Kendall Howard 7000-3-5xx-00 User Manual

4

DISCLAIMER: Kendall Howard LLC. endeavors to make this manual accurate and com­plete. However, Kendall Howard LLC makes no representations or warranties of any
kind, expressed or implied, about whether the use of products contained herein would
infringe any rights or the correctness, accuracy or reliability of the information contained
herein or that said information covers all details, conditions or variations. The information
herein does not provide for every possible contingency in connection with the installation
or use of the product(s). The information contained in this document is subject to change
without notice or obligation. Kendall Howard LLC assumes no responsibility for the
accuracy, completeness or reliability of the information contained in this document. Any
re l i anc e pla c ed on the i nfor m ati o n is t h ere f ore s tric t ly a t you r own r isk.

For details about product warranty, please visit www.kendallhoward.com

Instruction s / Dire ctions

Performance Plus Accessory Bar

# 7000-3-5XX-00 (XX = Length)

1

IN N OV A TO R S I N P ROD UCT DE SIG N

w w w . k e n d a l l h o w a r d . c o m

A d d r e s s : 1 0 1 5 2 L i b er t y L a n e
C h i s a g o C it y , M i n n e s o ta , 5 5 0 1 3
U n i t e d St at e s o f A m er ic a
P h o n e : 6 5 1 - 2 1 3 - 1 33 3
F a x : 8 0 0 - 4 1 8 - 6 89 7

Tools Needed:

Included:

2

Screw Driver

Wrench 7/16in

(4x) Nut 1/4 - 20

(4x) Flat Washer 1/4in

(4x) Bolt 1/4 - 20 x 2in

(2x) Mounting Brackets

(1x) Accessory Bar

Assembly - Step 1:

Assembly - Step 2:

3

Slide both Mounting Brackets on either end of Accessory Bar.

Install Bolts through Mounting Bracket into desired position on

upright. Install Flat Washers and Nuts from backside.

Use Screw Driver and Wrench to secure hardware.