KC HiLiTES KC 42302 Instructions

#42302
2007-2013 JEEP WRANGLER (JK)
H4 “DOT” HEADLIGHT CONVERSION KIT
23 Year Warranty
See details on our website at
www.kchilites.com
#42302 HEADLIGHT CONVERSION KIT INCLUDES:
2 - #4230 H4 HEADLIGHTS 2 - H4 PHILIPS 55/60W BULBS 1 - #6307 H13-H4 CONVERSION HARNESS KIT
TOOLS REQ’D FOR INSTALLATION:
• 10mm Socket/Wrench
• Flathead Screwdriver
Philips Screwdriver**
**Note: For earlier JK Models with Screw-type Retainer Tabs, it requires a Philips Screwdriver.
INSTALLATION:
Pop open your Hood. Using a 10mm wrench, <Disconnect>
1. the (-) NegaƟve Terminal from the baƩery.
<Locate> the Turn Signal Wire Harness behind the grill
2. through the wheel well and <Unlock> the connector by pulling out the red locking tab.
<Remove> the Jeep Wrangler Grille by firmly pulling on
5.
the lower part of the grille unƟl the retainer clips break free of the chassis.
Tip: There are (6) Press-In Retainer Clips holding the Jeep Grille in place: (1) Located Above each turn signal (Le & Right) and (5) located along the boom of the lower radiator support.
Using the T15 Torx Driver: <Remove> the (4) retaining ring
6. screws holding the headlight assembly in place.
<Pull> headlight assembly out to expose the wire harness
7. with connector. <Unplug> the headlight by unlocking the connector by sliding out the red locking tab, press and hold the release tab and disconnect the connector.
<Separate> the Retainer Ring from the OEM Headlight and
8. discard the OEM Headlight.
Take the H13-H4 Harnesses Adapter (#6307) and <Connect>
9. the Male H13 plug to the OEM Connector.
Take the KC H4 Headlight and <Connect> it to the H4
10. connector from the Harness Adapter (#6307).
<Unplug> the connector by pressing and holding the
3. release tab down while you pull it out.
Using the Flathead Screwdriver, <Remove> the (6) PlasƟc
4. Retainer Tabs located along the top of the grill shroud by liŌing the plasƟc pins and gently prying the tabs out. (For older model JKs, it will require using a Philips Screwdriver to unscrew the plasƟc liŌ pins.)
KC HiLiTES, Inc. Post Office Box 155, Williams, Arizona 86046-0155 * 800-528-0950 * www.kchilites.com
The KC H4 Headlight is indexed to align with the Jeep
11. Wrangler Headlight Housing. Make sure the indexed tabs are properly aligned before screwing the retainer ring back into place using the original T15 Retainer Ring Screws.
<Re-install> the Jeep Wrangler Grille by following Steps
12. (1-7) in reverse order.
Enjoy your New H4 Headlights!
Loading...