Kenmore 11079722800, 11079652800, 11079632800, 11079622800, 11069652800 Owner’s Manual

Wehavetakengreatcaretogiveyournewdryerthemostconvenientandeasy-to-usefeatures.Usethisguidetohelpoptimizetheuseofyourdryer.
ConsulttheUseandCareGuideformoredetailedinstructions.TocontacttheSearsServiceCenter,call1-800-4-MY-HOME®(1-800-469-4663).

Models/Modelos 110.7/6962#, 7/6963_, 7/6964#, 7/6965_

Explosion Hazard

Keep flammable materials and vapors, such as
gasoline, away from dryer.

Do not dry anything that has ever had anything
flammable on it (even after washing).

Failure to follow these instructions can result in

death, explosion, or fire.

Clean the tint screen.

Place laundry in dryer.

Shut the door.
Select Auto Moisture Sensing Cycle,

• Turn cycle knob to recommended Auto Moisture
Sensing Cycle for type of load being dried.

• Use Normal Dry to dry most heavy to medium-weight

fabrics.

or Timed Dry Cycle.

• Turn cycle knob to aTimed Dry Setting.

• Select temperature setting using Fabric Care selector.

Select the End of Cycle Signal.

Press and hold the START button.

Fire Hazard

No washer can completely remove oil.
Do not dry anything that has ever had any type of

oil on it (including cooking oils).

Items containing foam, rubber, or plastic must be

dried on a clothesline or by using an Air Cycle.

Failure to follow these instructions can result in

death or fire.

£II/F IYIL£ $1IIAL IIIWRIL

The End of Cycle Signal sounds when a cycle

is complete. This signal is helpful when you are

drying permanent press, synthetics, and other
items that should be removed from the dryer
promptly at the end of a cycle.

The End of Cycle Signal is selectabte. The signal
stops when you open the door or turn the End of
Cycle Signal on the Start button to Off.

Ifthe WRINKLE GUARD _feature is on, the End of

Cycle Signal sounds every few minutes. Ifthe End
of Cycle Signal is turned off, you wilt not hear
WRINKLE GUARD ®sound every few minutes.

\

W10035733A

J

Continued on back

J

FormodelswithaFabricCarecontrolknob,youmayusethiscontroltoselectthedryingtemperaturethatmatchesthefabrics

inyourload.Thefollowingtablelistssuggestedautomoisturesensingortimeddrysettingsforvariousloads.Thisisonlyaguide.

FABRIC CARE/ AUTO MOISTURE TIMED DRY

TEMPERATURE LOAD TYPE SENSING SETTING*

COTTON/TOWELS Heavyweight items - Quilts, towels, More Dry 50-70
HIGH jeans, cottons, bedspreads minutes

NORMAL Medium-weight items - Shirts, Normal Dry 30-50
MEDIUM HIGH sheets, slacks, play clothes, minutes

DELICATE Lightweight items - Lingerie, blouses, Less Dry 20-40
LOW dresses, synthetics, and blends minutes

CASUAL Medium-weight items - synthetics Normal Dry 30-50
MEDIUM (polyester, acrylic), skirts, sweaters, slacks minutes

*Reset time as needed to allow items to dry completely.

cloth diapers

Auto Moisture Sensing

When you are using the Auto Moisture Sensing Cycle,
the dryness of the load is determined by two metal strips

(sensors) located on the inside of the dryer. The metal

strips help "feel" the amount of moisture left in the clothes

as they pass. When there is moisture left in the clothes, the

Cycle Control knob will not advance. As clothes begin to
dry, the amount of water left in the clothes decreases, and
the timer advances through the remainder of the cycle.
When the selected dryness level is reached, the dryer
goes into a cool down period of up to 10 minutes.

Ifthe load is drier than you like, you may select a setting
closer to Less Dry the next time you dry a similar toad. If

a load is not as dry as you like, you may complete drying

using a Timed cycle. You may also select a setting closer
to More Dry the next time you dry a similar load.

Timed Dry

This cycle may be used to get up to 90 minutes of heated
drying time. The heating cycle is followed by a coot down period

of up to 10 minutes.

Air Fluff

You may use the Air Fluff cycle to get up to 30 minutes of drying
time in room temperature air. This setting should be used for

items such as plastics, rubber, and heat-sensitive fabrics.

WRIIRL£ llaBI I

WRINKLE GUARD ®I helps smooth out wrinkles that may form when clothes are not removed promptly at the end of a cycle.

WRINKLE GUARD_ I continuously tumbles the load, without heat, for 40 minutes unless you open the dryer door.

uring WRINKLE GUARD_ I, the End of Cycle Signal will sound every 5 minutes unless the signal is turned off.

J

1

TIIIILESIIITINI - LIII IIY TIMES,LIAI NIT IIYINI

Before you call service...check for the following.

Is the lint screen clogged with lint? Is the exhaust vent or outside exhaust hood clogged with

• Clean the lint screen before each toad. lint?

• Lint should be cleaned out of the exhaust vent at least once
every 2 years.

See the Use and Care Guide for complete details.

W10035733A 8/o8

© 2008 Sears Brands, LLC ® Registered Trademark / TMTrademark / SMService Mark of Sears Brands, LLC Printed in U.S.A.