Kenmore 41797972701, 41797972700, 41797922701, 41797922700, 41797822701 Owner’s Manual

@

Laundry Center Dryer Operating Instructions

Models 97922/97972

All

40 50

Before Operating Your Dryer

Readyour Owner's Guide. It hasimportant safety

and warranty information. It also has many
suggestions for best drying results.

To reduce the risk of fire, electric

shock, or injury to persons, read the IMPORTANT
SAFETYINSTRUCTIONSin your owner's guide before
operating this appliance.

Operating Steps

Read Drying Procedures in your Owner's Guide.

It explains these operating steps in detail.

1, Prepare items for drying.

2. Check that tint screen is clean and in place.

3. Load the dryer, If desired, add a dryer fabric

softener sheet.

4, Close the dryer door,

Printed in U.S.A.

TURN TO STARI

COOi _OWN

OF/

IPE_@4t:_[_II_SS KNI'S

',E) l H/, M [ Ui,/LO\/i {Eis,

5. Set Drying Temperature control

6. Turn cycle selector clockwise to desired
setting.

7. Start dryer. Turn the Turn to Start control

clockwise to ON. Hold for I-2 seconds and
release.

& A signal will sound when the cycle ends.

9, Remove items immediately and hang or

fold.

10. Clean tint screen after every load.

Temperature Selection

Always follow directions on fabric care
labels.

To avoid fire hazard, do not use heat

to dry items containing feathers or down, foam

rubber, plastics, or similarly textured, rubber-like
materials. Use Air Fluff-No Heat cycle only.

D£YINQ TE#4P_R_'[UIBE

AUTO/_aI_ I0

WRl#iI(I £ RIP

Select the temperature setting most suitable for each
load. TheREGULAR--HIGH HEAT, PERM PRESS--

MEDIUM HEA T,KNITS--MEDIUM-LOW HEA Tand
DELICATES--LOWHEATtemperature settings may

be used with any cycle setting.

Cycle Selection

Turn cycle selector clockwise to desired cycle and
setting.

The Automatic and Timed Dry cycles end with a cool
down period. The heat automatically turns off and
the load continues to tumble during the cool down
period. This reduces wrinkling and makes items
easierto handle during unloading.

Drying time varies depending on sizeand dampness
of load, weight and fabric type. Room temperature
and humidity, type of installation and electrical
voltage or gas pressure can also affect drying time.

I#lJt IObRIS

P/N 134818600(0611)

Cyde Selection continued

A utoma tic Cyde Air Fluff Cycle

Laundry Center Features

,, TOWELS - This setting isbest for towel

loads. Select the REGULAR--HIGH HEAT
temperature setting.

,, REGULAR- This setting isbest for cotton

items. Select the REGULAR--HIGHHEAT
temperature setting.

DELICATES/PERM PRESS- Thissetting is
best for delicate, knit, or perm press items.

Select the PERM PRESS--MEDIUMHEAT
temperature setting for permanent press

items, the KNITS---MEDIUM-LOW
temperature setting for most knit items, or

the DELICATES--LOWHEAT temperature
setting for delicate items.

Occasionally a load may seem too damp or
overdried at the end of the cycle. To
increase drying time for similar loads in the
future, set the cycle selector to the left of the

TOWELS, REGULAR,or DELICATES/PERM
PRESSsetting. For loads requiring lessdrying

time, set the cycle selector to the right.

,, DAMPDRY- This setting isbest for items

you wish to partially dry before hanging or
ironing. Select the temperature setting most

suitable for the load.

WrinMe Rid Cyde

If the dried load cannot be removed promptly
at the end of the cycle, the cycle selector will
automatically advance to the WRINKLE RID
setting when the Automatic Wrinke-Rid
option issetto ON. Unheated tumbling
continues for about 20 minutes to help
reduce wrinkling. If you do not wish to
advance into the Wrinkle Rid cycle from
Automatic cycle, set the Automatic Wrinkle-
Rid option to OFF. TheWrinkle Rid cycle
can also be selected as a separate cycle.

This cycle provides approximately 20 minutes
of tumbling without heat. UseAir Fluff to dry

items containing feathers or down, foam
rubber, plastics, or similarly textured, rubber-
like materials, to freshen clothing, pillows or
blankets, or to dust draperies.

Timed Dry Cycle

This cycle provides up to 90 minutes of drying
time atthe temperature selection of your

choice.

Energy Saving Tips

* Keep the lint screen clean and exhaust the

dryer correctly.

* Sort laundry properly and select proper

temperature and cycle settings. Choose the
Automatic Dry cycle whenever possible for

accurate drying time.
Dry only full loads. Single items and small
loads usually take longer to dry.

* Avoid overloading, adding wet items to a

partially dry load, and overdrying.

* Dry one load after another to take

advantage of a warm dryer.
Opening the door needlessly causeswarm
air to escape,which prolongs drying time.
If possible, usethe dryer on low humidity
days.

* Install the dryer in an area where the room

temperature is at least 45% (7°C).

CONVENIENCE

HANGERN J

DR YING
RA CK _,

SA FETY
DOOR

FIL TER
OPENING

BLEACH
D!SPENSE_

DYNA MIC
BALANCE

SYS TEM

SELF-CLEANING
LINT FILTER

MODEL-SERIAL
NUMBER PLATE

SAFETY LID
LOCK

•FABRIC
SOFTENER

DISPENSER

P/N134818600(061 I)

Washer Operating Instructions

@

WASH/RINSE TE_SPEB£=I/_ RE WATEB LEVEL

WA/_M COLD tOAD
W,qSM COLD

Before Operating Your Washer

Readyour Washer Owner's Guide. It has im porta nt safety

and warranty information. It also has many suggestions for
best washing results.

To reduce the risk of fire, electric shock, or

injury to persons, read the IMPORTANT SAFETY INSTRUC-
TIONS in your Washer Owner's Guide before operating this

appliance.

Operating Steps

Read Washing Procedures in your Owner's Guide. It

explains these operating steps in detail.

1. Sort laundry into loads that can be washed together.

2. Prepare items for washing.

3. Pretreat stains and heavy soil.

4. Addthemeasuredamountofdetergenttowashtub
before adding the laundry load.

5. If desired, add liquid bleach to bleach dispenser. DO

NOT pour bleach directly onto the load.

Printed in U.S.A.

Laundry Center Model 97922/979 72

_4EI}I/JM

I(}A_>

_S, RE<_ES

f_J/,_Y_ s/w/7 PERM PRESS
_WSHm ,;lOs, PREWASH

5. If desired, add liquid fabric softener to fabric
softener dispenser. DO NOT pour fabric softener

directly onto wash load.

7. Add laundry load loosely to wash tub. Dry load
should not be higher than top of agitator vanes.

For best results, DO NOT overload.

8. Select the wash cycle and settings according to type,
size and soil level of each load.

9. Close lid and pull out Cycle Selector knob to start

washer. The washer will fill with water but will not agitate

or spin with the lid open.

To stop the washer, push in the Cycle Selector knob. To

change a cycle, push in the Cycle Selector knob and turn
it clockwise to the desired setting. Pull out the knob to

restart the washer.

10. Remove items at end of cycle. Wait about 2-3 minutes
for safety lid lock to release.

SPIN

Cycle Selection

Push in and turn the Cycle Selector knob clockwise to
the desired cycle, For best results, follow the

washing instructions on the fabric care labels,

The Regular, Perm Press and Delicates cycles progress

through wash agitation, drain and spin with a spray
rinse, rinse agitation, and a spray rinse during the final
spin.

Regular Cyde

This cycle provides up to 15 minutes of normal agitation and

a fast spin for most fabrics.

Extra Rinse Cycle

Use the Extra Rinse cycle after any complete wash cycle

when an additional deep rinse may be needed to remove

excess detergent and soil. It provides 3 minutes of rinse
agitation in cold water, followed by a spray rinse at the
selected rinse water temperature during spin.

If desired, add liquid fabric softener to the rinse water or use
a softener sheet in the dryer. DO NOT pour fabric softener

directly onto the load.

P/N134818600(061 I)