Kenmore 41799390800 Owner’s Manual
MODEL-SERIAL
NUMBER PLATE
DRYING RACK
K nmore
BLEACH
DISPENSER
DYNAMIC
BALANCE SYSTEM
SELF-CLEANING
LINT RLTER
LINT FILTER
OPENING
. SAFETY LID
SWITCH
PiN 131219200 6/93
USING THE DRYER
READ USE AND CARE GUIDE FOR
MORE COMPLETE iNSTRUCTiONS
,
Clean dryer lint filter located at the bottom of the door
opening before or after EACH load. Replace filter.
CLEAN FILTER will flash in display window until dryer
starts. If it flashes during dryer operation, air flow is
blocked. Stop dryer, disconnect power cord, and check lint
filter, exhaust duct and vent hood.
.
Place one wash load in dryer. Add fabric softener sheet if
desired.
°
Close dryer door.
4.
Touch Cycle, Option, and Cycle Adjustment pads desired.
5.
Touch START pad.
6.
Remove dried load promptly to minimize wrinkling.
OPEN FOR MORE WASHER tNFORMATDON'_
Page 2
BASIC CYCLES
SPECIAL CYCLES
FAVORWTE CYCLE
COTTON STURDY A cycle for
work clothes, towels and underwear
that provides a combination ofnormaI
and gentle agitation for 6-18 minutes.
After agitation, a spray rinse in the
first spin is followed by a deep rinse
and a fast spin. This cycle is
programmed for a t2-minute warm
wash and a cold rinse at Water Level
5.
PERM'T PRESS A cycle for
cottons and blends with a no-iron
finish that provides a combination of
normal and gentle agitation for 6-12
minutes. After agitation, a spray rinse
in the first spin is followed by a deep
rinse and a stow spin. This cycle is
programmed for an 8-minute warm
wash and a cold rinse at Water Level
5.
KNIT/DELICATE A cycle
for synthetics and fabrics requiring
special care. It provides acombination
of gentle agitation and soak for 4-8
minutes. A spray rinse occurs during
the first spin, followed bYa deep rinse
and a slow spin. This cycle is
programmed for a 6-minute warm
wash and a cold rinse at Water Level
3.
NOTE: The above cycles may be
personalized. See page 7 or Quick
Reference Card,
SOAK A special cycle for heavily
soiled or stained items. Two minutes
of gentle agitation are followed by 9-
34 minutes of soak time, 2 more
minutesofagitation andacombination
of fast and slow spins. This cycle is
programmed for 19 minutes of soak in
warm water and a cold rinse at Water
Level 3. Always follow SOAK with a
basic wash cycle using the
recommended amount of detergent.
NOTE: Hot water cannot be selected
because some stains are set at that
temperature.
RINSE/SPIN A special cycle that
provides a combination of normaland
gentle agitation for 4minutes followed
by 8 minutes of fast and slow spin.
This cycle is programmed to use cold
water at Water Level 5.
SPIN ONLY A special cycle that
provides a combination of fast and
slow spins for 12 minutes. This cycle
is usedto remove water from wet items
such as hand laundry and diapers or if
more spin time is needed after
completion of a cycle.
This special cycle can be programmed
to meet your specific laundry needs.
1. Touch FAVORITE CYCLE.
2. Touch a BASIC CYCLE.
3. Add Options desired.
4. Make Cycle Adjustments desired.
5. Touch FAVORITE CYCLE
again. A long beep will sound.
This cycle will be remembered each
time FAVORITE CYCLE is selected.
Follow same steps to reprogram this
cycle, To return to factory setting,
touch FAVORITE CYCLE until a
tong and a short beep sound. Then
touch that pad again. A long beep will
sound when the factory-set program is
restored.
ONE STEP
ONE STEP is an effortless cycle
designed for the occasional launderer.
This general purpose cycle
automatically starts with one touch.
CYCLE SIGNAL, ELECTRONIC
TEMP CONTROL, WASH TEMP,
RINSE TEMP AND WATER_LEVEL
can be changed after washer starts.
Page 3
Loading...