Kendall Howard 5500-3-100-00 User Manual

4

DISCLAIMER: Kendall Howard LLC. endeavors to make this manual accurate and com­plete. However, Kendall Howard LLC makes no representations or warranties of any
kind, expressed or implied, about whether the use of products contained herein would
infringe any rights or the correctness, accuracy or reliability of the information contained
herein or that said information covers all details, conditions or variations. The information
herein does not provide for every possible contingency in connection with the installation
or use of the product(s). The information contained in this document is subject to change
without notice or obligation. Kendall Howard LLC assumes no responsibility for the
accuracy, completeness or reliability of the information contained in this document. Any
reli a n c e p l a ced on th e i n f o rmation is t h e r e fo re stric t l y a t your ow n r i s k .

For details about product warranty, please visit www.kendallhoward.com

Instructi on s / Directi on s

Training Table / Ganging Kit

# 5500-3-100-00

1

INN O V A TO RS I N PR OD UC T DE S IGN

w w w . k e n d a l l h o w a r d . c o m

A d d re s s : 1 0 15 2 Li be r t y L a n e
C h i sa g o C i t y , M i n n e s o t a , 5 5 0 1 3
U n i te d St a t e s o f A m e r i c a
P h o n e : 651- 213- 1333
F a x: 800- 418- 6897

Tools Needed:

2

(16 ) Screws

Included:

Screw Driver

(2) Ganging Plates

Assembly - Step 1:

3

Line up ganging plates with pre-drilled holes on the under-

side of the front and rear of the training table(s).

Secure with included screws to join the two tables together.