Kenmore 11055842401, 11055844401, 11055846401, 11055847401, 11055848401 Installation Guide

...

15.5" (39.4 cm) Pedestal

Pedestal de 15.5" (39,4 cm)

!_!ii'!S:i]ii%iOCiiO!iG(!i!!_,S=iil])ii!i!i!_ii_i!ii!li!iii!!i!!lii!iiGl!!!iii:i!i_i3iiiii_ii!!ii_:Oii(iiil)i['i

Pi_destal de 15.5" (39,4 cm)

i_iii ! i];_ !! ii ! ii];_ iii i];_ _iiil;iiiiiiii_i[]:i ii !i !

Model/Modelo/Modele 110.5584_<

:_ = color number/nemero de color/numero de couleur

(60 cm)

151/2"

(39.4 cm)

8543766 Sears Canada Inc., Toronto, Ontario, Canada M5B 2B8 www.sears.ca

Sears Roebuck and Co., Hoffman Estates, IL 60179 U.S.A. www.sears.com

TABLE OF CONTENTS

FULL ONE=YEAR WARRANTY ON MECHANICAL PARTS For one year from the date of purchase, supptier wilI repair or

replace any of its mechanical parts if defective in materiaIs or workmanship= This pedestal must be installed with the listed

washer or dryer and operated according to the instructions provided in the washer or dryer Use and Care Guide=

Warranty Restriction

If the pedestal is subject to other than private family use and/or used with any other product than those listed in the installation

instructions, the warranty is null and void.

Warranty Service

Warranty service is available by contacting the retailer where the pedestal was purchased. If retailer is not available, please refer to

the Use and Care Guide that came with the washer or dryer that

is installed with the pedestal and contact the service department listed there.

This warranty applies only while the pedestal is in use in the

United States or Canada.

This warranty gives you specific legal rights and you may also have other rights which vary from state to state or province to

province. Warranty terms may vary in Canada.

Product Record In the space following, record your complete model number,

serial number, and purchase date. You can find this information on the model and serial number label, located behind the drawer,

on the side frame of the pedestal. Have this information available to help you quickly obtain

assistance or service. Mode_ number

Serial number Purchase date Save these instructions and your sa_es receipt for future

reference.

PEDESTAL SAFETY

Your safety and the safety of others are very important.

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages.

This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others.

All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."

These words mean:

You can be killed or seriously injured if you don't immediately follow instructions.

You can be killed or seriously injured if you don't follow

instructions.

All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed.

iNSTALLATiON REQUIREMENTS

Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed

here. Tools needed

_, Utility knife _, 1/4"hex-head ratchet or

open-end wrench (leveling legs)

_, %6" hex-head ratchet

(for sheet metal screws) 1/4"nut driver

_, %6" open-end wrench

(for leveling leg Iocknutd}

Parts supplied Remove parts package from pedestal drawer. This package

contains 4, #12 x %" hex head sheet metal screws.

Expmosior_ Hazard

Keep flammable materials and vapors, such as gasoline, away from dryer.

Place dryer at least 18 inches (46 cm) above the floor for a garage installation.

Failure do to so can resumt in death, expmoeion, or fire.

_, Pliers or slip-joint pliers

(for drain and inlet hoses) _, Level _, Phillips screwdriver (drawer

removal) _, Bucket

IMPORTANT: If your washer and dryer are already installed, they must be uninstalled.

If you need to uninstall your washer or dryer, see your Installation Instructions that came with your model for tools required.

Ut_it_stalling "four Washer

Turn off the hot and cold water faucets.

Unplug the power supply cord.

S,ow,y loosen the fil! hoses at the faucets to relieve the water pressure. Use a sponge or towel to absorb the released water.

Remove the hot and cold fill hoses from the back of the

washer. Drain the water from the hoses into a bucket. Squeeze the ears of the drain hose clamp with pliers to open

and slide the clamp down the hose. Disconnect the drain

bucket,hosefrom the washer and drain any water in the hose into a _i !

PulI the washer away from wall so it can be tipped on its

back.

Protect the floor with a large piece of cardboard cut from the

pedestal carton. Lay the washer on its back (make sure that the power suppty cord is not under the washer) so that the

cardboard is under the entire lower back edge of the washer. An additional small amount of water wilI drain out of the

washer when it is tipped back.

NOTE: If dryer and pedestal assembly is located in a garage, 3" (7.6 cm) must be added under pedestal so that dryer is

18" (46 cm) above garage floor=

(30.5cm \\\\

15"

(Z;5'om }

8. Go to "installing the Pedestal" section.

Uninstalling Your Electric Dryer 1, Unplug the power supply cord.

Electrical Shock Hazard

Disconnect power before servicing, Replace aimparts and paneJs before operating. Failure to do so can result in death or electrical shock.

2, Disconnect wiring if dryer is direct wired.

3, PulI the dryer away from the wail enough to loosen the vent

clamp. Loosen the clamp and gently remove the exhaust vent from the dryer exhaust outlet.

4, Disconnect the flexible gas supply line from the dryer. Put a

piece of tape over the open ends of the gas line connection fittings.

5, Pull the dryer away from wall so that it can be tipped onto its

back.

6, Protect the floor with a large piece of cardboard cut from the

pedestal carton, Lay the dryer on its back (make sure that the power supply cord is not under the drye0 so that the

cardboard is under the entire lower back edge of the dryer.

(30.5 cm

12" __

7. Go to "Installing the Pedestal" section,

Pull the dryer away from the wall enough to loosen the vent ciamp. Loosen the clamp and gently remove the exhaust vent

from the dryer exhaust outlet,

Pull the dryer away from wall so that it can be tipped onto its back,

Protect the floor with a large piece of cardboard cut from the pedestal carton, Lay the dryer on its back (make sure that the

power supply cord is not under the drye0 so that the cardboard is under the entire lower back edge of the dryer,

(30.5 cm

15"

6 Go to "Installingthe Pedestal" section, Uninstalling "four Gas Dryer

Washer or Dryer is in its Packaging

Position the packaged washer or dryer close to its final

position, Cut the packaging as follows: Washer: Cut plastic film along dotted cut line around the

base, Do not remove the packaging.

Dryer: Cut carton around top and down corners along dotted

cut lines. Lay all four carton sides on floor. Discard carton top and corner posts.

IMPORTANT: Leave carton bottom underneath dryer.

1, Unplug the power supply cord. 2, Turn off the gas supply.

A, Ca_on sides

Lay washer or dryer on its back, NOTE: When laying the washer on its back, hold the bottom

cap down on the floor, Do not remove the plastic film, corner posts or top cap. These protect the floor and washer back,

When laying the dryer on its back, the floor and dryer back are protected by pieces of the carton.

NSTALLAT ON NSTRUCT ONS

i the screw head and the bottom of the washer or dryer.

Follow these instructions to install the pedestal on a washer or dryer.

5, Partially install the 2, #12 x %" hex head sheet metal screws

in the lower holes. Leave a space of about 3A"(1 cm) between

A B

1, Open pedestal drawer and remove the envelope inside. This

envelope contains 4, #12 x 5/8"hex head sheet metal screws used in step 5.

2, Verify the 4 spacer pads are installed on the top of the

pedestal.

A. Spacer pads

Using a 1/4"nut driver, remove the hex-head screws from both drawer slides and save screws. Remove the drawer from the

slides and set aside. Push the slides back into the pedestal

_j X_ _

C C

A. Washer bottom B. Dryer bottom

C. Install screws

6, Tip the pedestal on its back and move it against the washer

or dryer bottom, Slide the pedestal's keyhole slots over the lower 2 partially installed screws,

7, Position the pedestal toward the front of the washer or dryer

and install the 2 remaining hex-head sheet metal screws, Do not tighten completely,

8, Align the sides of the pedestal so that they are even with the

sides of the washer or dryer, Reach inside the pedestal drawer opening and securely tighten all 4 pedestal screws,

HHHHHHHHHH_

Ifyour washer or dryer has feet installed, remove them, Do

not install the feet that came with a new washer or dryer,

A. Lower screws in keyhole slots

9, Tip the washer or dryer back to its upright position, Remove

and discard packaging including washer's plastic film, corner

posts and top cap, 10 Slide the washer or dryer close to its final location, 11, Follow the Installation Instructions that came with your model

to finish installing or reinstalling your washer or dryer (hoses,

vents, etc,),

12,Levelthewasherordryerfromsidetosideandfronttoback.

NOTE:Makesureall4pedestalfeetareinsolidcontactwith thefloor.

PlaceaIeve!onthetop.Locatethe1/4"hex-headscrewson thetopofeachpedestalfoot.Reachinsidethepedestaland

usea1/4"hex-headratchetoropen-endwrenchtoadjustthe feetupordownasneededtolevelthewasherordryer.

13,Whenthewasherordryerislevel,usea%d'open-end

wrenchtosecurelytightenall4Iocknutsagainstthepedestal. TheIocknutsmustbetightenedtoperventvibration.

A .....................

A.Locknuts

14, Pull both drawer slides out and reassemble the drawer to the

drawer slides with the 2 hex-head screws, Use of the dividers is optional. See "Pedestal Use" section. Close the drawer.

PEDESTAL USE

Your pedestal has several uses_

The drawer may be used to store detergent and other laundry

supplies and is equipped with removable dividers.

The shelf will support a laundry basket to assist with loading and

unloading of the washer and dryer.

The shelf can be hooked to the front of the drawer to open together in one step. The shelf can also be stid front to back or

removed,

The shelf is equipped with a removable compartment to store

dryer sheets in.

O000000

°°22 _

oooooooo

+ 14 hidden pages