Kenmore 110.C6621*, 110.C6654*, 110.C6655* Quick Reference Guide

Quick Start Dryer Guide

We have taken great care to give your new dryer the most convenient and easy-to-use features. Use this guide to help optimize the use of your dryer. Consult the Use and Care Guide for more detailed instructions. To contact the Sears Service Center, call 1-800-4-MY-HOME® (1-800-469-4663).

Models/Modèles 110.C6621 , C6/7653 , C6654 , C6655

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as gasoline, away from dryer.

Do not dry anything that has ever had anything flammable on it (even after washing).

Failure to follow these instructions can result in death, explosion, or fire.

the door.

Auto Dry Cycle,

•Turn cycle knob to recommended Auto Dry Cycle for type of load being dried.

•Use the Energy Preferred Automatic Setting (*) to dry most heavy to medium weight fabrics.

Timed Dry Cycle.

• Turn cycle knob to a Timed Dry setting. and hold the PUSH TO START button.

WARNING

Fire Hazard

No washer can completely remove oil.

Do not dry anything that has ever had any type of oil on it (including cooking oils).

Items containing foam, rubber, or plastic must be dried on a clothesline or by using an Air Cycle.

Failure to follow these instructions can result in death or fire.

CONTROL

a cycle is complete. permanent press,

synthetics and other items that should be removed from the promptly at the end of a cycle.

the WRINKLE GUARD® feature, the End of Cycle Signal every few minutes. The signal stops when you open the

or turn the Cycle Control knob to Off.

8571692

Continued on back

	FABRIC CARE/ TEMPERATURE		LOAD TYPE	TIMER CYCLE SELECTION	CYCLE
					SETTING*
	HIGH		Heavyweight items - Quilts, towels, jeans,	Timed Dry	50 - 70
			cottons, bedspreads		minutes
	HIGH		Medium weight items - Shirts, sheets, slacks,	Perm Press/Normal	Normal Dry**
			play clothes, cloth diapers
	LOW		Lightweight items - Lingerie, blouses, dresses	Knit/Delicate	Normal Dry**
			synthetics and blends

*Reset time as needed to allow items to dry completely.

**Reset dryness level to More or Less Dry as needed for type of fabric or load size.

the Auto Dry Cycle, the exhaust air temperature of the determines the drying time and dryness levels. A thermostat

the Cycle Control Knob when to move into Cool Down. drying time for an Auto Dry Cycle depends on load type and size. When drying a large or heavy load, the Cycle Control may take a long time before it begins to advance into Cool

. The Auto Dry Cycle takes the guesswork out of drying time enhances fabric care. The amount of time that is displayed is estimated time remaining in the cycle.

Automatic Cycle may be used for most loads. This cycle gives best drying in the shortest time. Drying time varies according

the type of fabric, size of the load, and dryness setting.

is determined by the exhaust temperature of the dryer. the dryness selected is reached, the dryer goes into a

minute (approximately) cool down period.

The Cycle Selector (Timer) Control may be set to NORMAL DRY (*), which is good for most fabrics. At the end of the cycle, you may check the dryness of the load.

If the load is drier than you like, you may select a setting closer to Less Dry the next time you dry a similar load.

If a load is not as dry as you like, you may complete drying using a Timed cycle. You may select a setting closer to More Dry the next time you dry a similar load.

This cycle may be used to get up to 70 minutes of heated drying time. The heating cycle is followed by a cool down period of up to

10 minutes.

Air Dry

You may use the Air Dry cycle to get up to 20 minutes of drying time in room temperature air. This setting should be used for items such as plastics, rubber and heat-sensitive fabrics.

Touch Up

This cycle may be used to help smooth synthetic and permanent press clothes that are clean but wrinkled from being crowded in a closet or suitcase. This setting provides about 15 minutes of heated tumbling followed by a cool down period of up to 10 minutes.

are not removed promptly at the end of a cycle. WRINKLE GUARD® I dryer door.

WRINKLE GUARD® I, the End of Cycle Signal will sound every 5 minutes.

– LONG DRY TIMES, LOAD NOT DRYING you call service...check for the following.

		lint screen clogged with lint?		Is the exhaust vent or outside exhaust hood clogged with lint?
		the lint screen before each load.		• Lint should be cleaned out of the exhaust vent at least once every
				2 years.
				See the Use and Care Guide for complete details.
8571692				6/05

© 2005 Sears Brands, LLC

® Registered Trademark/™ Trademark/SM Service Mark of Sears Brands, LLC

Printed in U.S.A