KC HiLiTES KC 6314 Instructions

6314 QUAD BEAM

Installation Instructions

Please Note

! Not for use on cars equipped with high beam daytime running lights. Low

beam daytime running lights are okay.

! This kit may not work on vehicles that utilize a negatively switched headlight

system. Works on most GM vehicles up to 1999 & 2003-2006.

INGREDIENTS TOOLS NEEDED

2 - Scotchloks 1 - 6” Black wire Philips screwdriver
2 - Sheet metal screws 1 - 28” Yellow wire w/fuse Pliers
1 - Relay 1 - 36” Green wire 1/4” Drill motor
1 - Relay plug 1 - 60” Convoluted tube 1/8” Drill bit
1 - 32” White wire 4 - Tyraps

1. With one of the screws provided, mount the relay within 24 inches of both the battery and the rear of
your headlights.

2. Using one of the screws supplied, attach the black wire to a grounded metal surface.

3. Unplug the high beam wires from the rear of the headlight bulb.
A. Turn on your headlight high beam and with the use of a test light, determine
which wire is hot.
B. Turn off your headlights.
C. Using a Scotchlok, attach the white relay wire to the high beam wire.

4 Unplug the low beam wires from the rear of the headlight bulb.

A. Turn on your headlight low beam and with the use of a test light,
determine which wire is hot.
B. Turn off your headlights.
C. Using a Scotchlok, attach the green relay wire to the low beam hot wire.

5. Remove the fuse from the fuse holder on the yellow wire and attach the wire to the battery or suitable

power source. Replace the fuse.

6. Cut the enclosed protective tubing as required, slide the split side over the wire and secure with tyraps

as necessary.

Low Beam

RELAY WIRING

86

(Green)

87

85

30

(Black)

DIAGRAM

Relay

High Beam

Battery +

KC HiLiTES, Inc. 2843 W. Avenida de Luces, Williams, AZ 86046 * 928-635-2607 * * 3266 - rev www.kchilites.com

Fuse

(White)

(yellow)

Ground