Keeson Technology RF359A Users Manual

OKIN Refined Electric Technology Co., Ltd

Operating Manual of Remote Control system

1 Interface of the remote control

2Button description

A. HEAD UP button：Press and hold the button, the Head actuator will go up. Stop

when released.

B. HEAD DN button：Press and hold the button, the Head actuator will go down.

Stop when released.

C. FOOT UP button：Press and hold the button, the Foot actuator will go up. Stop

when released.

Page 1 of 7

OKIN Refined Electric Technology Co.,Ltd

D. FOOT DN button：Press and hold the button, the Foot actuator will go down.

Stop when released.

E. ZERO GRAVITY button: Click the button, the Head and Foot actuator will start

up and keep running until arriving to the zero gravity position. Running can be stopped by
clicking any button.

F. FLAT button: Click the button, the Head and Foot actuator will start up and

keep running until arriving to the FLAT position. Running can be stopped by clicking any
button.

G. MEMORY 1 button: Click the button, the Head and Foot actuator will start up

and keep running until arriving to the Memory 1 position preset by user. Running can be
stopped by clicking any button.

H. MEMORY 2 button: Click the button, the Head and Foot actuator will start up

and keep running until arriving to the Memory 2 position preset by user. Running can be
stopped by clicking any button.

The blue LEDs for backlight are on as long as any button is pressed. IF all buttons are
released the LEDs will automatically turn off three seconds later.

The blue LED for power is always on as long as the power on.

The below positions can be changed or set by the end user.
The Zero gravity position;
The Memory 1 position;
The Memory 2 position;

The procedure to set these special positions is below:

Page 2 of 7

OKIN Refined Electric Technology Co.,Ltd

Step 1: Click the button to flat the bed;

Step 2: Adjust the Head and Foot position to a desired position by pressing the

button HEAD_ UP or HEAD_DOWN or FOOT_UP or FOOT_DOWN;

Step 3: Press and hold the button for 3sec, backlight LED start flashing;

Step 4: Release the button then click one of or or

button before LED stop flashing. Then the Flashing stops immediately to

indicate the corresponding operating has completed successfully.

ALL of the Zero gravity position and the Memory 1 position and the Memory 2

position can be restored to default sets by pressing and holding the

button for approximate six seconds until the backlight LEDs finally stop flashing
from first flashing.

I. Massage Mode button：
Click the button the vibrating mode will change by one level, total

4 levels.

When it has been level 4, it will return to level 1 if click the button.

J. Head Massage INTENSITY ICREASEMENT and DECREASEMENT button：

Click the button the Head vibrating intensity will raise up one level, total

4 levels.

Page 3 of 7