Issue department：Bedding Division
Date：
2019-3-29
Product Function
instruction
Author：
Allen
No：RF377D
RF377D
Version：
1.0
Page 1 of 5
RF377D Function instruction
1. Electrical configuration diagram：
1
Issue department：Bedding Division
Date：
2019-3-29
Product Function
instruction
Author：
Allen
No：RF377D
RF377D
Version：
1.0
Page 2 of 5
2. Process of test
2.1 Head Lift +
Press and hold HEAD Lift + button of remote, head actuator moves out, stop when released；
2.2 Head Lift -
Press and hold HEAD Lift - button of remote, head actuator moves in, stop when released；
2.3 Foot Lift +
Pressa and hold FOOT Lift + button of remote, foot actuator moves out, stop when released;
2.4 Foot Lift -
Press and hold FOOT Lift - button of remote, foot actuator moves in , stop when released；
2.5 Tilt up
Press and hold Tilt Lift + button of remote, Tilt actuator moves out, stop when released；
2.6 Tilt down
Press and hold Tilt Lift - button of remote, Tilt actuator moves in, stop when released；
2.7 Lumbar up
Press and hold Lumbar Lift + button of remote, Lumbar actuator moves out, stop when released；
2.8 Lumbar down
Press and hold Lumbar Lift - button of remote, Lumbar actuator moves in, stop when released；
2
Issue department：Bedding Division
Date：
2019-3-29
Product Function
instruction
Author：
Allen
No：RF377D
RF377D
Version：
1.0
Page 3 of 5
2.9 FLAT
Click FLAT button, the bed goes flat, stop when click any button during the process of going flat；
2.10 M1
Release after press, 2 lifts move to M1 position
2.11 M2
Release after press, 2 lifts move to M2 position
2.12 M3
Release after press, 2 lifts move to M3 position
2.13 Zero-G
Release after press, 2 lifts move to Zero-G position
2.14
Turn on massage head
2.15
2.16
Press the Massage time key will turn on the massage and choose timing for 10min-20min-30min-off
Massage head
Massage foot
Turn on massage foot
Massage time
3
Issue department：Bedding Division
Date：
2019-3-29
Product Function
instruction
Author：
Allen
No：RF377D
RF377D
Version：
1.0
Page 4 of 5
2.17
FCC Warning：
Any Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
ISED RSS Warning:
This device complies with Innovation,Science and Economic Development Canada licenceexempt
RSS standard(s). Operation is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radio
exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
Pairing
PressHead Lift + and Foot Lift +key for more than 1 second, the remote will enter pairing
mode and a B_ LED will flash. Release this key to stop pairing .After the pairing is successful,
B_LED will stop flashing.
ISED RF exposure statement:
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment.The device has
been evaluated to meet general RF exposure requirement.
Le matériel est conforme aux limites de dose d'exposition aux rayonnements énoncés pour fac un autre
environnement.ce dispositif a été évalué à satisfaire l'exigence générale de l'exposition aux rf.
4
Issue department：Bedding Division
Date：
2019-3-29
Product Function
instruction
Author：
Allen
No：RF377D
RF377D
Version：
1.0
Page 5 of 5
Massage motor
FCC ID: 2AK23RF377D
IC: 22406-RF377D
Power cord AC
FCC ID: 2AK23MC122
IC:22406-MC122
Power Supply
control box
Foot Motor
Head Motor
5
Loading...