Kendall Howard 5500-3-100-01 User Manual

Assembly - Step 4:

Select the appropriate adapter from the chart in step 3.
Snap jack into adapter following the instructions provided with the
jack.
Once assembled, snap adapter into the notched, square holes in
the orientation shown.

Instructions / Directions

Power/Data Conversion Kit

#5500-3-100-01

For details about product warranty, please visit www.kendallhoward.com

DISCLAIMER: Kendall Howard LLC endeavors to make this manual accurate and com­plete. However, Kendall Howard LLC makes no representations or warranties of any
kind, expressed or implied, about whether the use of products contained herein would
infringe any rights or the correctness, accuracy or reliability of the information contained
herein or that said information covers all details, conditions or variations. The informa­tion herein does not provide for every possible contingency in connection with the in­stallation or use of the product(s). The information contained in this document is subject
to change without notice or obligation. Kendall Howard LLC assumes no responsibility
for the accuracy, completeness or reliability of the information contained in this docu­ment. Any reliance placed on the information is therefore strictly at your own risk.

4

w w w . k e n d a l l h o w a r d . c o m

IN NO VA T O R S IN P RO D U C T DE SI GN

A d d r e s s : 1 0 1 5 2 L ib e rt y L a n e
C h i s a g o C i t y , M i n n e s o t a , 5 5 01 3
U n i t e d S t a t e s o f A m e r ic a
P h o n e : 651- 213- 1333
F a x : 800- 418- 6897

1

Included:

(1) Voice/Data Adapter Kit

Assembly - Step 1:

(1) Power/Data Center

Assembly - Step 2:

Slide the Power/Data Center
through the grommet. Be sure
the power supply/
communication cable is free to
move up & down with the power
center.

To remove the Power/Data
Center—Slide the Power/Data
Center to its upright position,
squeeze the sides of the power
center close to the grommet
and lift the power center out of
the grommet.

Assembly - Step 3:

Place hook on the bottom of the cap under the front edge of
the power center and slide toward rear.

Tap down on the top of the cap to lock in place on the power
center. To remove the cap, pry up on the back edge of the
cap.

2

Select appropriate adapter plate to fit with your preferred connectors

3