Kelvinator KCFH43B User Manual
OPERATING AND INSTALLATION MANUAL
CHEST FREEZER
GB
KCFH 43 B
Make sure that the power plug is not squashed or damaged by the back of the fridge/freezer.
- A damaged power plug may overheat and cause a fire.
Do not place heavy articles or the fridge/freezer itself on the power cord.
- There is a risk of a short circuit and fire.
Do not remove the power cord by pulling on its lead, particularly when the fridge/freezer is being pulled out of its niche.
- Damage to the cord may cause a short-circuit, fire and/or electric shock.
- If the power cord is damaged, it must be replaced by a certified service agent or qualified ser vice personnel.
If the power plug socket is loose, do not insert the power plug.
- There is a risk of electric shock or fire.
REFRIGERANT
Your appliance contains an environmental friendly gas called isobutane (R600a) as refrigerant which is nevertheless flammable. During transportation and installation of the appliance, be sure that none of the components of the cooling circuit become damaged. If any part of the cooling circuit damaged: avoid naked flames and sources of ignition; thoroughly ventilate the room in which the appliance is installed.
DISPOSAL
Appliance Packaging Information All materials are environmentally sound! They can be dumped or burned at an incinerating plant without danger!
About the materials: The plastics can be recycled and are identified as follows:
>PE< for polyethylene, e.g. the outer covering and the bags in the interior.
>PS< for polystyrene foam, e.g. the pads, which are all free of chlorofluorocarbon.
The carton parts are made from recycled paper and should be disposed of at a waste-paper recycling collection location. Disposal of old
Appliances For environmental reasons, refrigaration appliances must be disposed of properly. This applies to your old appliance, and -at the end
of its service life- for your new appliance as well.
Warning! Before disposing of old appliances make them inoperable. Remove plug from mains, sever the power cable, remove or
destroy any snap or latch closures. This eliminates the danger that playing children lock themselves into the appliance (danger of
suffocation!) or place themselves into other life-endangering situations.
Disposal
The appliance may not be disposed of with domestic waste or bulky refuse. The refrigerating circuit may not be damaged. Information concerning collection schedules or locations can be obtained from the disposal authorities or town hall.
The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could other wise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your
household waste disposal service or the shop where you purchased the product.
POSITION
Place the freezer horizontally on a firm surface, resting on all four plastic feet. Use a wooden block or similar object to compensate for any bumps/holes in
the surface. The room should be dry and adequately ventilated. Temperatures of the external environment have an impact on the energy consumption of the device. Therefore: do not put the device to a place exposed to sunshine ore besides a radiator or oven, put it to a place where the
temperature of the environment corresponds to the climatic classification for which the device was designed.
Climatic classification Ambient temperature limits
SN from +10°C to +32°C
N from +16°C to +32°C
ST from +18°C to +38°C
T from +18°C to +43°C
If the freezer has been handled standing on end it should be allowed to stand in normal position
for about 12 hours before switching it on. Please ensure that when the appliance is installed it is
easily accessible for the engineer in the event of a breakdown.
ELECTRICAL REQUIREMENTS.
Before switching on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate, located inside the lid.
Warning: This appliance must be earthed.
this appliance complies with the following EC Directives:
- 73/23/EEC of 19. 02. 1973 - Low-Voltage Directive
- 89/336/EEC of 03. 05. 1989 (including Amendment Directive 92/31/EEC - EMC Directive.
Some of the models are not available in all countries. Testing has been carried out in accordance with ISO 5155 regarding the determination of
freezer capacity, energy consumption and hold-overtime. Information for test institute: A plan of the positioning of test packages may be obtained
directly from the manufacturer.
SWITCHING ON FREEZER BOX
Close top of freezer box installed in accordance with specifications down then connect equipment with mains as specified above. At this time
electric components inside will be energised. Adjust knob of temperature regulator in centre with rotating clockwise. After a weak clicking cooling compressor will start together with slight vibration and noise.
2
TEMPERATURE CONTROL
The thermostat ensures that the required temperature is maintained in the freezer. Turning the thermostat button
towards
“”makes the temperature in the freezer colder, and turning the button towards “”makes the tem-
perature warmer. The correct setting can be found by measuring the temperature of the top package in the middle
of the freezer. This should not have a temperature higher than –18°C.
OPENING/CLOSING THE LID
The lid is fitted with a tightly closing sealing strip to prevent moisture getting inside the freezer and increasing the amount of frost formed. When
the lid is opened the air inside the freezer becomes slightly warmer and expands. As soon as the lid is closed again the air is cooled immediately. This may lead to the creation of a vacuum which makes it hard to open the lid immediately after it has been closed. This is quite normal.
Wait a few minutes until the vacuum has disappeared, then open the lid by pulling gently. Never pull the handle violently.) Top has closed and
opened position. Movement over open position of top (about 95°) can cause damage.
FREEZING
It is important that fresh food placed in the freezer is frozen quickly, and that the food already in the freezer is heated as little as possible.If more than 3-4 kg of food is to be frozen: Turn the thermostat button to the coldest setting
“”. The freezer will now run continuously, creating a sufficient reserve of the temperature required. Turn
the thermostat button 6-24 hours before placing new food in the freezer, depending on how much food is to be
frozen. Place the food in the freezer and leave the thermostat set at
“”for about 24 hours more. Then turn the
thermostat button back again. The freezer will return to normal storage temperature. If you forget to turn the thermostat button back, the freezer will not be damaged by running at this setting for some time - but energy will be
wasted.
BASKET
The baskets are designed for the storage of food which has already been frozen.
STORAGE
Frozen food can be stored anywhere inside the freezer, but should be kept at least 5 mm below the top edge. Never exceed the maximum storage time for purchased frozen food. When you buy frozen food, make sure that it has been stored at the correct temperature. Do not buy products which have wet or damaged packaging. Place purchased products in your freezer as quickly as possible. We recommend using an insulated bag to bring such products home with you. Never place bottles, warm objects, or fizzy drinks in the freezer.
FREEZING
Only use fresh food of the best quality. Cool hot dishes to room temperature as quickly as possible before placing them in the freezer. Wrap food
carefully in freezer foil, or use the special freezer boxes or bags which are on the market. Divide food into small por tions before freezing - this
ensures that freezing is more rapid, and means that you only need to defrost the amount needed for immediate consumption. Remember that
defrosted food must not be re-frozen. However, dishes which have been made using defrosted food may be frozen. Mark the freezer packaging
with the date of freezing. We recommend keeping a record of the contents of your freezer. If freezing is too slow, the quality of the food being frozen
deteriorates. Consequently, do not freeze larger amounts than stated in the freezer’s data plate. If you wish to freeze food several days in a row, the
maximum freezing capacity stated per day is reduced by about one-third. As far as possible, keep the lid closed during freezing. If you know nothing about home freezing, we recommend that you purchase a book containing advice and guidelines.
DEFROSTING
In general food should not be defrosted at room temperature, since this increases the risk of bacteria growth. It is best to defrost large portions
of meat or poultry in the refrigerator, and this also applies to food which is to be consumed as it is (e.g. fruit, butter and sliced meat). Small portions of food can be cooked straight from the freezer. A good number of ready-to-cook dishes can also be cooked without defrosting. Always
observe the instructions on product packaging. Bread tastes good when defrosted in a moderate oven. Microwave ovens can be used for the
rapid defrosting of most frozen foods. Observe the instructions for use of the microwave oven concerned.
The formation of frost on the inside of freezers cannot be avoided. Frost is formed when moisture contained in the air comes into contact with
the cold surfaces of the freezer. Consequently, the lid should only be opened when necessary, and it should never be left open. A thin layer of
ice or frost does not affect the function of the freezer adversely, and can be removed carefully using the scraper provided.
IMPORTANT! Never use a knife or any other sharp implement to remove frost.
When the frost or ice layer is 10-15 mm thick, the freezer should be defrosted. We suggest that you defrost your freezer when there is little or no
food inside. Switch off the current. Remove the contents of the freezer, wrap them in newspapers, and leave them in a cold place. The speed of
defrosting can be increased by placing one or more bowls of hot (not boiling) water inside the freezer and closing the lid. Open the lid after a
while, and remove the layer of ice carefully. Do not try to speed up defrosting by using anything other than hot water, since this may damage the
freezer. After defrosting, clean the inside of the freezer.
HOW TO CLEAN YOUR FREEZER INSIDE
Remove the plug from the mains socket, and remove all loose accessories before cleaning the freezer. The best time to clean your freezer is after
defrosting and before the electricity supply is connected again. Use a damp cloth to clean your freezer. Use hot water, and a mild, non-aromatic
cleaning agent. After cleaning the freezer, clean the basket/baskets before replacing them.
IMPORTANT! Never use strong cleaning agents, scouring powder or strongly aromatic cleaning agents to clean your freezer inside,
since this will damage the inside and leave a strong smell.
FREEZING
CAPACITY
3
Loading...