12 pcs.
5/16" Spring Washer
I
5/16" Flat Washer
J
Ø5/16-18 x 2" Long
Allen Head Bolt
Components and Hardware List
A
H
B
5mm Allen Wrench
2 pcs.
Bench Top
Made in China
Assembly Instructions
4 pcs.
Top Stretcher
STEP 1
L
1 pc.
Ø5/16-18 x 3" Long
Allen Head Bolt
Bottom Stretcher
10 pcs.
Column
STEP 2
∅5/16-18 x 3-1/4" Long
Allen Head Bolt
2 pcs.
Be sure to check all packing material carefully for small parts, which may have come loose inside the
carton during shipment. Separate, count and check all parts against the Components and Hardware List
above. Failure to use the correct length bolts in the proper locations may result in an unsafe product and
could also cause damage to the parts being assembled.
Step 1: Attach the Bottom Stretcher (C) between the two Columns (B) using the 3-1/4" long Allen Head
Bolts(H), Spring Washers (I) and Flat Washers(K). Do not fully tighten until after Step 3.
Step 2: Attach the Top Stretcher (D) between the two Columns using the 1-1/2" long Allen Head Bolts (E)
Spring Washers (I) and Flat Washers (J). Pull all parts together snug and tighten Bolts with the
Allen Wrench (L).
Step 3: Carefully place the Bench Top (A) upside down on a soft surface such as a blanket or carpet. Position the
assembled Stretchers and Columns on the Bench Top and attach the Columns end holes using the
2" Allen Head Bolts (F) and the middle holes using the 3" Allen Head Bolts (G), the Top Stretcher
using the 1-1/2" Bolts (E) and all the same Washers as before. Tighten Bolts with the Allen Wrench
(L).
Step 4: Set the assembled Bench upright.
WARNING
This BENCH is designed and intended for seating only. To
prevent against potential injuries and structural failures, this bench
should NEVER be used for other than its intended purpose.
5/16"x 30mm Flat Washer
Ø5/16-18 x 1-1/2" Long
Allen Head Bolt
4 pcs.
C
D
E
F
G
K
1 pc.
1 pc.
2 pcs. 1 pc.
2 pcs.
K
I
H
L
J
I
E
L
J
I
G
L
I
J
F
L
I
J
F
L
J
I
E
L
J
I
G
L
A
D
C
B
B
Dining Room
Page 1 of 1
DINING BENCH
Loading...