Kelvinator KSV53HRB, KSV35HRB, KSV80HRB, KSV70HRB, KSV62HRB Installation Manual
...
Inverter Split-type Room Air Conditioner
Installation Manual
KSV26HRB, KSV35HRB, KSV53HRB,
KSV62HRB, KSV70HRB, KSV80HRB
Refrigerant R410A
warning
Do not install yourself.
Incorrec t installation could c ause injury due to fire,
electric al shock, the unit fa lling or leakage of water.
Consult the d ealer from whom you purch ased the
unit or author ised installer.
Perform the in stallation secur ely referring to the
installation instruction.
Incorrec t installation could c ause a personal injur y
due to fire, elect ric shock, the unit f alling or leakage
of w ater.
Install the u nit securely in a plac e which can bear the
weight of the u nit.
If installed i n a structurally u nsound location, the u nit
could fall causing injury.
Perform ele ctrical work accord ing to the installatio n
manual and b e sure to use a dedicated ci rcuit.
If the capaci ty of the power circui t is insufficient or
there is incom plete electrical w ork, it could result in a
fire or an elect ric shock.
Use the speci fied wires to connec t the indoor and
outdoor uni ts. Securely atta ch the wires to the
terminal boa rd connecting sec tions so the stress of
the wire is not ap plied to the section s.
Incorrec t connection and fix ing could cause a fire.
Check that th e refrigerant gas do es not leak after
installatio n is complete.
Leak refriger ant could be a hazard to heal th and the
environment.
Unit may not per form to full capacit y and life of unit
may reduce.
Be sure to use the pa rts provided or spe cified parts
for the insta llation work.
The use of defec tive parts cou ld cause an injury du e
to a fire, electr ic shock, the unit falli ng etc.
Perform the dr ainage/piping work acc ording to the
installation instruction.
If there is a defec t in the drainage/pip ing work, water
could leak from t he unit and household g oods could
get wet or be damag ed
Operating temperature
Cooling Mode
Indoor
Outdoor
Max. Min. Max. Min.
32°C 17°C
50°C 18°C
Heating Mode
Indoor Outdoor
Max. Min. Max. Min.
27°C 17°C 34°C -15°C
Note: Optimum performa nce will be achieved within these
operating temperatures.
Please read the user ma nual before installation and caref ully
store in a handy place fo r later reference. Inside you will
find many helpful hint s on how to install and test the air
conditioner properly.
Electrical w ork must be performed by a li censed electrician.
Be sure to use the corre ct rating of the power plug and main
circuit for the mod el to be installed.
Incorrect in stallation due to ignoring of the in struction will
cause harm or da mage, and the seriousness is cla ssified by
the following indications.
Meanings of symb ols used in this manual are shown belo w:
warning
This symbol indicates information concerning your
personal safety
caution
This symbol in dicates information on how to avoid
damaging the appliance
tips and information
This symbol in dicates tips and information a bout
use of the applia nce
environmental tip
This symbol in dicates tips and information a bout
economical and ecological use of the appliance
This symbol in dicates never to do this
This symbol in dicates always do this
Important safety instructions
2 Contents Kelvinator Air Conditioning
Congratulatio ns and thank you for choosing our Inver ter
split-type roo m air conditioner. We are sure you will find
your new air conditio ner a pleasure to use. Before you use
the air conditione r, we re commend that you read through
the entire user man ual, which provides the descri ption of
the air conditioner and its functions.
To avoid the risks that are alway s present when you use an
electric al appliance, it is important t hat the air conditioner
is installed cor rectly and that you read the safe ty instructions
carefully to avoid misu se and hazards.
We recommend that you kee p this instruction book let
for future referenc e and pass it on to any future owner s.
After unpack ing the air conditioner please c heck it is not
damaged. If in doubt , do not use the air conditioner bu t
contact your l ocal Electrolux Custom er Care Centre.
environmental tip
Information on disposal for users
• Most of the pac king materials are recyclable.
Please dispose of t hose materials through your loca l
recycling dep ot or by placing them in appropriate
collection containers.
• If you wish to disc ard this air conditioner, please contac t
your local autho rities and ask for the correc t method
of disposal.
caution
• The air condit ioner is not intended for use by young
children or infirmed persons without supervision.
• Young children should be su pervised to ensure that th ey
do not play with the air c onditioner.
• Contact a n authorised installer for in stallation of this unit.
• Contact a n authorised service te chnician for repair or
maintenance of this uni t.
• If the power cord is to b e replaced, replacement work
shall be performed by authorised personnel only.
• Installatio n work must be performed i n accordance
with the national w iring Standards by authorised
personnel only.
Conditions of use
This appliance is in tended to be useed in household an d
similar applications such as:
• Staff kitchen are as in shops, offices and other wo rking
environments
• Farm houses
• By clients in hotels, motel s, and other residential
type environments
• Bed and breakfas t type environments
Safety instructions
Warning .........................................................................................3
Caution ..........................................................................................3
Installation instructions
Select the rig ht place for installation .........................................6
Indoor unit installation ................................................................9
Outdoor unit installation ...........................................................10
Refrigerant pipe connection ...........................................10
Electrical work .................................................................15
Air purging
Air purging with va cuum pump ................................................18
Safety and leaka ge check .........................................................19
Test running.....................................................................19
Congratulations Contents
Kelvinator Air Conditioning Important safe ty instruc tions 3
Kelvinator Air Conditioning typical installation 54 before installation Kelvinator Air Conditioning
caution
• Use a stud nder to loc ate studs to prevent
unnecessa ry damage to the wall.
• A minimum pipe run o f 3 metres is required to
minimise vibration & excessive noise.
• Two of the A, B and C directio ns should be free
from obstructions.
• This illustrati on is for explanation purposes o nly.
• Copper lines mus t be insulated indepen dently.
KSV26HRB
KSV26HRC
KSV35HRB
KSV35HRC
KSV53HRC
KSV62HRC
KSV70HRB
KSV70HRC
KSV80HRC
INDOOR
Remote control
(Including Holder)
1 1 1
Battery
2 2 2
Tubing plug
1 1 1
Self-tappin g Screw
ST4.2*25 TA
5 10 10
Manual
1 1 1
OUTDOOR
Drainage plug
- 3 3
Drainage Joint and seal
1 1 1
Before Installation Typical installation (shows minimum clearances required for ef fective operation and access
for service and maintenance)
Tools needed for installation
Level gauge
Screwdriver
Electric dri ll, Hole core drill ( 65mm)
Flaring tool set
Specified torque wrenches: 1.8kgf.m,
4.2kgf.m, 5.5kgf.m, 6.6kgf.m
(different dep ending on model No.)
Spanner (half union)
Hexagonal wrenc h (4mm)
Gas-leak detec tor
Vacuum pump
Gauge manifold
Users manual
Thermometer
Multimeter
Pipe cutter
Measuring tape
Items required for installing the unit
Number Name of Accesso ries Qty
1
Installation Plate 1
2
Clip Anchor 8
3
Self-tappin g Screw A 8
4
Seal (See page 8 for d etails) 1
5
Drain Joint (See p age 8 for details) 1
6
Connecting
pipe Assembly
Liquid
Side
φ
6.35
Parts
you must
purchase
(A minimum
pipe wallthickness
of 0.7mm
is required.)
φ
9.52
(<3.5k W mode l)
Gas
Side
φ
12.70
(>=3.5kW mo del)
7
Remote control 1
Note: Excluding the parts that a re provided with the unit
detailed above all other pa rts must be purchased
separately.
Pipes needed for installa tion (Purchase separately according
the following table).
Diameter
2.6kW 3.5kW&5.3kW >=6.2kW
6.35mm
Yes Yes No
9.35mm
Yes No Yes
12.7m m
No Yes No
16.0 mm
No No Yes
Yes: Pipe needed on model. No: Pipe not n eeded on model.
Loop the
connective
cable.
Air Outlet
15cm clearance
2
1
3
6
7
2.0m below
60cm above
Air Filter
30cm left
12cm right
30cm behind
60cm right
2.0m front
A
B
C
12cm left
• Ens ure that the clearance around the ba ck of the unit
is more than 30c m and more than 30cm on the lef t side.
The front of the unit s hould have more than 2.0m
of clearance and th e connection side (right side) sho uld
have more than 60c m of clearance.
• Do not p lace animals and plants in the path of t he air
inlet or outlet.
• Take the air condi tioner weight into account and sele ct
a place where noise an d vibration will not be an issue.
• Sel ect a place so that the warm air an d noise from the
air conditioner d o not disturb neighbours.
Rooftop installation
• If th e outdoor unit is installed on a roof s tructure, be sure
to level the unit.
• Ens ure the roof structure and an choring method are
adequate for the uni t location.
• Co nsult local codes regarding roo ftop mounting.
• If th e outdoor unit is installed on roof s tructures or
external walls, t his may result in excessive noise and
vibration, and may al so be classed as a non servic eable
installation.
Tools needed for ins tallation
• Level ga uge
• Screwd river
• Elec tric drill, Hole core drill (65mm)
• Flaring to ol set
• Sp ecied torque wrenches: 1.8kgf.m, 4.2kgf.m, 5.5kgf.m,
6.6kgf.m (different d epending on model No.)
• Spann er (half union)
• Hexago nal wrench (4mm)
• Gas-l eak detector
• Vacuum pu mp
• Gauge man ifold
• User ma nual
• Thermometer
• Multimeter
• Pipe cu tter
• Measuring
Installation instructions Piping length elevation
Select the r ight place for in stallation
Read completely, then follow s tep by step.
Indoor unit
More than 15cm clearance
More than
12cm
More than
12cm
More than 2.0m
• Do not ex pose the indoor unit to heat or steam.
• Sel ect a place where there are no obs tacles in front
or around the unit.
• Make su re that condensation drainag e can be
conveniently routed away.
• Do not i nstall near a doorway.
• Ens ure that the space on the left and r ight of the unit
is more than 12cm.
• Us e a stud nder to locate studs to pre vent unnecessary
damage to the wall.
• Th e indoor unit should be installe d on the wall at
a height of 2.0m or more f rom the floor.
• Th e indoor unit should be installe d allowing a minimum
clearance of 15cm from t he ceiling.
• Any v ariations in pipe length will/may req uire adjustment
to refrigerant ch arge.
• Th ere should not be any direct sunligh t. Otherwise,
the sun will fade th e plastic cabinet and affec t its
appearance. If unavo idable, sunlight prevention should
be taken into consideration.
Outdoor unit
More than 2.0m
More than 30cm
More than 60cm
More than 30cm
• If an a wning is built over the outdoor unit to pre vent
direct sunligh t or rain exposure, make sure that heat
radiation from the c ondenser is not restric ted.
6 Installation instructions Kelvinator Refrigeration Kelvinator Refrigeration piping length elevation 7
Capacity
Piping
Standard
Length(m)
Max.
Length
B (m)
Max.
Length
A (m)
Additional
Refrigerant
(g/m)
Gas Liquid
2.6kw
3/8”
9.53mm
1/4”
6.35mm
5
8 20 20
3.5kw
1/2”
12.7m m
1/4”
6.35mm
5
8 20 20
5.3kw
1/2”
12.7m m
1/4”
6.35mm
5
10 25 20
6.2kw
5/8”
16.0 mm
3/8”
9.53mm
5
10 25 40
7.0 kw
5/8”
16.0 mm
3/8”
9.53mm
5
10 25 40
8.0kw
5/8”
16.0 mm
3/8”
9.53mm
5
10 25 40
Piping lengt h under 5m Piping lengt h of 5m or more
caution
Capacity i s based on standard length a nd maximum
allowance len gth is on the basis of reliabilit y.
Oil trap should b e installed every 5~7 metres.
When the conn ecting pipe is longer tha n 5 metres,
additional re frigerant should be added i nto the unit
according to the ab ove table through the service p ort
on the “LO” valve on the outdo or unit.
Loading...