Components and Hardware List
Made in Viet Nam
Page 1 of 2
Assembly Instructions
Be sure to check all packing material carefully for small parts,
which may have come loose inside the carton during
shipment.
A
Anti-Tip Restraint Kit
(attached to back of unit)
1 pc.
For product and personal safety,
Anti-Tip Restraint kits have been
included with this cabinet which can
help to minimize the risk of the
cabinet accidentally tipping forward,
if used and properly installed.
To remove the drawer if it ever becomes
necessary:
A. Pull the drawer fully open so the black
latch is visible in the inside channel of the
guides.
B. Release the latches by simultaneously
pushing one lever up and the other down.
C. At the same time, pulling the drawer
forward until the slides release.
To reinstall the drawers, carefully align the
channels of both guides and push drawer
back in until fully closed. Open and close
drawer fully a couple times to verify
proper operation.
There are Levelers located underneath all four
corners, which can be adjusted to compensate for
uneven flooring if needed. To adjust, after
determining which leveler needs adjusting,
carefully have one person tilt the dresser while
another person reaches underneath, adjusting the
leveler as needed.
Bed Room
5-DRAWER CHEST
1. Temporarily locate the furniture to near it's final location in the room next to a wall. Locate a
wall stud behind your furniture and also mark the stud's location on the back of your furniture.
2. Firmly attach one bracket to the stud approximately 2" below the top of the furniture with the
2 inch long Wood Screws provided. It may be necessary to drill 3/32 dia. pilot holes for the
screws.
3. Firmly attach the other bracket onto a solid, structural part on the back of the furniture using
the 5/8 inch long Wood Screws. It may also be necessary to pilot bore for these screws.
4. Move the furniture into its final position, taking care to line up the wall bracket with the
furniture bracket. Thread a strap through the bracket as shown in the illustration. Tighten strap
until snug but do not over tighten.
Warning: This tip-over restraint is not to be a substitute for proper adult supervision. Do not
allow children to climb on furniture. Items left on top of the TV and furniture, such as toys,
remote controls and treats might tempt young children to climb. Push the TV as far back as
possible from the front of its stand. Place electrical cords out of a child's reach, and teach
children not to play with the cords.
Approximately
2"
Anti-Tip Hardware
Installation Instructions
Install screws
through the small
hole in brackets
Page 2 of 2
Notice: We recommend that steps be taken for certain furniture items to prevent or minimize the
risk of tip-over. This furniture is equipped with Tip-over Restraint Hardware for use to
minimize this risk, if used. Please follow below installation steps. We recommend that parents
and guardians periodically visit the U.S. Consumer Product Safety Commission (CPSC) website
at http://www.cpsc.gov/ and stay up to date on all issues related to children's product safety.
Caution: We assume no liability for improper installation or excessiveloads placed on
screws, brackets or straps. Failure to detach this restraint before movingfurniture may
result in personal injury and property damage.
Loading...