Kenmore 1163441291, 1163441290 Owner’s Manual

III" I
II ilillil I lillll II lllllii
I
L I
I
IllIIH
I
L
I I I
II II_II 11 _ IIIIIII III IIIIII I I IIII I
III III
III I I I_II I
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
III III
! I III1!
[[I ['111[[I I
III1[[ I I I
III IIIII I
I
I
-I
I I
I
SEARS
Kenmore _Vacuum Cleaner
OWNER'SMANUAL
READTHISMANUAL for important safety,
assembly and operating instructions.
C(_ 1ZJP3(_U_-4369584C
EEE ,ONTENTS
WARRANTY ....... : ...................... I
SERVICE ................................. I
IMPORTANT SAFETYINSTRUCTIONS ....... 2
PARTSAND FEATURES.................... 3
ASSEMBLY........ ...................... 4-5
ATTACHMENTASSEMBLY ................. 5
USE
To Vacuum .............................. 6
How to Select Proper Height for Cleaning .... 6
Using Attachments ....................... 7
Attachment Use Chart .................... 7
Vacuum Storage .......................... 8
Proper assembly and safe use of your vacuom cleaner are your responsibg#ies. Your cleaner is intend-
ed only for household use. The cleaner should be stored in a dry, indoor area. Read this Owner's Manu- al carefully for Iml_ant use and safety information.
VACUUM CARE 8
Bag Changing 9-10
Motor Safety Filter Cleaning ............... I0
Suction Motor Reset ...................... 11
Belt Changing' Brush Changing
and Brush Cleaning ................... i 1-!3
Cleaning Exterior and Attachments ........ 13
Ught Bulb Changing ...................... 14
Clog Removal ..... ........ ............. 15
TROUBLESHOOTING ..................... 16
KENMOREVACUUMCLEANER
FULLONE-YEARWARRANTY
When used for private household purposes, if within one year from the date of purchase, this vacuum
cleaner fails due to a defect in material or workman- ship, RETURNIT TO THE NEARESTSEARSSERVICE CEN-
TER/DEPARTMENTIN THEUNITEDSTATES,and Sears will repair it free of charge.
If this vacuum cleaner is used for commercial or rental purposes, the above warranty coverage
applies for only 90 days from the date of purchase. This warranty gives you specific legal rights, and
you may also have other rights which vary from state to state.
SEARS,ROEBUCKAND CO., D/817 WA,
Hoffman Estates, IL.60179
If you need service or parts, visit your nearest Sears Service Center or the Service Department located at most Sears Retail Stores. They will be able to solve your problem and supply any needed replacement parts. Any service needed other than described in this Owner's Manual should be done by a Sears authorized service representative.
How to Order Repair Parts
When requesting service or ordering parts, have the following information available:
I. Model number.
2. Serial number.
3. Description of problem.
4. Part number.
5. Name of part. EnglishSpeaking:
To Call TollJ:ree For Service:
To CallTollFree ForParts:
Spanbh Speaking: To Call TollFree For'service:
To Call Toll Free For Parts:
(I-800-4-REPAIR) (I-800-473-7247)
(I-800-FON-PART)
(I-800.-366-7278)
(1-800-626-5811) (1-800-659-7084)
EEEE MPORTANTSAFETYINSTRUCTIONS
To reduce the risk of fire, electrical shock, injury to persons or damage when using your
vacuum cleaner, follow basic safety precautions including the following:
Read this manual before assembling or using
your vacuum cleaner.
Use your cleaner only as described in this manual. Use only with Sears recommended
attachments.
To reduce the risk of electrical shock - Do not
use outdoors or on wet surfaces. Disconnect electrical supply before servicing
or cleaning out brush area. Failure to do so could result in electrical shock or brush
suddenly starting.
Always turn qJeaner off before unplugging. Do not unplug by pulling on cord. To unplug,
grasp the plug, not the cord. Do not use with damaged cord or plug. If
cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped
into water, return it to a Sears Service Center/Department.
Do not pull or carry by cord, use cord as a hahdle, close door on cord, or pull cord around sharp edges or corners. Do not run cleaner over cord. Keep cord away from heated surfaces.
Do not leave cleaner when plugged in. Unplug from outlet when not in use and before servicing.
Do not allow to be used as a toy. Close attention is necessary when used by or near
children.
Do not handle plug or cleaner with wet hands.
Do not put any objects into openings. Do not use with any opening blocked; keep
free of dust, lint, hair and anything that may reduce air flow.
Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
Do not use cleaner without dust bag in place. Always change the dust bag after vacuuming
carpet cleaners or fresheners, powders and fine dust. These products clog the bag, reduce airflow and can cause the bag to
burst. Failure to change bag could cause permanent damage to the cleaner.
Do not usethe cleanerto pick up sharp hard objects,smalltoys,pins,paper,etc.They may damage the cleanerordustbag.
Do not pick up anything that isburning or smoking, such as cigarettes,matches, or
hot ashes.
Do not use cleaner to pick up flammable or combustible liquids(gasoline,cleaning fluids, perfumes, etc.),or use inareas where they
may be present. The fumes from these substances can create a firehazard or
explosion. Use extracare when cleaningon stairs.Do not
put on chairs,tables,etc.Keep on floor.
You are responsible for making sure that your vacuum cleaner is not used by anyone unable to operate it properly.
SAliE THESEINSTRUCTIONS
Proper assembly and sate use of your vacuum cleaner are your responsibilities.
Your cleaner isintended only for household use. The cleaner should be stored in a dry, indoor area.
Read this Owner's Manual carefully for important use and safety information.
ANDFEATURES
UPRIGHTVACUUM CLEANER
It is important to know your vacuum cleaner parts
and features to assure its proper and safe use.
Review these before using your cleaner.
COPY YOUR MODELAND SERIALNUMBERSHERE. Copy this information from the bottom of the
vacuum cleaner into these spaces. Keep these
numbers for future reference. If you need service or
.call with a question, have this information ready:
Hose
Quick
Release Cord Hook
Hose
Lower Cord Hook
l_andle
Screw
Port
116.
Model Number
.
Serial Number
Release
Dusting Brush
I
Belt
l In U.S. #2O-5275
In Canada #20-40096
Headlight and Lens (On Some Models) Bulb
h
(Dust Bag Inside) Dust Bag
In U.S. #20-50688 In Canada #20-50680
Filter (Inside Dust Cover)
oot,as oalr
Adjustment Lever
(On Some Models)
Serial Number
Label
Warning
Label
Button
ResetLabel (Seepage t I)
Serial Number
Label
Tool
Short Hose
Wand-_ f ff (On Some _ _k
Models)
Brush
l In U.S. 020-5240
In Canada #20-40600
ATTACHMENTS
_ No
Tabs
/.2-4-- Crevice
Tool
3
Y
HANDLEASSEMBLY
Before assembling your vacuum cleaner, be sure you have all the parts shown on page 3.
ElectricalShockHazard Do notplug into electrical supplyuntilassemblyIs
complete. Failureto do so could resultinelectrical
shock or injury.
Handle
Hooks
Handle Screw and Hole
Handle
Scn_
Back Of I
v-uum°' llI
Remove the handle screw located just below the top
edge of the back of the vacuum, (see illustration above).
Position the handle so the cord hooks are toward the back of the cleaner.
Insert the handle into the opening at
the top of the vacuum.
Align the handle screw in the hole in
the handle and the
handle screw hole inthe back of the
vacuum.
Insert the handle screw so it passes through the back of
the vacuum into the handle.
Begin to tighten the screw with your fingers. It may
be necessary to adjust the handle slightly.
In Vacuum
Using a screwdriver, tighten the screw,
DONOToverlighten.Overtlghteningcould stripthe screwholes.
DONOToperate the cleaner withoutthe screw in place. -..
CORD ASSEMBLY
Make sure the quick release upper cord hook is in the upright position,
Remove the wire fie from
the power
cord, Wrap the power.
cord arour_d the upper
and lower cord hooks,
TTACHMENT
ASSEMBLY
TOASSEMBLE ATTACHMENTS
After the handle has been assembled to th$ body and the power cord has been
wrapped around the cord hooks, the attachments can be assembled,
. The wand can be affached to the
hose by inserting the small end of the
wand into the open end of the hose,
Be sure to align the tabs on the wand with the "J" slots in the hose, Once the wand is
inserted into the hose it should be twisted to the right to lock the tabs into the "J" slots,
2. The wand and hose can then be routed in front of the handle and over the hose support.
3. The wand can then be placed over the end of the short hose, twisting as you push down,
Brush
Tool
4. The dusting brush can be placed in the holder in front of the wand with the brush portion up,
5. The crevicetoolcan be slippeddown intothe holder besidethe wand.
5
Loading...
+ 12 hidden pages