Assembly Instructions
DRESSER AND MIRROR ARE SOLD AND PACKED SEPARATELY
ASSEMBLY RATING
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
EASY
DIFFICULT
Page 1 of 5
Tools Required for Assembly:
Allen Wrench
(Included)
2 PERSONS RECOMMENDED
Page 2 of 5
MD
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
Parts List
#1 x 1 pc
Dresser
#2 x 1 pc
Mirror
#3 x 2 pcs
Support Rail
#4 x 4 pcs
Foot
Hardware List
#A x 8 pcs
Bolt 1/4”x1-3/8”
#B x 8 pcs
Lock W asher
#C x 8 pcs
Flat W asher
#D x 1 pc
Allen Wrench
#5 x 1 pc
Center Foot
Due to the size and/or weight of this product, it is
highly recommended that the assembly should be
done near the area of its intended location. Make
sure you have enough space to move around during
the assembly. ALWAYS have at least two people to
help with transporting and assembling the product to
avoid any potential injury and/or damage, especially
with the fragile nature of the mirror .
Page 3 of 5
I. With the help of another person, carefully place the dresser (#1)
on its back over a protected surface.
II. Align the threaded end of the 4 feet (#4) with the pre-drilled holes
on the bottom corners of the dresser (#1) and tighten by hand
until secured.
III. Align the threaded end of the center foot (#5) with the pre-drilled
hole on the center of the dresser (#1) and tighten by hand until
secured.
Turn right (clockwise) to tighten
#A x 4 pcs
#B x 4 pcs
#C x 4 pcs
I. Align the two support rails (#3) vertically with the pre-drilled holes
of the dresser (#1).
II. Prepare 4 bolt assemblies by inserting FIRST the lock washer (#B)
onto the bolt (#A) and then the flat washer (#C) onto the SAME bolt
(#A), in that order .
III. Insert the bolt assemblies through the support rails (#3) and secure
those bolts using an Allen wrench (#D) to lock with the dresser
(#1).
Page 4 of 5
Turn right (clockwise) to tighten
#A x 4 pcs
#B x 4 pcs
#C x 4 pcs
I. With the help of another person, carefully align the mirror (#2) with
the pre-drilled holes of the support rails (#3).
II. Prepare 4 bolt assemblies by inserting FIRST the lock washer
(#B) onto the bolt (#A) and then the flat washer (#C) onto the
SAME bolt (#A), in that order.
III. Insert the bolt assemblies through the support rails (#3) and
secure those bolts using an Allen wrench (#D) to lock with the
mirror (#2).
Back Side
Back Side
ASSEMBLY IS COMPLETED
Turn right (clockwise) to tighten
Page 5 of 5
Loading...