Kemper GUH User Manual

WP BAKERYGROUP

GUH AROMAT 1/2

Semi-automatic Retarder Proofer
GUH AROMAT

Temperature range -20/+15 °C or -20/+20 °C
Moisture range approx. 65–95 % rel. hum.
Output from 92 to 928 kg dough pieces per batch

Semi-automatic Retarder Proofer of the series GUH AROMAT assist aroma formation in dough pieces and improve the
quality of the products through optimum long-time control. The complete product range is ready for proofing as soon as
work starts. The Werner & Pfleiderer air guidance system, specially designed for dough pieces, together with the high
relative humidity and the adjustable air speed are a guarantee for an optimum flavour development of the products
for proofing. The systems are fitted with dough resting and ripening process control. Temperature and moisture climates
ensure that the products run on an aroma line within the plus range and achieve a surprisingly aromatic result.

Semi-automatic Retarder Proofer 29.04.2009

+

0

-

Cooling

aroma line

Storage

Defrosting

-20 / +15/ +20 °C

Technical Details

Dimensions

Cells are constructed from standard panels
WP offer customised GUH AROMAT systems for individual bakeries

Cell casing

Panels with 80 mm PU insulation, foamed, freed of CFCs, HCFCs and HHCs

k value

0.24 W/m2K

Surfaces standard finish

Inner walls, outer walls,
cell front in sheet steel,
galvanised, white, RAL 9002

Optional stainless steel panelling for all surfaces

Advantages

– Efficient working and division of labour
– Shifts working hours from night to day time
– Goods are ready to bake in the early morning
– Optimum use of oven capacity
– GUH AROMAT supports flavour development

in the dough pieces

– Improvement in product quality

All details non-binding. Subject to change in the course of technical progress. All rights reserved. ® = registered trademark

WP BAKERYGROUP

WERN ER & PFLE IDERE R Koeling Benelux B.V. Industrieterrein 9 D . 5981 NK Panningen . Netherlands

Fon [phone] . Fax [phone] . [e-mail] . www.wp-bakerycooling.com

WERN ER & PFLE IDERE R Lebensmitteltechnik Kälte GmbH . von-Raumer-Straße 8-18 . 91550 Dinkelsbühl . Germany .
Fon [phone] . Fax [phone] . [e-mail] . www.wp-l.de

GUH AROMAT 2/2
Semi-automatic Retarder Proofer 29.04.2009

GUH AROMAT

System

Tongue and groove system with foamed-in eccentric turnbuckle joints for easy,
fast assembly on site.

Floor

The TECFLOOR System floor has 80 mm thick PU insulation with direct
foamed-on 0.8 mm thick stainless steel panel.
Mounted on this is a 3mm thick stainless steel base plate in the form of a trough with raised sides.

Ram Protection

Inside all-round stainless steel square profile 40 x 120 mm

Doors

Optional as rotating door or sliding door(s) with clear dimensions of 73/90/100/120 x 200 cm or double wing doors
with clear dimensions of 143/150/178/200 x 200 cm.

Per rotating door

– 3 door hinges, rising
– Solid press lever fastening for commercial use
– Ram protection inside and out
– Door seal
– Multiple rubber abrasive for floor seal

Optional electrical operation of sliding doors

Technology

The performance of the cooling system is matched exactly to the feed
volume taking into account loads per hour or per batch.

Air Guidance

To achieve more gentle storage of the dough pieces, the cold air is fed into the room via a lowered stainless steel
ceiling and a removable stainless steel guidance system, i.e. it is not blown directly over the dough pieces. Stainless
steel rails are mounted at a distance to the wall in the air intake and blow-out areas. The cold air is blown out on
one side of the cell and is fed back slowly over the cooling products to the vaporizer.

Control system

By WP-MCS4 computer
– built into the door or in a cassette on the cell wall
– Complete with control cabinet above the door
– Very easy operation by menu navigation (5 keys)
– Fully automatic proofing delay program
– Control cabinet pre-wired to VDE standards
– Computer control is installed at the correct ergonomic height
– Computer control is easy to understand and operate

Equipment

– Machine switch
– Soft start
– Oil sump heating
– Pressure controlled, speed-controlled condenser for energy-saving operation
– Low noise, separate condensers (< 56 dB) or quiet rollers (< 38 dB) as optional features
– All necessary safety features