ASSEMBLY INSTRUCTIONS
E26 Type A - 60W X 2 (Not included)
E26 CFL - 13W X 2 (Not included)
1. Place all parts on a flat smooth surface and start the
Lamp assembly
2. Attach the Tube C to the Lamp Frame D (thread the
wires through)
3. Thread the Canopy B to the Tube C (thread the wires
through)
4. Install BULB(s) (Not included)
CAUTION - Refer to the wattage caution
label located near the lamp holder for
maximum wattage - do not exceed the
maximum wattage
5. Lamp installation
CAUTION - Before starting the installation,
disconnect the power by turning off the circuit
breaker or by removing the fuse at the fuse box.
Turning the power off using the light switch is not
sufficient to prevent electrical shock
6. Install the Crossbar A to the ceiling outlet box using the
provided screws
7. Wiring: using the provided Wire Connectors connect the
Lamp BLACK wire to your installation POSSITIVE wire,
then connect the Lamp WHITE wire to the NEUTRAL.
Lastly connect your house Ground wire and the Lamp
BARE GROUND wire to the GROUND SCREW located
in the Crossbar A
8. Gently push the wiring inside the electrical box, then lift
the lamp from the Canopy B and using the two Canopy
screws attach it to the Crossbar A
9. Finally install the shade to the Lamp frame using the Finial
E
CARE INSTRUCTIONS - Use only a soft cloth; do not use any chemicals or
abrasive cleaners.
Loading...