If this griii faiis due to a defect in materiai or workmanship
within one year from the date of purchase, caii 1-800-4MY-HOME® to arrange for
free repair (or replacement if repair proves impossible).
For five years from the date of purchase, the
stainless steel burners will be replaced free of
charge if they rust through. After the first year
from the date of purchase, you must pay the labor
cost to have them installed.
All warranty coverage excludes ignitor batteries,
grill part paint loss, discoloration, and surface
rusting, which are either expendable parts that can
wear out from normal use within the warranty
period, or are conditions that can be the result of
normal use, accident or improper maintenance.
All warranty coverage is void if this grill is ever used for
commercial or rental purposes.
All warranty coverage applies only if this grill is used in the
United States.
This warranty gives you specific legal rights, and you may
have other rights which vary from state to state.
Sears, Roebuck and Co., Hoffman Estates, IL
60179
IF YOU SMELL GAS:
Shut off gas to the appliance.
Extinguish any open flame.
Open lid.
If odor continues, keep away
from the appliance and immediately
call your gas supplier or your fire
department.
AA
• Do not store or use gasoline or other
flammable liquids or vapors in the
vicinity of this or any other appliance.
• An LP cylinder not connected for use
shall not be stored in the vicinity of this
or any other appliance.
Grill Information Center
If you are missing parts, need assistance during
assembly, or have any other questions, please call 1
800-933-0527 between the hours of 8:30am and
5:00pm, Monday through Friday, Central time.
Note that you will be speaking with a representative
of the grill manufacturer and not a Sears employee.
Product Record
IMPORTANT: Fill out the product record
information on below.
119.16433010Model Number
_____________________
Serial Number ______________________
(See silver CSA plate inside of left door)
Date Purchased
A
CAUTION
For residential use only. Do not use for commercial cooking.
A.
California Proposition 65
1. Combustion by-products produced when using this
product contain chemicals known to the State of
California to cause cancer, birth defects, and other
reproductive harm.
2. This product contains chemicals, including lead and
lead compounds, known to the State of California to
cause cancer, birth defects or other reproductive harm.
This outdoor cooking gas appiiance is not intended
to be instaiied in or on boats or recreationai
vehicies.
Liquid Propane Gas (LPG) griiis must be used with
the iiquid propane gas reguiator assembiy suppiied.
This griii is not convertibie to natural gas.
ALWAYS keep the gas hose assembly away from
any heated surface and dripping grease. Avoid
unnecessary twisting of the hose. Visually
inspect the hose prior to each use for cuts,
cracks, excessive wear, or other damage. Do not
use the gas grill if the hose appears damaged.
Call Sears at 1-800-4-MY-HOME®
(1-800-469-4663) for a Kenmore replacement
gas hose assembly.
General Safety
A
NEVER use your gas grill in a building,
garage, porch, shed, breezeway or any
other enclosed area.
NEVER obstruct the flow of ventilation
air around your gas grill cabinet.
DO NOT leave children and pets
unattended in the area when the grill is
in operation.
ENSURE the grill is on a level surface
when in operation. You can adjust the
feet in front to level and stabilize the grill.
NEVER attach an unregulated gas line
to this appliance.
PRE-ASSEMBLY
• Two people will be necessary to assemble the
larger parts of the grill.
. Lay a cardboard sheet on the floor and use as a
work surface to protect floor and grill parts from
scratches.
• Once all parts are removed and unpacked,
use the Hardware and Part Diagrams to ensure al
items are included and free of damage.
El1*ASMC0085-01Cabinet Assembly
E22SE0257Swivel Caster
E31S4025-042D-002Cabinet Door Stop
E42SE0055Swivel Locking Caster
E51*ASMC0085-02Cabinet Toe Plate
E61SE0080-001Regulator and Hose Support Ring
E71SE0290-002Cylinder Support Ring
E82SE0150Magnetic Door Stop
E91*ASMC0085-03Cabinet Front Crossbar
ElO1SE9027-011Condiment Basket
Ell1*ASMC0085-04Cabinet Left Door
E121*ASMC0085-05Cabinet Right Door
E132PLABS0092N-001Cabinet Door Handle
E141*ASMC0085-06Cabinet Back Panel
E151SE0019-001Manual Igniter Stick
E162SE0289-001Door Bottom Pin
E172SE0288-001Door Top Pin
Part No.Description
Qty
Not Pictured
N/A1ASMF085Hardware Pack
N/A1RNA0103Manual
If you are missing hardware or have damaged parts after unpacking griii, caii 1-800-933-0527 for repiacement.
To order repiacement parts after using griii, caii 1-800-4-MY-HOME®.
Parts Diagram 119.16433010
I - '■!
1-.
&
A3 re
i
C-
iB25
B3]
m
D5) 'V
-S3
B14
I 'f
O
m)
m)
M5)
S!)
—(c^
(S
Assembly Instruction
Remove Firebox from Cabinet
□ Cut fastening straps on Cabinet Toe Piate. Remove the Toe Piate and set aside. Cut fastening
straps securing regulator and hose to cabinet.
□ Unscrew and discard the 8 Phillips Head Bolts (M6x35mm) and 8 Washers (M6) from the corner
holes of the cabinet. Remove the crossbar and set aside.
□ With the aid of an assistant, carefully lift the cabinet up from the firebox and set aside. Remove
all foam packing from the Firebox. Raise lid and remove and unpack parts inside Firebox.
Cabinet Front Crossbar
Cabinet Toe Plate
\ .*••*/•**
♦
4
Install Casters to Cabinet
□ Place the Cabinet Assembly upside down and attach the 4 Casters to the bottom using 16 Phillips
Head Bolts (M6xl6mm). Install both locking casters on rear of cabinet.
Phillips Head Bolt M6xl6mm
Qty: 16
•••à.
Swivel Caster
Install Cabinet Toe Plate
□ Attach the Cabinet Toe Plate to the Cabinet Bottom Panel using 4 Phillips Head Bolts
(MBxlOmm).
□ Place cabinet in upright position on casters.
fcfeirWwW
Phillips Head Bolt MBxlOmm
Qty: 4
A
Install Cabinet Doors and Cabinet Front Crossbar
□ Insert the Cabinet Right Door bottom pin into the Cabinet Bottom Panel (Inset 1), and insert the
Cabinet Right Door top pin into the Cabinet Front Crossbar (Inset 2). With door magnets
extending into Cabinet, attach the Cabinet Front Crossbar to the right side of the Cabinet using
2 Phillips Head Bolts (M6x35mm) and Plastic Washers (M6) (Inset 3). Do not fully tighten bolts
at this time.
□ Insert the Cabinet Left Door in the same way and attach Cabinet Front Crossbar to the left side
of the Cabinet using 2 Phillips Head Bolts (M6x35mm) and Plastic Washers (M6). Fully tighten
all 4 Front Crossbar bolts at this time.
Phillips Head Bolts M6x35mm
Qty: 4
.♦I
L
Plastic Washer M6
Qty: 4
Inset 2
t
Inset 1
Inset 3
Hang Condiment Basket and attach Cabinet Door Stop
□ Attach the Cabinet Door Stop to the front of cabinet bottom using 2 Phiiiips Head Boits
(M4x8mm).
□ Hang Condiment Basket on the inside of Cabinet Right Door.
Phiiiips Head Boit M4x8mm
Qty: 2
Cabinet Door Stop
Qty: 1
Attach Firebox to Cabinet
□ With the aid of an assistant, piace the Firebox onto the Cabinet Frame with Reguiator Hose and
Side Burner Ignition Wire hanging inside of Cabinet. Note: Rear of Firebox rests on two tabs at
back of Cabinet.
□ Line up the hoies and attach the firebox to the cabinet frame using 4 Phiiiips Head Boits
(M5xl5mm) and 4 Piastic Washers (M5).
Hint: You may need to siide the Firebox Assembiy forward, backward, or iift siightly for the boit
hoies to properiy iine up.
□ Push the 3 Main Burner Controi Knobs and smaiier Rôtisserie Controi Knob onto Vaive Stems as
shown.
Phiiiips Head Boit M5xl5mm
Qty: 4
Piastic Washer M5
Qty: 4
................................................
,*•* .•* *♦.
A** ' •
•*
* « ■ I
■ ■‘fa *
/\
10
Loading...
+ 21 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.