Kenmore 11068932790, 11068942890, 11068944890, 11068972890, 11068974890 Installation Guide

...

IUN IN. TRU TIONS

for Even Heot Control Board

Disconmict power before servicing. Failure to do so can result in deaUt or electrical shock.

|111 ii i _ I _q _ III El m| " i • ii

Even heat phase one was designed with an AC coil motor relay. Even heat phase two has a DC coil motor relay.When replacing an avert heat phase one control board with this kit, the AC coil

motor relay must be replaced with the motor misy supplied in this kit,

1. Disconnect power or unplug dryer.

2. Remove the end cap trim on each end of the con.

sole.

3. Remove the screws in front of each end cap that

holds the console to the dryer top.

4. Flip console so the backside is facing you. See

Rgure 1.

5. Disconnect wires from the defect_ AC even heat board, part number 3402605, and remove the board.

6. Disconnect the lout (4) wires, two (2) ptnWblack and two (2) light blue, from the defeoUve AC coil motor

-slay, part number 697812, and remove motor m- Ay.

Remove console harness, that connects the rotary

swithes to the contorl board and the heat relay, part

number 3405990,

Cut two (2) pieces of tape on main harness by motor relay. See Figure 1.

c0ml_. B0/_

Electrll:at Shock Hazard

Locate the two (2) pink/black wires from the main harness that were connected to the AC motor relay.

One pink/blaok wire _0nnects to the control Ixiard,

other ;]oe,s into the body m me dryer0Tape the

pink/black wire that goes intot he body of the dryer

_to the main harness, IT WILL NuT _E U_i:u. See

Figure 2.

10.

Install the new DC coil motor relay, part number 3405281, included in this kit..This relay is the same as the DC coil heat relay. Attach the two (2) light

lue wi and th " k/black wire from

tacneo zO_r small terminal on the relay, and the

blue wires c_ be _acheo to eitm_-of the larger terminals. Re-tape the main harness.

11.

Install new DC even heat board, part number

3976594. Connect wires from main harness and timer.

12.

_nsole harness___2art number

39765_0 toe-th-e-€ontmiDoam, hiat relay, and the

rotary swltches.lnntali the aink/hlnrJc wire from t_

CLOllSOleharnA_ to the_remaining connector on the

motor relay,

13.

Flip console into its original position.

14.

Install screws into the end caps.

15.

Attach the trim for the end caps.

R_I

OF_f

RG/L__