong plug and must be
inserted into a three-prong, grounded wall outlet. Do not use

an extension cord.

WARNING: Unless the above grounding

methods is followed, you are not protected
against severe or lethal shock in the event of a

short circuit in refrigerator wiring or electrical
components.

Things to Remember

1. When resetting your refrigerator to a new temperature,
allow 24 hours for it to reach the new setting.

2. The motor will start and stop often. It must do so in order
to maintain the selected temperature.

3. Keep your refrigerator level.

4. Always unplug the refrigerator before cleaning or
servicing.

NOTE: Please remove the protective film on the door

and cabinet before usage.

Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.

Part No. 303035

SR4433SSDL)

PDF processed with CutePDF evaluation edition www:CutePDF.com

Part No. 8336460148900

Sears Roebuck and Co. U.S.A.

. k :_

. • . . . .

HOW TO TRANSFER THE DOOR HINGE LOCATION OF

A REVERSIBLE DOOR

Foryour convenience, this door can be reversed bychanging the position of the door hinge assembly.

1. Gently lay de refrigerator on its back.

2. Unscrew the leg at opening side and set aside. *There may be a screw next to the leg; if so unscrew it.
Otherwise unable to attach the hinge.

3. Unscrew two screws (some models have 3 screws) at the bottom hinge, remove the leg, a hinge and a

shaft.

4. Unscrew two screws at the bottom of the door and remove the door stopper, then transfer them to the other

side

5. Pull the door toward you, and set it at the side. (We recommended putting the door on a blanket to avoid
scratches.)

6. Remove the shaft carefully from the top table as using the screwdriver and relocate itto the other side.

7. Remove the hinge collar cap from the door cap, and then relocate itto the other side.

8. Reattach the door to the refrigerator cabinet toward the shaft at the top tahie and the bottom of the door hole
has to meetwith the shaft at the bottom hinge.

9. Reattach the hinge with two screws (some models have 3 screws), the leg and also the shaft with the hinge.

10. Now you r door has been reversed. The following points should be checked.
A. Make sure the door is on straight.

B. Make sure that there is no space between the door gasket and the refrigerator unit itself when the door is

closed.

C. Make sure that the gasket on the hinge side is not caught between the door and the unitwhen the door is

opened or closed. (If the door isforced closed when the gasket is caught, the gasket may be damaged.)
When checking the above points, if it isdiscovered that the door is not installed properly (this is apt to happen
at the first try), loosen the screws holding the lower hinge, straighten the door and tighten the screws slowly
with the socket wrench. After making sure that the door is installed correctly, tighten all the screws holding

the hinge. Ifthey are not tightened, the door may slip put of position or there may be an opening between the
door andthe unit

11. Stand the unit back in the upright position.
Wait 3 hours before plug inthe power cord.

k_• -1 k

• " °

Leg Space, '-'=-'_''_"

Leg j

NexegonalHsad
Screws

TophingeAssernbly

F HingeCollar CaB

/

l