Kendall Howard 5000-3-40x-xx User Manual

KENDALL HOWARD

Assembly and Maintenance Manual

Workbenches LAN Stations

And Accessories

Y our New Performance
Workstation

Congratulations on your new Kendall Howard Performance LAN Station
Workbench. This manual will step you through the assembly process. If you have
trouble, please feel free to call our customer service department from 8:30 AM to 5:30
PM CST.

Step 1. Inv entory

Please be sure that you unpack the crate completely and take a complete inventory of
what you have received. This will save you much time if parts are missing and you
have to stop in the middle of the build process. We take every precaution to ensure
that you do receive all parts required; however accidents do happen in shipping that
may cause the loss of a key part. If you suspect that you are missing parts, please
contact our customer service department immediately at 651-340-1400. You will need
to have your order confirmation number before you call.

PART QTY

Levelers 4

Table Sides (1 left, 1 right 2

Cross Bars 6

Upper Shelf Supports 4

Upper Shelf Channels 2

Lower Shelf 1

Upper Shelf 2

Work Surface 1

Cable Tray/Back Support 1

PART QTY

¾” Round Plastic End Cap 16

1 ½” Square Plastic End Cap 4

1 ½” x 2” Rectangle End Cap 4

Channel Nut 8

1 ½ Hex Drive Bolt 16

2 ½” Hex Drive Bolt 4

T-Handle Hex Wrench 1

Cross Head Screw 12 (24”)

15 (48”), 24 (72”), 30 (96”)

Step 2. Assemble the Upper Shelves

Place the upper shelves so that the hardware inserts are facing up. Next, place one of
the cross bars on the shelf lining up the holes on the shelf with the brackets on the
cross bar. Insert (2) cross head screws but
notice a small gap between the bracket and the shelf. This was designed so that after
the bench is assembled, you will tighten all the cross head screws which will pull the
shelf down tight against the frame.

With the shelves still in the same position as in step 2, place a left and a right shelf
support on the shelf and attach with (2) 1 ½ Hex Drive Bolts.

DO NOT FULLY TIGHTEN. You will

Step 3. Assemble the Work Surface

With the work surface placed with the hardware inserts facing up, attach 2 cross bars to
the shelf with (4) cross head screws but DO NOT FULLY TIGHTEN. You will
notice a small gap between the bracket and the shelf. This was designed so that after
the bench is assembled, you will tighten all the cross head screws which will pull the
shelf down tight against the frame.

Step 4. Assemble the Lower Shelf

Place the lower shelf so that the hardware inserts are facing up. Next, place two of the
cross bars on the shelf lining up the holes on the shelf with the brackets on the cross
bar. Insert (4) cross head screws but
notice that one of the crossbars will overlap the shelf. This feature will be used if you
purchased the bottom add-on shelf.

DO NOT FULLY TIGHTEN. You will

5