Kendall Howard 5500-3-100-60 User Manual

4

DISCLAIMER: Kendall Howard LLC. endeavors to make this manual accurate and com­plete. However, Kendall Howard LLC makes no representations or warranties of any
kind, expressed or implied, about whether the use of products contained herein would
infringe any rights or the correctness, accuracy or reliability of the information contained
herein or that said information covers all details, conditions or variations. The information
herein does not provide for every possible contingency in connection with the installation
or use of the product(s). The information contained in this document is subject to change
without notice or obligation. Kendall Howard LLC assumes no responsibility for the
accuracy, completeness or reliability of the information contained in this document. Any
reli a n c e p l a ced on th e i n f o rmation is t h e r e fo re stric t l y a t your ow n r i s k .

For details about product warranty, please visit www.kendallhoward.com

Assembly - Step 4:

.

a. Secure female Hinges to the Cable Enclosure Bottom with the

M5x10 Screws. Make sure the hole openings are face to­wards each other.

b. Secure 1 Male Hinge to Cable Enclosure Door Bottom with

the M5x10 Screws. Insert should be facing to the outsides of
the door

c. Insert the installed male hinge into the female hinge. Take

the remaining male hinge and insert into the opposing female
hinge and secure to the door with the M5x10 Screws

Instructi on s / Directi on s

Training Table Cable Management Enclosure

# 5500-3-100-60

1

INN O V A TO RS I N PR OD UC T DE S IGN

w w w . k e n d a l l h o w a r d . c o m

A d d re s s : 1 0 15 2 Li be r t y L a n e
C h i sa g o C i t y , M i n n e s o t a , 5 5 0 1 3
U n i te d St a t e s o f A m e r i c a
P h o n e : 651- 213- 1333
F a x: 800- 418- 6897

Tools Needed:

2

Screw Driver

(1x) Left End

(11x) 1/4-20 Screw

(8x) M5x10 Screw

(1x) Right End

(2x) Male Hinge

(2x) Female Hinge

(1x) Bottom

(1x) Door

(2x) Lock Base

Included:

Assembly - Step 1:

Secure right and left ends to the bottom of the

Cable Management Enclosure with 1/4-20” screws

Assembly - Step 3:

3

a. Detach the modesty panel from the leg kit
b. Remove screws from the rear leg kit that fasten it to the table

top
c. Slide the Cable Enclosure around the modesty panel
d. Re insert screws securing the modesty panel and cable en-

closure to the leg kit.

Secure the lock base just behind the grommet opening with the

1/4”-20 screws

Assembly - Step 2: